clock reset SUZUKI ALTO 2013 7.G Owners Manual
[x] Cancel search | Manufacturer: SUZUKI, Model Year: 2013, Model line: ALTO, Model: SUZUKI ALTO 2013 7.GPages: 190, PDF Size: 8.76 MB
Page 57 of 190
2-38
BEFORE DRIVING
53MH0-74E
When the ignition switch is turned to “ON”
and the position lights, tail lights and/or the
headlights are on, the display shows four
types of indication; odometer (A), trip
meter A (B), trip meter B (C), clock (D) and
indication of illumination intensity (E). Push
the “MODE” knob (3) quickly to switch the
indication among the five. When the indica-
tion shows (E), you can control the meter
illumination intensity. Refer to “Meter illumi-
nation control” section below for details on
how to dim or brighten the meter illumina-
tion.
53M-04-102
To reset the trip meter to zero, hold in the
“MODE” knob (3) for about 2 seconds.Meter illumination control
53M-04-103
When the display shows the indication of
illumination intensity (E), you can dim or
brighten the meter illumination.
To change the meter illumination bright-
ness, continue to hold in the “MODE” knob
(3). The indication will change as shown in
the illustration. The illumination gets dim-
mer then returns to the brightest condition
after it reaches the dimmest.
NOTE:
When you reconnect the negative (–) ter-
minal to the battery, the brightness of the
instrument panel lights will be reinitialized.
Readjust the brightness according to your
preference.
Lighting Control Lever
53M-04-104EXAMPLE
EXAMPLE
EXAMPLE
WA R N I N G
To avoid possible injury, do not oper-
ate controls by reaching through the
steering wheel.
EXAMPLE
Page 109 of 190
5-16
OTHER CONTROLS AND EQUIPMENT
53MH0-74E
Turning power on/off
Press the VOL PUSH POWER knob (1).
The unit starts in the function mode it was
in when the power was turned off last.
Adjusting the volume
Turning it clockwise increases the volume;
turning it counterclockwise decreases the
volume.
Mute
Press the MUTE button (3) to mute the
sound. To cancel the mute, press the
MUTE button (3) again.
Adjusting bass/treble/balance /
fader
1) Press the SOUND button (2).
Each time the knob is pressed, sound
adjustment will change as follows:
2) Turn the VOL PUSH POWER knob (1)
to adjust the sound.
Beep tone
Each time SOUND button (2) is pressed
(more than 1 second) beep tone mode
switches as follows.
Preset-EQ
Preset-EQ calls up various sound types in
accordance with the listening music type.
1) Press the SOUND button (2) several
times until “FLAT” appears.
2) Turn the VOL PUSH POWER knob (2).
Each time the knob is turned, preset
EQ mode will change as follows:
NOTE:
Once the set is switched off and switched
on, the setting on EQ will be remained the
previous setting.
53M-07-058
You can also turn the power on by pressing the
desired source button
RADIO mode :
Last accessed media mode :Press the BAND
button (4)
Press the MODE
button (5)
Preset-EQ (FLAT)
Bass adjustment (BAS 0)
Treble adjustment (TRE 0)
Balance adjustment (BAL 0)
Fader adjustment (FAD 0)