Rear door SUZUKI CELERIO 2017 User Guide

5-6
OTHER CONTROLS AND EQUIPMENT
76MH1-74E
Glove Box
76MH0A073
To open the glove box, pull the latch lever. To close it, push the lid until it latchessecurely.
WA R N I N G
Never drive with the glove box lidopen. It could cause injury if an acci- dent occurs.
EXAMPLE
Cup Holder and Storage Area
76MH0A074
(1) Instrument panel pocket (driver’s side)(2) Instrument panel pocket (center)
(3) Front cup holders (4) Front door pocket
(5) Rear cup holder (6) Rear door pocket
(4)(1)
(4) (5)(3)(2)
(6)
(6)
EXAMPLE
91

5-7
OTHER CONTROLS AND EQUIPMENT
76MH1-74E
76MH1-74E
Instrument Panel Pocket
(driver’s side) (1) /
Instrument Panel Pocket (center) (2)
Front Cup Holders (3)
Rear Cup Holder (5)
76MH0A075
Open the top to use the cup holder.
Rear Door Pocket (6)This pocket is provided for holding light and small items.
Bottle holder You should hold a bottle with a cap in the holder.
Floor Mats (if equipped)
68LM554
To prevent the driver’s side floor mat fromsliding forward and possibly interfering withthe operation of the pedals, Maruti genuine floor mats are recommended. Whenever you put the driver’s side floormat back in the vehicle after it has been removed, be sure to hook the floor mat grommet(s) to the fastener(s) and positionthe floor mat properly in the footwell.
When you replace the floor mats in your vehicle with a different type such as all- weather floor mats, we highly recommend using Maruti genuine floor mats for properfitting.
WA R N I N G
Do not place any objects which may fall out from the pocket when the vehi-cle is moving. Failure to take the precaution may result in an object interfering with thepedals and causing a loss of vehicle control or an accident.
WA R N I N G
Failure to take the precautions listedbelow could cause personal injury or vehicle damage.• Be careful when you are using the cup holders to hold a cup contain- ing hot liquid. Spilling out hot liquidcan cause burn injury. • Do not use the cup holders to hold sharp-edged, hard, or breakableobjects. Objects in the cup holdersmay be thrown about during a sud- den stop or impact, and could cause personal injury. • Be careful not to sp ill liquid or insert any foreign materi als into the mov- ing part of the gearshift lever, or anyelectrical components. Liquid or for- eign materials may damage these parts.
EXAMPLEEXAMPLE
92

7-23
INSPECTION AND MAINTENANCE
76MH1-74E
76MH1-74E
The fuse box is located under the driver’s side of the dashboard. Remove the fuse box cover by pushing inat both ends and pulling off the cover.
81A283
Bulb ReplacementMAIN FUSE/PRIMARY FUSE
(1) 10A Stop light
(2) 30A Blower motor
(3) 10A ST SIG
(4) 15A Accessory
(5) 10A Rear fog light
(6) 10A Tail light
(7) 10A Back-up light
(8) 10A ABS
(9) 10A Meter
(10) 15A Ignition coil
(11) 20A Wiper/Washer
(12) 10A IG2 SIG
(13) 10A IG1 SIG
(14) 10A Air bag
(15) 20A Power window timer
(16) 20A Door lock
(17) 15A Horn/Hazard
(18) 20A Rear defogger
(19) 15A Dome
(20) 30A Power window
(21) 7.5A ACC 2
(22) 15A Radio 2
(23) – Blank
(24) – Blank
WA R N I N G
Always be sure to replace a blown fuse with a fuse of the correct amper- age. Never use a substitute such as aluminum foil or wire to replace ablown fuse. If you replace a fuse and the new one blows in a short period of time, you may have a major electri-cal problem. Have your vehicle inspected immediately by your MAR- UTI SUZUKI dealer.
BLOWN OK
CAUTION
• Light bulbs can be hot enough toburn your finger right after being turned off. This is true especially for halogen headlight bulbs.Replace the bulbs after they become cool enough. • The headlight bulbs are filled withpressurized halogen gas. They can burst and injure you if they are hit or dropped. Handle them carefully.
NOTICE
The oils from your skin may cause ahalogen bulb to overheat and burst when the lights are on. Grasp a new bulb with a clean cloth.
NOTICE
Frequent replacement of a bulb indi-cates the need for an inspection of the electrical system. This should be carried out by your MARUTI SUZUKIdealer.
161