manual radio set SUZUKI ALTO 2013 7.G Owners Manual
[x] Cancel search | Manufacturer: SUZUKI, Model Year: 2013, Model line: ALTO, Model: SUZUKI ALTO 2013 7.GPages: 190, PDF Size: 8.76 MB
Page 106 of 190
5-13
OTHER CONTROLS AND EQUIPMENT
53MH0-74E
Audio System (if equipped)
ALTO 800
Refer supplementary manual for audio
system (if equipped), provided along with
the vehicle.
ALTO K10
53M-07-047
Notes on Discs
Precautions
When the inside of the vehicle is very
cold and the player is used soon after
switching on the heater, condensation
may form on the disc or the optical parts
of the player and proper playback may
not be possible. If condensation forms
on the disc, wipe it off with a soft cloth. If
condensation forms on the optical parts
of the player, do not use the player forabout one hour. This will allow the con-
densation to disappear normally.
Driving on extremely bumpy roads which
cause severe vibrations may cause
sound to skip.
This unit uses a precision mechanism.
Even in the event that trouble arises,
never open the case, disassemble the
unit, or lubricate the rotating parts.
Please bring the unit to an authorized
MARUTI SUZUKI dealer.
Cautions on Handling
53M-07-048
This unit has been designed specifically for
playback of compact discs bearing mark
(A) shown above.
53M-07-049
To remove the compact disc from its stor-
age case, press down on the center of the
EXAMPLE
If you pay extended attention to oper-
ating the audio system or viewing the
audio system display while driving,
an accident can occur. If you set the
sound volume too loud, it could pre-
vent you from being aware of road
and traffic conditions.
• Keep your eyes on the road and
your mind on the drive. Avoid pay-
ing extended attention to operating
the audio system or viewing the
audio system display.
• Familiarize yourself with the audio
system controls and operation of
the audio system before driving.
• Preset your favorite radio stations
before driving so that you can
quickly tune to them using the pre-
sets.
• Set the sound volume to a level
that will allow you to continue to be
aware of road and traffic conditions
while driving.
Page 111 of 190
5-18
OTHER CONTROLS AND EQUIPMENT
53MH0-74E
Selecting the reception BAND
Press the BAND button (1). Each time the
button is pressed, the reception band will
change as follows:
53M-07-061
Seek tuning
Hold down the seek Up button (2) or the
seek Down button (3) for 1 second or lon-
ger.
The unit stops searching for a station at a
frequency where a broadcast station is
available.
Manual tuning
Press seek Up button (2) or the seek Down
button (3).
The frequency being received is displayed.
Which receiving FM stereo broadcasting.
ST lights up.
Preset memory
1) Select the desired station.
2) Hold down a desired button ([1] to [6])
of the Preset buttons (4) to which you
want to store the station for 2 seconds
or longer.
Auto store
Hold down the AST button (5) for 1 second
or longer. Six stations in good reception
will automatically be stored to the Preset
buttons (4) in order, starting from a station
whose frequency is the lowest.
NOTE:
• Auto store can be released by pressing
AS button (5) while auto store is under
way.
• When the auto store is performed, the
station previously stored in the memory
at the position is over written.
• When there are fewer than 6 stations
that can be stored even if 2 rounds of
auto store operation is performed, no
station will be stored at the remaining
Preset buttons (4).
• 6 stations can be preset for FM1, FM2
and FM3 in common, and 6 stations for
AM in auto store mode.
Radio Reception
Radio reception can be affected by envi-
ronment, atmospheric conditions, or radio
signal’s power and distance from the sta-
tion. Nearby mountains and buildings may
interfere or deflect radio reception, causing
poor reception. Poor reception or radio
static can also be caused by electric cur-
rent from overhead wires or high voltage
power lines.
Page 128 of 190
5-35
OTHER CONTROLS AND EQUIPMENT
53MH0-74E
Troubleshooting
FM/AM
SYMPTOM CAUSEREMEDY
The station cannot be received.The connection of the car antenna has
not been made correctly.Check the connection of the car antenna.
Automatic tuning is not possible.The broadcast signal is too weak. Perform manual setting.
The radio sensitivity is poor.Car antenna is not extended fully or
inclining.Check the car antenna.
No sound is coming out from front
speaker or rear speaker.Adjustment of the front and rear speakers
tilts towards either of the side.According to “Adjusting the audio”, adjust
the FAD level.
For the 2 speakers, adjust the FAD level
to “0”.