tow SUZUKI NEXA 2015 1.G Owner's Manual
[x] Cancel search | Manufacturer: SUZUKI, Model Year: 2015, Model line: NEXA, Model: SUZUKI NEXA 2015 1.GPages: 288, PDF Size: 8.02 MB
Page 241 of 288
Downloaded from www.Manualslib.com manuals search engine 7-18
INSPECTION AND MAINTENANCE
64MS0-74E
Wheel AlignmentIn case of abnormal tyre wear or pull
ing
towards one s
ide, have the wheel al
igned
at
A U T H O R I S E D - A R U T I 3 U Z U K I . % 8 ! D E A L E R
W O R K S H O P
Tubeless Tyres (If equipped)The veh
icle
is equ
ipped w
ith Tubeless
Tyres
. In tubeless tyre, a th
in layer of butyl
rubber
is used for l
ining the
inside of the
tubeless tyre
. Th
is layer
is to prevent a
ir
loss and fulf
illing the purpose of tube
. The
a
ir pressure
is ma
inta
ined by the seal
ing
between tyre bead and wheel r
im. Tube-
less tyres are hav
ing advantage of slow a
ir
loss and prevent
ing sudden deflat
ion wh
ile
dr
iving.Care and maintenance tips for tubeless
tyres
1) Always ma
inta
in recommended
inflat
ion
pressure
. Dr
iving cont
inuously at low
inflat
ion pressure can lead to tyre dam-
age.
2) In case any leakage
is found, check for
any na
il penetrat
ion/valve core dam-
age or r
im bent
. Damaged wheel must
not be used
.
3) In case tyre has run at low pressure,
it
must be
inspected for any defect
.
4) Whenever new tyre
is fitted, replace the
valve
.
5) If cont
inuous h
igh speed dr
iving
is
requ
ired,
increase tyres pressure by 5
ps
i over recommended
inflat
ion pres-
sure
.
6) Never run the tyre beyond TWI (Tread
wear
indicator)
. The tyre
is recommen-
ded to be replaced when the rema
ining
tread has worn to th
is po
int. The
indica-
tors are spaced across the tread
around the tyre marked by a tr
iangular
symbol (TWI)
.
7) Always prefer tubeless tyre mount
ing
mach
ine. In case of manual mount
ing-
tyre/wheel r
im damage may occur
.
8)
In case of any problem, please get
in
touch w
ith
A U T H O R I S E D - A R U T I 3 U Z U K I
W O R K S H O P
Battery
WA R N I N G
• Batteries produce flammable
hydrogen gas. Keep flames and
sparks away from the battery or an
explosion may occur. Never smoke
when working in the vicinity of the
battery.
• When checking or servicing the
battery, disconnect the negative
cable. Be careful not to cause a
short circuit by allowing metal
objects to contact the battery posts
and the vehicle at the same time.
• To avoid harm to yourself or dam-
age to your vehicle or battery, fol-
low the jump starting instructions
in the “EMERGENCY SERVICE”
section of this manual if it is neces-
sary to jump start your vehicle.
• Diluted sulfuric acid spilled from
battery can cause blindness or
severe burns. Use proper eye pro-
tection and gloves. Flush eyes or
body with ample water and get
medical care immediately if suf-
fered. Keep batteries out of the
reach of children.
Wheel BalancingIf the veh
icle v
ibrates abnormally on
smooth road, have the wheel balanced at
A U T H O R I S E D - A R U T I 3 U Z U K I W O R K S H O P
Page 258 of 288
Downloaded from www.Manualslib.com manuals search engine , 1 6 3 ( & 7 , 2 1 $ 1 ' 0 $ , 1 7 ( 1 $ 1 & (
0 6 (
) R U Z L Q G V K L H O G Z L S H U V
70G119
1) Hold the wiper arm away from the win-
dow.
NOTE:
When raising both of the front wiper arms,
pull the driver’s side wiper arm up first.
When returning the wiper arms, lower the
passenger’s side wiper arm first.
Otherwise, the wiper arms may interfere
with each other.
54G130
2) Squeeze lock (1) towards wiper arm (2)
and remove the wiper frame from the
arm as shown.
3) Unlock the lock end of the wiper blade
and slide the blade out as shown. 5 H P R Y D O
60A260
, Q V W D O O D W L R Q
54G132
(1) Locked end
( ; $ 0 3 / (
Page 259 of 288
Downloaded from www.Manualslib.com manuals search engine
, 1 6 3 ( & 7 , 2 1 $ 1 ' 0 $ , 1 7 ( 1 $ 1 & (
0 6 (
54G135
(1) Retainer
4) If the new blade is provided without the
two metal retainers, move them from
the old blade to the new one.
60MH07160MH072
(A) Up
(B) Down
NOTE:When you install the metal retainers (3),
make sure the direction of metal retainers
as shown in the above illustrations.
5) Install the new blade in the reverse order
of removal, with the locked end posi-
tioned toward the wiper arm.
Make sure the blade is properly retained
by all the hooks. Lock the blade end into
place.6) Reinstall wiper frame to arm, making
sure that the lock lever is snapped
securely into the arm. ) R U U H D U Z L S H U V
80G146
1) Hold the wiper arm away from the win-
dow.
2) Remove the wiper frame from the arm
as shown.
3) Slide the blade out as shown.
(3)
(3)
( ; $ 0 3 / (
(3)(A)
(B)
( ; $ 0 3 / (
( ; $ 0 3 / (
Page 264 of 288
Downloaded from www.Manualslib.com manuals search engine ( 0 ( 5 * ( 1 & < 6 ( 5 9 , & (
0 6 (
7 L U H & K D Q J L Q J 7 R R O
61MM0B100
(1) Spare tire
(2) Jack
(3) Jack handle
(4) Wheel Brace
(5) Luggage Compartment Board
The tire changing tools are stowed in the luggage compartment.
(3) (4) (2)
(5)
(1)
( ; $ 0 3 / (
64MS142
To remove the spare tire, turn its bolt (1)
counterclockwise and remove it.
: $ 5 1 , 1 *
$ I W H U X V L Q J W K H W L U H F K D Q J L Q J W R R O V E H
V X U H W R V W R Z W K H P V H F X U H O \ R U W K H \
F D Q F D X V H L Q M X U \ L I D Q D F F L G H Q W
R F F X U V
& $ 8 7 , 2 1
7 K H M D F N V K R X O G E H X V H G R Q O \ W R
F K D Q J H Z K H H O V , W L V L P S R U W D Q W W R U H D G
W K H M D F N L Q J L Q V W U X F W L R Q V L Q W K L V V H F
W L R Q E H I R U H D W W H P S W L Q J W R X V H W K H
M D F N
(1)
( ; $ 0 3 / (
Page 269 of 288
Downloaded from www.Manualslib.com manuals search engine
( 0 ( 5 * ( 1 & < 6 ( 5 9 , & (
0 6 (
4) If the booster battery you are using is fit-
ted to another vehicle, start the engine of
the vehicle with the booster battery. Run
the engine at moderate speed.5) Start the engine of the vehicle with the
flat battery.
6) Remove the jump leads in the exact
reverse order in which you connected
them.
7 R Z L Q JIf you need to have your vehicle towed,
contact a professional service. Your dealer
can provide you with detailed towing
instructions.
: K H H O ' U L Y H : ' 0 D Q X D O 7 U D Q
V D [ O HManual transaxle vehicles may be towed
using either of the following methods.
1) From the front, with the front wheels
lifted and the rear wheels on the ground.
Before towing, make sure that the park-
ing brake is released.
2) From the rear, with the rear wheels lifted
and the front wheels on the ground, pro-
vided the steering and drivetrain are in
operational condition. Before towing,
make sure that transaxle is in neutral,
the steering wheel is unlocked (vehicle
without keyless push start system - the
ignition key should be in the “ACC” posi-
tion) (vehicle with keyless push start sys-
tem - the ignition mode is ACC), and the
steering wheel is secured with a clamp-
ing device designed for towing service.
& $ 8 7 , 2 1
& R Q Q H F W W K H M X P S O H D G W R W K H H Q J L Q H
P R X Q W E U D F N H W V H F X U H O \ , I W K H M X P S
O H D G G L V F R Q Q H F W V I U R P W K H H Q J L Q H
P R X Q W E U D F N H W E H F D X V H R I Y L E U D W L R Q D W
W K H V W D U W R I W K H H Q J L Q H W K H M X P S O H D G
F R X O G E H F D X J K W L Q W K H G U L Y H E H O W V
NOTICE
2 E V H U Y H W K H I R O O R Z L Q J L Q V W U X F W L R Q V
Z K H Q W R Z L Q J \ R X U Y H K L F O H