ad blue SUZUKI GRAND VITARA 2008 3.G Inspection And Maintenance Manual

Downloaded from www.Manualslib.com manuals search engine INSPECTION AND MAINTENANCE
'Interval: This interval should be judged by odom-I km (xl000) 15 30 L 45 I 60 75 90 eter reading or months, whichever comes first. I
miles (xl000) 9 18 ~ 27 j 36 45 54
I months
12 24 ~ 36 I 48 60 72 ENGINE 1-1. Engine accessory drive belt
[Class 1] 1.6
L engine: Tension check, • Adjustment, 'Replacement - -I --R [Class 1] Except
1.6 L engine: Inspect for damage -- -I --I
[Class 2] Including tensioner, idlers - - --R -*1-2. Camshaft timing belt [Class 2] Including tensioner ----R -'1-3. Valve lash (clearance) [Class 1] 1.6 L or 2.0 L engine -I -I -I -[Class 1] 2.4 L engine --I - -I 1-4. Engine oil and oil filter R R R
R R R
1-5. Engine coolant
[Class 1] SUZUKI LLC: Standard (Green) - -R --R SUZUKI LLC: Super (Slue) (#1) First time only:
Replace at 150000 km (90000 miles) or 90 months Second time and after: Replace every 75000 km (45000 miles) or 45 months [Class 2]
= 1 7 1 = 1 7 1 =1
R '1-6. Exhaust system (except catalyst) i IGNITION (except Diesel engine) 2-1. Spark plugs When unleaded fuel is used [Class 1] Iridium plug (or Platinum plug for 3.2 L engine) Replace every 105000 km (63000 miles) or 84 months. [Class 2] Iridium plug -I -I -I R I -I -When leaded fuel is used, refer to "Severe Driving Condition" schedule FUEL --3-1. Air cleaner filter element Paved-road I I I I R I I I I I R
Dusty condition
Refer to "Severe Driving condition" schedule.
*3-2. Fuel lines -I I I -I I I -I I
*3-3. Fuel filter
[Class 1] RePI~ce Try ~05oof km ~r 63rO m~les. 1
1 [Class 2] --'3-4. Fuel tank -I
#1: Be sure to perform the engine coolant level check under the daily inspection in "OPERATING YOUR VEHICLE" section. If you replace the engine coolant other than the SUZUKI LLC: Super (Blue), follow the schedule of SUZUKI LLC: Standard (Green).
• For Sweden: Item 2-1,4-1 and 4-2 should be per- Their next maintenance service should be done (1) V belt formed by odometer reading only. within the specified period. (2) V-rib belt • For Item 2-1. Nickel spark plugs, replace every 50000 km if the local law requires. • Some maintenance items are required to be ser­viced at times other than the regular maintenance
times shown at the top of above table. These items
can be serviced at an earlier service opportunity
according to customer's maintenance convenience.
7-3
1
'?;U (2~
65D395
• For Item 1-4: The engine oil level should be checked
regularly.
• For further details, see "Daily Inspection Checklist" in the "OPERATING YOUR VEHICLE" section.

Downloaded from www.Manualslib.com manuals search engine Selection of Coolant CAUTION
SUZUKI LLC: Super (Blue) coolant;
SUZUKI LLC: Super (Blue) coolant is already diluted to the proper percent­
age. Do not dilute with distilled water additionally. Doing so may result in the possibility of freezing coolant and/or overheating.
To maintain optimum performance and durability of your engine, use SUZUKI Genuine Coolant or equivalent.
NOTE: If you replace the engine coolant other
than the SUZUKIl:.LC: Super (Blue), follow
.the schedule of SUZUKI LLC: Standard
(Green). To see the detail of the mainte­nance schedule, refer to "Periodic Mainte­nance Schedule" in this section.
This type of coolant is best for your cooling system as it: • Helps maintain proper engine tempera­ture. • Gives proper protection against freezing
and boiling.
• Gives proper protection against corro-
sion and rust. Failure to use the proper coolant can dam­age your cooling system. Your authorized SUZUKI dealer can help you select the
proper coolant.
CAUTION
To avoid damaging your cooling sys­tem: • Always use a high quality ethylene
glycol base non-silicate type cool­ant diluted with distilled water at the correct mixture concentration. • Make sure that the proper mix is 50/ 50 coolant to distilled water and in no case higher than 70/30. Concen­trations greater than 70/30 coolant to distilled water will cause over­heating conditions. • Do not use straight coolant nor plain water (except SUZUKI LLC: Super (Blue».
• Do not add extra inhibitors or addi­tives. They may not be compatible with your cooling system. • Do not mix different types of base coolants. Doing so may result in accelerated seal wear and/or the possibility of severe overheating and extensive engine/automatic
transmission damage.
INSPECTION AND MAINTENANCE
Coolant Level
Check Check the coolant level at the reservoir
tank, not at the radiator. With the engine cool, the coolant level should be between
the "FULL (MAXI)" and "LOW (MINI)" marks.
Adding Coolant
(For Gasoline Engine Model) If the coolant level is below the "LOW" mark, more coolant should be added. Remove the reservoir tank cap and add coolant until the reservoir tank level reaches the "FULt..:' mark. Never fill the res­ervoir tank above the "FULt..:' mark.
(For
Diesel Engine Model)
A. WARNING
It is hazardous to remove the degas­sing tank cap for Diesel engine when the water temperature is high,
because scalding fluid and steam may be blown out under pressure. Wait· until the coolant temperature has lowered before removing the cap.
If the coolant level is below the "MINI" mark, more coolant should be added. When the engine is cool, remove the degassing tank cap by turning it antic lock­wise slowly to release any pressure. And add coolant until the degassing tank level reaches the "MAXI" mark. Never fill the
degassing tank above the "MAXI" mark.
7-14