airbag SUZUKI JIMNY 2019 User Guide
[x] Cancel search | Manufacturer: SUZUKI, Model Year: 2019, Model line: JIMNY, Model: SUZUKI JIMNY 2019Pages: 421, PDF Size: 6.35 MB
Page 40 of 421

FOR SAFE DRIVING
58MS030
A WARNING
(Vehicle without the front passenger airbag deactivation system) Do not install a rear-facing child restraint in the front passenger's seat. If the passenger's front airbag inflates, a child in a rear-facing child restraint could be killed or severely injured. The back of a rear-facing child restraint would be too close to the inflating airbag.
1-19
A WARNING
(Vehicle with the front passenger airÂbag deactivation system) When using a child restraint system on the front passenger's seat, the front passenger's airbag system must be deactivated; otherwise deployment of the front passenger's airbag could result in the death or serious injury of the child.
A WARNING
If you install a child restraint system in the rear seat, slide the front seat far enough forward so that the child's feet do not touch the front seatback. This will help avoid injury to the child in the event of an accident.
65D609
A WARNING
Children could be endangered in a collision if their child restraint sysÂtems are not properly secured in the vehicle. When installing a child restraint system, follow the instrucÂtions below. Secure the child in the restraint system according to the manufacturer's instructions.
Page 41 of 421

Child restraint system for
countries applied for UN
Regulation No.16
.A. CAUTION
Adjust the height of the head restraint or remove it for fitting the child restraint, as necessary. HowÂever, if a booster cushion not equipped with the head restraint is fitted, the head restraint should not be removed. If the head restraint is removed for fitting the child restraint, you need to install it again after removing the child restraint. If the child restraint is fitted impropÂerly, a child sitting in it could be injured in a collision. (Refer to "Installation with lap-shoulder seat belts" section, 11lnstallation with ISOÂFIX type anchorages" section and "Installation of child restraint with top tether11 section in this section for details.)
Child restraint
The suitability of each passenger's seat position for carriage of children and fitting of child restraint system is shown in the table.
Child restraint systems suitability for each seat position (for the vehicle with airbag deactivation switch)
The above illustration shows Left hand drive vehicle.
NOTE: Seat position number of G), @ and @ is same as Left hand drive vehicle for Right hand drive vehicle.
G) Front passenger's seat @ Rear seat right side @ Rear seat left side
G) (ID@ (#1. #2. #3)
(2) (ID~J,~ (#2, #3)
® (ID~J,~ (#2. #3)
FOR SAFE DRIVING
It is suitable for univerÂsal category of child restraint system fixed with the vehicle seat belt.
It is suitable for i-Size and ISOFIX child restraint system.
This seat is equipped with Top tether anchorÂage point.
Never use a rear-facÂing child restraint sysÂtem on the passenger seat when the front passenger airbag is activated.
#1: Move the front seat fully rearward. #2: When you install a forward-facing child restraint, if there is a gap or space between the child restraint and the seatback, adjust the seatÂback angle in order to install the child restraint system properly. #3: If the head restraint interferes with the child restratint system, adjust the height of the head restraint or remove it, as necessary.
NOTE: For the Installation suitability of child restraint systems of Taiwan models, refer to "For Taiwan" in the "SUPPLEÂMENT" section.
1-20
Page 42 of 421

FOR SAFE DRIVING
Detailed information for child restraint system (for the vehicle with airbag deactivation switch)
Seating position
Seat position number
Seating position suitable for universal belted (YES/NO)
i-Size seating position (YES/NO)
Seating position suitable for lateral fixture (L 1/L2)
Suitable rear-facing fixture (R1/R2/R3)
Suitable front-facing fixture (F2X/F2/F3)
Key of letters to be inserted in the above table YES =Suitable for this seating position NO = Not suitable for this seating position
Front Passenger airbag is activated
NO
NO
NO
NO
NO
X =ISOFIX position is not suitable for ISOFIX child restraint systems in this fixture.
G)
ISOFIX child restraint systems are divided into different mass group, size class and fixture.
Front Passenger airbag is deactivated
YES
NO
NO
NO
NO
The child restraint system can be used in the seating positions for fixture shown in the above table. For mass group, size class and fixture, confirm the table of next page.
NOTE:
(2)
YES
YES
X
R1, R2
F2X, F2, F3
@
YES
YES·
X
R1, R2
F2X, F2, F3
For the Installation suitability of child restraint systems of Taiwan models, refer to "For Taiwan" in the "SUPPLEMENT' section.
1-21
Page 44 of 421

FOR SAFE DRIVING
Installation suitability of SUZUKI recommendation child restraint systems (for the vehicle with airbag deactivation switch)
Recommendation of Mass group Child restraint system (#A)
0,0+ Britax Romer Baby-Safe i-Size (up to 13kg)
I Britax Romer Duo Plus (9kg to 18kg)
11, Ill Britax Romer Kid Fix XP (15kg to 36kg)
Key of letters to be inserted in the above table YES =It is suitable for this seating position NO = II is not suitable for this seating position
#1: Only belted.
Seating position
G)
Front Front (2) Passenger Passenger airbag is airbag is activated deactivated
NO YES (#1) YES (#1)
NO YES (#1) YES
NO YES (#1) YES
#A: These child restraint systems are SUZUKI Genuine Accessory, refer to the accessories catalog. However, there are countries which do not sell this child restraint system.
1-23
@
YES (#1)
YES
YES
Page 45 of 421

Child restraint systems suitability for each seat position (for the vehicle withÂout airbag deactivation switch)
The above illustration shows Left hand drive vehicle.
NOTE: Seat position number of G), @ and @ is same as Left hand drive vehicle for Right hand drive vehicle.
G) Front passenger's seat @ Rear seat right side @ Rear seat left side
G)
(#1, #2, #3)
~
(#2, #3)
@
(#2, #3)
(gJ
(g)@
[g)~l~
[g)~l~
It is suitable for univerÂsal category of child restraint system fixed with the vehicle seat belt.
It is suitable for i-Size and ISOFIX child restraint system.
This seat is equipped with Top tether anchorÂage point.
Never use a rear-facÂing child restraint sysÂtem on the passenger seat.
FOR SAFE DRIVING
#1: Move the front seat fully rearward. #2: When you install a forward-facing child restraint, if there is a gap or space between the child restraint and the seatback, adjust the seatÂback angle in order to install the child restraint system properly. #3: If the head restraint interferes with the child restratint system, adjust the height of the head restraint or remove it, as necessary.
1-24
Page 46 of 421

FOR SAFE DRIVING
Detailed information for child restraint system (for the vehicle without airbag deactivation switch)
Seat position number
Seating position suitable for universal belted (YES/NO)
· i-Size seating position (YES/NO)
Seating position suitable for lateral fixture (L 1 /L2)
Suitable rear-facing fixture (R1/R2/R3)
Suitable front-facing fixture (F2X/F2/F3)
Key of letters to be inserted in the above table YES =Suitable for this seating position NO = Not suitable for this seating position X =ISOFIX position is not suitable for ISOFIX child restraint systems in this fixture.
CD
YES (#1)
NO
NO
NO
NO
ISOFIX child restraint systems are divided into different mass group, size class and fixture. The child restraint system can be used in the seating positions for fixture shown in the above table. For mass group, size class and fixture, confirm the table of next page.
#1: When installing the child restraint systems, only a front-facing fixture is suitable.
1-25
Seating position
@
YES
YES
X
R1, R2
F2X, F2, F3
@
YES
YES
X
R1, R2
F2X, F2, F3
Page 48 of 421

FOR SAFE DRIVING
Installation suitability of SUZUKI recommendation child restraint systems (for the vehicle without airbag deactivation switch)
Recommendation of Mass group Child restraint system (#A)
0,0+ Britax Romer Baby-Safe i-Size (up to 13kg)
I Britax Romer Duo Plus (9kg to 18kg)
II, II I Britax Romer KidFix XP (15kg to 36kg)
Key of letters to be inserted in the above table YES =II is suitable for this seating position NO = It is not suitable for this seating position
#1: Only belted.
G)
NO
YES (#1)
YES (#1)
#A: These child restraint systems are SUZUKI Genuine Accessory, refer to the accessories catalog. However, there are countries which do not sell this child restraint system.
1-27
Seating position
(2) @
YES (#1) YES (#1)
YES YES
YES YES
Page 50 of 421

FOR SAFE DRIVING
ELR type belt
80JC021
1-29
(For models with front passenger airbag deactivation system) Whenever possible, SUZUKI recomÂmends that child restraint systems be installed on . th_e rear seat. According to· accident stat1st1cs, children are safer when ~roperly restrained in rear seating posiÂtions than in front seating positions. • If you must install the child restraint sysÂtem on the front passenger's seat follow instructions below. ' -D_eactivate the front passenger's front airbag by the front passenger airbag d~activation system (if equipped). -Slide the seat to the most rear position by the seat position adjustment lever. -If there is a gap or space between the child restraint and the seatback, adjust the seatback angle in order to install the child restraint system properly.
Install your child restraint system accordÂing to the instructions provided by the child restraint system manufacturer.
Check that the seat belt is securely latched. Move the child restraint system in all direcÂtions to check that it is securely installed. When you put your child in the child restraint system, appropriately slide the front seat forward not to touch a part of your child's body.
Installation with ISOFIX type
anchorages
78RB02020
Your vehicle is equipped with the lower anchorages in the rear seat outboard seatÂing positions for securing a ISOFIX type of child restraints with the connecting bars. The lower anchorages are located where the rear of the seat cushion meets the botÂtom of the seatback.
A WARNING
Install the ISOFIX type of child restraint(s) in the only outboard seatÂing positions, not in the central posiÂtion for the rear seat.
Page 54 of 421

FOR SAFE DRIVING
NOTICE
When installing a child restraint sysÂtem to the rear seat, adjust the front seat position so that the front seat does not interfere with the child restraint system.
NOTE: For Australian models, refer to "For AustraÂlia" in the "SUPPLEMENT" section.
1-33
Seat belt pretensioner system
A WARNING
This section describes your SUZUKI vehicle's seat belt pretensioner sysÂtem. Read and follow all these instructions carefully to minimize your risk of severe injury or death.
To determine if your vehicle is equipped with a seat belt pretensioner system at the front or rear seating positions, check the label on the seat belt at the bottom part. If the letters "p" and/or "PRE" appear as illusÂtrated, your vehicle is equipped with the seat belt pretensioner system. You can use the pretensioner seat belts in the same manner as ordinary seat belts. Read this section and "Supplemental restraint system (airbags)" section to learn more about the pretensioner system.
The seat belt pretensioner system works with the supplemental restraint system (airÂbags). The crash sensors and the elecÂtronic controller of the airbag system also control the seat belt pretensioners. The pretensioners are triggered only when there is a frontal or side collision severe enough to trigger the airbags and the seat belts are fastened. For precautions and general information including servicing the pretensioner system, refer to "SupplemenÂtal restraint system (airbags)" section in addition to this "Seat belt pretensioner sysÂtem" section, and follow all those precauÂtions.
Page 55 of 421

The pretensioner is located in each front seat belt retractor and each rear seat belt retractor in outboard seating position. The pretensioner tightens the seat belt so the belt fits the occupant's body more snugly in the event of a frontal or side collision. The retractors will remain locked after the preÂtensioners are activated. Upon activation, some noise will occur and some smoke may be released. These conditions are not harmful and do not indicate a fire in the vehicle.
The driver and all passengers must be properly restrained by fastening seat belts at all times, whether or not a pretensioner is equipped at their seating position, to minimize the risk of severe injury or death in the event of a collision.
Sit fully back in the seat; sit up straight; do not lean forward or sideways. Adjust the belt so the lap portion of the belt is worn low across the pelvis, not across the waist. Please refer to "Seat adjustment" section and the instructions and precautions about the seat belts in this "Seat belts and child restraint systems" section for details on proper seat and seat belt adjustments.
Please note that the pretensioners along with the airbags will activate in severe fronÂtal or side collisions. They are not designed to activate in rear impacts, rollÂovers, or minor frontal side collisions. The pretensioners can be activated only once. If the pretensioners are activated (that is, if the airbags are activated), have the preÂtensioner system serviced by a SUZUKI dealer as soon as possible.
FOR SAFE DRIVING
If AIRBAG light on the instrument cluster does not blink or come on briefiy when the ignition switch is turned to "ON" position, stays on for more than 1 O seconds, or comes on while driving, the pretensioner system or the airbag system may not work properly. Have both systems inspected by a SUZUKI dealer as soon as possible.
Service on or around the pretensioner sysÂtem components or wiring must be perÂformed only by a SUZUKI dealer who is specially trained. Improper service could result in unintended activation of pretenÂsioners or could render the pretensioner inoperative. Either of these two conditions may result in personal injury.
To prevent damage or unintended activaÂtion of the pretensioners, check that the lead-acid battery is disconnected and the ignition switch has been in "LOCK" position for at least 90 seconds before performing any electrical service work on your SUZUKI vehicle.
Do not touch pretensioner system compoÂnents or wiring. The wires are wrapped with yellow tape or yellow tubing, and the couplers are yellow. When scrapping your SUZUKI vehicle, ask a SUZUKI dealer, body repair shop, or scrap yard for assisÂtance.
1-34