cruise control SUZUKI NEXA 2015 1.G Owners Manual
[x] Cancel search | Manufacturer: SUZUKI, Model Year: 2015, Model line: NEXA, Model: SUZUKI NEXA 2015 1.GPages: 288, PDF Size: 8.02 MB
Page 85 of 288
Downloaded from www.Manualslib.com manuals search engine
% ( ) 2 5 ( ' 5 , 9 , 1 *
0 6 (
However, repeating these operations could
cause damage to the power steering sys-
tem.
NOTE:
If the power steering system does not work
properly, you will feel heavier to steer but
you still will be able to steer.
NOTE:
If the steering is operated, you may hear a
noise. This is normal and indicates that the
power steering system works properly.
³ & 5 8 , 6 ( ´ , Q G L F D W R U / L J K W
L I H T X L S S H G
52D113
When the cruise control system is on, this
light will be on.
Page 115 of 288
Downloaded from www.Manualslib.com manuals search engine
2 3 ( 5 $ 7 , 1 * < 2 8 5 9 ( + , & / (
0 6 (
& U X L V H & R Q W U R O L I H T X L S S H G The cruise control system allows you to
maintain a steady speed without keeping
your foot on the accelerator pedal. The
controls for operating the cruise control
system are on the steering wheel.
You can use the cruise control system with
the following conditions:
• The gear position is in 3rd, 4th, 5th or 6th
(if equipped).
• The vehicle speed is about 40 km/h (25
mph) or higher.
61MS416
(1) “CRUISE” switch
(2) “CANCEL” switch
(3) “RES +” switch
(4) “SET –” switch
7 R 6 H W & U X L V L Q J 6 S H H G1) Turn on the cruise control system by
pushing the “CRUISE” switch (1). When
the “CRUISE” indicator light comes on,
you can set cruising speed.
2) Accelerate or decelerate to the desired
speed.
3) Push the “SET –” switch (4) and the
“SET” indicator light will turn on. Take
your foot off the accelerator pedal and
the set speed will be maintained.
: $ 5 1 , 1 *
7 R K H O S D Y R L G O R V V R I Y H K L F O H F R Q W U R O
G R Q R W X V H W K H F U X L V H F R Q W U R O V \ V W H P
Z K H Q G U L Y L Q J L Q K H D Y \ W U D I I L F R Q V O L S
S H U \ R U Z L Q G L Q J U R D G V R U R Q V W H H S
G R Z Q J U D G H V
(1)(2)
(3)(4)
: $ 5 1 , 1 *
, I W K H F U X L V L Q J V S H H G L V V H W E \ D F F L
G H Q W \ R X F D Q Q R W G H F H O H U D W H D Q G P D \
O R R V H F R Q W U R O R I W K H Y H K L F O H 7 K L V
F R X O G O H D G W R D Q D F F L G H Q W U H V X O W L Q J L Q
V H Y H U H L Q M X U \ R U G H D W K
7 X U Q R I I W K H F U X L V H F R Q W U R O V \ V W H P
D Q G P D N H V X U H W K H
Page 116 of 288
Downloaded from www.Manualslib.com manuals search engine 2 3 ( 5 $ 7 , 1 * < 2 8 5 9 ( + , & / (
0 6 (
³ & 5 8 , 6 ( ´ , Q G L F D W R U / L J K W
52D113
When you push the “CRUISE” switch, the
system is on and a “CRUISE” indicator
light on the instrument cluster will be on.
³ 6 ( 7 ´ , Q G L F D W R U / L J K W
65D474
When the vehicle’s speed is controlled by
the cruise control system, a “SET” indica-
tor light on the instrument cluster will be
on. 7 R & K D Q J H 6 S H H G 7 H P S R U D U L O \When the cruising speed is maintained,
you can temporarily accelerate or deceler-
ate.
To accelerate, depress the accelerator
pedal. When you take your foot off the
pedal, your vehicle will return to the set
speed.To decelerate, depress the brake pedal.
The set speed will be canceled and “SET”
indicator light will go off.
To resume the previously set speed, push
the “RES +” switch (3) and turn on the
“SET” indicator light again when vehicle
speed is above 40 km/h (25 mph). The
vehicle will accelerate to and maintain the
previously set speed.
7 R & K D Q J H & U X L V L Q J 6 S H H G 8 V L Q J W K H D F F H O H U D W R U S H G D O
To reset at a faster cruising speed, accel-
erate to the desired speed using the accel-
erator pedal and push the “SET –” switch
(4). The new speed will be maintained.
8 V L Q J W K H E U D N H S H G D O
To reset at a slower cruising speed, decel-
erate to the desired speed using the brake
pedal and push the “SET –” switch (4). The
new speed will be maintained.
NOTE:
When the brake pedal is depressed, the
“SET” indicator light goes off until the cruis-
ing speed is reset.
8 V L Q J W K H
Page 117 of 288
Downloaded from www.Manualslib.com manuals search engine
2 3 ( 5 $ 7 , 1 * < 2 8 5 9 ( + , & / (
0 6 (
& D Q F H O O D W L R Q R I W K H & U X L V H & R Q W U R OThe “SET” indicator light will go off and the
cruise control will be canceled temporarily
with following procedures:
• Push the “CANCEL” switch (2).
• Depress the brake pedal.
• Depress the clutch pedal.
• The vehicle speed falls more than about
20 percent from the set speed.
• Any time the vehicle speed falls below
40 km/h (25 mph).
To resume the previously set speed, push
the “RES +” switch (3) and turn on the
“SET” indicator light. Besides, the vehicle
speed has to be above 40 km/h (25 mph)
when the vehicle is not in the above condi-
tions.
To turn off the cruise control system, push
the “CRUISE” switch (1) and make sure
the “CRUISE” indicator light is off.
Also, if the malfunction indicator light in the
instrument cluster comes on or blinks, the
cruise control system will be turned off.
NOTE:
If you turn off the cruise control system, the
previously set speed in the memory is
cleared. Reset your cruising speed again.
3 D U N L Q J 6 H Q V R U V L I H T X L S S H G
61MM0A192
(1) Symbol representing an obstacle
detected by parking sensor*
* This symbol represents an obstacle
that is located to the right rear at
the vehicle.
• The parking sensor system uses ultra-
sonic sensors to detect obstacles near
the rear bumper. If obstacles are sensed
while you are parking or moving the
vehicle slowly, the system warns you by
sounding a buzzer and displaying sym-
bols representing the obstacles on the
information display in the instrument
cluster.
• The system emits an ultrasonic wave
and the relevant sensor detects the
return of the wave reflected by an obsta-
cle. The system measures the time
taken by the ultrasonic wave to reach the
obstacle and return from it, from which it
determines the obstacle’s position.
• The parking sensor function can be used
when you press the engine switch tochange the ignition mode to “ON”, the
gearshift lever is in “R” position and the
parking sensor switch is in the “ON”
position. This function is helpful in the
following cases: pulling over to the curb;
parallel-parking the vehicle; steering the
vehicle into a garage; driving along an
alley; and moving slowly in a place with
obstacles.
(1)
: $ 5 1 , 1 *
Page 246 of 288
Downloaded from www.Manualslib.com manuals search engine 7-23INSPECTION AND MAINTENANCE
64MS0-74E
*Feature not available in the vehicle.
81A283
PRIMARY FUSE
(1) – Blank
(2) 20 A Power window timer
(3) 15 A Steering lock
(4) 20 A Rear defogger(5)
20 A
Sunroof*
(6)
10 A
DRL*
(7)
10 A
Heated mirror*
(8) 7.5 A Starting signal
(9) 15 A Accessory socket 2
(10) 30 A Power window
(11) 10 A Hazard
(12) 7.5 A BCM
(13) 15 A Ignition coil
(14) 10 A ABS control module
(15) 15 A Accessory socket
(16)
10 A
A-STOP controller*
(17) 15 A Horn
(18) 10 A Stop light
(19) 10 A Air bag
(20) 10 A Back-up light
(21) 15 A Wiper / Washer
(22) 30 A Front wiper
(23) 10 A Dome light(24)
15 A
4WD*
(25)
7.5 A
RR fog lamp*
(26) – Blank
(27) 7.5 A Ignition-1 signal
(28) 15 A Radio 2
(29) 10 A Accessory socket 3
(30) 15 A Radio
(31) 10 A Tail lamp
(32) 20 A D/L
(33) 7.5 A Cruise control
(34) 10 A Meter
(35) 7.5 A Ignition-2 signal
(36)
20 A
Seat heater*
WA R N I N G
Always be sure to replace a blown
fuse with a fuse of the correct amper-
age. Never use a substitute such as
aluminum foil or wire to replace a
blown fuse. If you replace a fuse and
the new one blows in a short period of
time, you may have a major electrical
problem. Have your vehicle inspected
immediately by your D X W K R U L V H G
0 D U X W L 6 X ] X N L Z R U N V K R S.
BLOWN OK