ECU SUBARU WRX 2018 Manual PDF

(546,1)
北米Model "A1700BE-B" EDITED: 2017/ 10/ 11
&Front turn signal light (mod-
els with LED headlights)Left-hand side1.Left-hand side:Use a screwdriver to
remove the secured clip of the washer
tank. To make it easy to access the bulb,turn the neck of the washer fluid filler pipe
as illustrated.
Right-hand sideRight-hand side:Use a screwdriver to
undo the clips on the air intake duct, then
remove the air intake duct.
2. Remove the bulb from the headlight
assembly by turning it counterclockwise.
3. Replace the bulb with a new one. At
this time, use care not to touch the bulb
surface.
4. To install the bulb to the headlight
assembly, turn it clockwise until it clicks.
5.Left-hand side:Set the washer fluid
filler pipe to the original place and secure it
with a clip.
Right-hand side:Install the air intake duct
with clips.&Front fog light (models with
the LED front fog light)Have the front fog light assembly checked
by your SUBARU dealer.
Maintenance and service/Replacing bulbs
11-48

(548,1)
北米Model "A1700BE-B" EDITED: 2017/ 10/ 11
1. Remove the clips from the trunk trim
with a flat-head screwdriver.2. Open the rear portion of the trunk trim
panel as illustrated.NOTEMake sure that the“
*”part of the trunk
trim in the illustration does not contact
the trunk lid stay. If the“
*”part is bent,
the trunk trim may be torn.
1) Rear side marker light
2) Backup light
3) Rear turn signal light3. Remove the bulb socket from the rear
combination light assembly by turning it
counterclockwise.
4. Pull the bulb out of the bulb socket and
replace it with a new one.
5. Set the bulb socket into the rear
combination light assembly and turn it
clockwise until it locks.
6. Secure the rear trunk trim panel with
the clips.NOTEWhen replacing a bulb of the rear side
marker light, detach the bulb socket of
the backup light in advance. Afterreplacing the bulb, first attach the side
marker light, and then attach the back-
up light.
&License plate light1. Open the trunk and remove the clips
from the trunk lid trim with a flat-head
screwdriver.
2. Turn over the trunk lid trim.
Maintenance and service/Replacing bulbs
11-50

(580,1)
北米Model "A1700BE-B" EDITED: 2017/ 10/ 11
.
Tread rib
A tread section running circumfer-
entially around a tire..
Tread separation
Pulling away of the tread from the
tire carcass..
Treadwear indicators (TWI)
The projections within the principal
grooves designed to give a visual
indication of the degrees of wear of
the tread..
Vehicle capacity weight
The rated cargo and luggage load
plus 150 lbs (68 kg) times the
vehicle’s designated seating capa-
city..
Vehicle maximum load on the tire
Load on an individual tire that is
determined by distributing to each
axle its share of the maximum
loaded vehicle weight and dividing
by two..
Vehicle normal load on the tire
Load on an individual tire that is
determined by distributing to each
axle its share of the curb weight,
accessory weight, and normal oc-cupant weight (distributed in accor-
dance with Table 1 that is appended
to the end of this section) and
dividing by 2.
.
Wheel-holding fixture
The fixture used to hold the wheel
and tire assembly securely during
testing.
Consumer information and Reporting safety defects/Tire information
13-8