engine oil capacity SUZUKI GRAND VITARA 2008 3.G Inspection And Maintenance Manual

Downloaded from www.Manualslib.com manuals search engine INSPECTION AND MAINTENANCE
Refill with Oil and Check for Leaks 1) Pour oil through the filler hole and install the filler cap. For the approximate capacity of the oil, refer to the "Capacities" item in the "SPECIFICATIONS" section. 2) Start the engine and look carefully for leaks at the oil filter and drain plug. Run
the engine at various speeds for at least 5 minutes. 3) Stop the engine and wait about 5 min­
utes. Check the oil level again and add oil if necessary. Check for leaks again.
CAUTION
• When replacing the oil filter, it is recommended that you use a genu­
ine SUZUKI replacement filter. If you use an aftermarket filter, make
sure it is of equivalent quality and follow the manufacturer's instruc­
tions.
• Oil leaks from around the oil filter or drain plug indicate incorrect installation or gasket damage. If you find any leaks or are not sure
that the filter has been properly tightened, have the vehicle inspected by your SUZUKI dealer.
7-13
Engine Coolant
(For Gasoline Engine Model)
EXAMPLE
64J151
(For Gasoline Engine Model)
EXAMPLE
(For Diesel Engine Model)
64J249
.A WARNING
It is hazardous to remove the degas­
sing tank cap for Diesel engine when
the water temperature is high,
because scalding fluid and steam may be blown out under pressure.
Wait until the coolant temperature
has lowered before removing the cap.