Downloaded from www.Manualslib.com manuals search engine Maintenance and Lubrication: 0B-3
NOTE
β’ βIβ: Inspect and correct or replace if necessary
β’ βRβ: Replace or change
β’ *1: Inspect or replace more frequently if the vehicle is used under dusty conditions.
β’ *2: Clean or replace more frequently if the air from the air conditioning decreases.
Repair Instructions
Accessory Drive Belt InspectionS7RS0B0206001
WARNING!
All inspection and replacement are to be
performed with ENGINE NOT RUNNING.
Water Pump and Generator Drive Belt1) Disconnect negative (β) cable at battery.
2) Inspect belt for cracks, cu ts, deformation, wear and
cleanliness. If any defect exists, replace.
Check belt for tension.
Water pump and generator belt tension
βaβ: 4.5 β 5.5 mm (0.18 β 0.22 in.) deflection
under 100 N (10 kg, 22 lb) pressure
NOTE
When replacing belt with a new one, adjust
belt tension to 3.5 β 4 mm (0.14 β 0.16 in.)
3) If belt is too tight or too loose, adjust it to
specification by adjusting alternator position.
4) Tighten alternator adjusting bolts and pivot bolt.
5) Connect negative (β) cable to battery. A/C Compressor Drive Belt
1) Disconnect negative (β) cable at battery.
2) Inspect belt for cracks, cuts, deformation, wear and cleanliness. If any defect exists, replace.
Check belt for tension.
If belt tension is out of specification, adjust it
referring to βCompressor Dr ive Belt Inspection and
Adjustment in Section 7Bβ.
A/C compressor drive belt tension
βaβ: 7 β 8 mm (0.28 β 0.31 in.) deflection under
100 N (10 kg, 22 lb) pressure
NOTE
When replacing belt with a new one, adjust
belt tension to 6 β 7 mm (0.24 β 0.28 in.).
3) Connect negative (β) cable to battery.
β B β β E β β H Automatic transaxle fluid
) R Every 30,000 km (18,000 miles) or
24 months
β β C D β β β β HVAC air filter (if equipped) *2 )
I Every 15,000 km (9,000 miles) or 12
months
) R Every 45,000 km (27,000 miles) or
36 months
Severe
condition code MaintenanceMaintenance
operation Maintenance interval
I3RM0A020001-01
I4RS0A020001-01
