Downloaded from www.Manualslib.com manuals search engine NOTE: Do not check the fluid level if you have just driven the vehicle for a long time at high
speed, if you have driven in city traffic in hot weather, or if the vehicle has been pull
ing a trailer. Wait until the fluid cools down
(about
30 minutes), or the fluid level indica
tion will not be correct.
3} Park your vehicle on level ground. 4} Apply the parking brake and then start
the engine in "P" (Park). Let it idle for two minutes and keep it running during
the fluid level check. . 5} With your foot on the brake pedal, move the gearshift lever through each range,
pausing for about three seconds in each range. Then move it back to the "P" (Park) position.
A. WARNING
Be sure to depress the brake pedal
when moving the gearshift lever, or the vehicle can move suddenly.
EXAMPLE or
60A205
6} The handle of the AfT fluid dipstick is colored red for easy identification.
Remove the dipstick, clean it and push it back in until the cap seats. Then pull out the dipstick. 7} Check both sides of the dipstick, and read the lowest level. The fluid level should be between the two marks in the "HOT' range on the dipstick.
INSPECTION AND MAINTENANCE
(3)
I?
~ (1)
(2) Co
(1) FULL HOT (2) LOW HOT (3) The lowest point = Fluid level
64J188
8} Add just enough specified fluid through the dipstick hole to fill the transmission to the proper level.
CAUTION
After checking or adding oil, be sure to insert the dipstick securely.
Changing Oil Since special procedures, materials, and tools are required to change the automatic
transmission oil, it is recommended that you trust this job to your authorized . SUZUKI dealer.
7-22
