steering wheel adjustment SUZUKI BALENO 1999 1.G Owners Manual

60G-74E
INSPECTION AND MAINTENANCE

70F-07-029
Do not use any fluid other than SAE

J1703 or DOT-3 brake fluid. Do not

use reclaimed fluid or fluid that has

been stored in old or open

containers. It is essential that foreign

particles and other liquids are kept

out of the brake fluid reservoir.

CAUTION

The brake fluid should be replaced

every two years or 20,000 km.

panel will come on (the engine must

be running with the parking brake

fully disengaged). Should the light

come on, immediately ask your

MARUTI dealer to inspect the brake

system.

A rapid fluid loss Indicates a leak in

the brake system which should be

inspected by your MARUTI dealer

immediately.

Brake fluid can harm your eyes and

damage painted surfaces. Use

caution when refilling the reservoir.
NOTE:

With disc brakes, the fluid level can be

expected to gradually fall as the brake pads

wear.

99
70F-07-030

Brake Pedal

Check if the brake pedal stops at the regular

height without "spongy" feeling when you

depress it. If not, have the brake system

inspected by your MARUTI dealer. If you doubt

the brake pedal for the regular height, check

it as follows:

With the engine running, measure the distance

between the brake pedal and floor wall when

the pedal is depressed with approximately 30

kg (66 lbs) of force. The minimum distance

required is 80 mm (3.1 in). Since your vehicle's

brake system is self-adjusting, there is no need

for pedal adjustment. If the pedal to floor wall

distance as measured above is less than the

minimum distance required, have your vehicle

inspected by your MARUTI dealer.

9-16

INSPECTION AND MAINTENANCE

60G-74E

STEERING

60G-09-015E

NOTE:

When measuring the distance between the

brake pedal and floor wall, be sure not to

include any floor covering in the measurement.

If you experience any of the following

problems with your vehicle's brake

system, have the vehicle inspected

immediately by your MARUTI dealer.

Poor braking performance

Uneven braking (Brakes not working

uniformly on all wheels.)

Excessive pedal travel

Brake dragging

Excessive noise

Pedal pulsation (Pedal pulsates

when depressed.)
63B-09-00SE

Parking brake

Check the parking brake for proper adjustment

by counting the number of clicks made by the

ratchet teeth as you slowly pull up on the

parking brake lever to the point of full

engagement. The parking brake lever should

stop between the 3rd and 5th ratchet tooth

and the rear wheels should be securely locked.

If the parking brake is not properly adjusted

or the brakes drag after the lever has been

fully released, have the parking brake

inspected and/or adjusted by your MARUTI

dealer.
60G-09-016

Check the play of the steering wheel by gently

turning it from left to right and measuring the

distance that it moves before you feel slight

resistance. The play should be between 0 -

30
mm
(0.0 -1.2 in).

Check that the steering wheel turns easily and

smoothly without rattling by turning it all the

way to the right and to the left while driving

very slowly in an open area. If the amount of

free play is outside the specification or you

find anything else to be wrong, an inspection

must be performed by your MARUTI dealer.

9-17

100