windscreen SUZUKI SWIFT 2017 5.G Owners Manual

5-7OTHER CONTROLS AND EQUIPMENT
74LH0-74E
Temperature-controlled air comes out of
the floor outlets and the side outlets, a
small amount of air comes out of the wind-
shield defroster outlets and also comes
slightly out of the side demister outlets.
Heat & defrost (f)
74LHT0507
Temperature-controlled air comes out of
the floor outlets, the windshield defroster
outlets, the side demister outlets and the
side outlets.
Defrost switch (5)
68LM518
Push the defrost switch (5) to turn on the
defroster.
This is used to clear the windscreen and
side windows by Pushing the switch when
the defroster switch is ON, the indicator
light above the defroster switch will come
ON and the defroster display is shown is
the display.Defrost
74LHT0508
Temperature-controlled air comes out of
the windshield defroster outlets, the side
defroster outlets and the side outlets.
NOTE:
When the defrost switch (5) is pushed to
turn on the defroster, the air conditioning
system will come on and the “FRESH AIR”
mode will be selected automatically. In
very cold weather, however, the air condi-
tioning system will not turn on.
Air conditioning switch (6)
68LM555
The air conditioning switch (6) is used to
turn on and off the air conditioning system
only when the blower is on. To turn on the
air conditioning system, push in the switch
and “A/C” will appear on the display. To
turn off the air conditioning system, push in
the switch again and “A/C” will go off.
System Operating InstructionsAutomatic operation
68LM520
You can let the climate control system work
automatically. To set the system for fully-auto-
matic operation, follow the procedure below.
1) Start the engine.
2) Push the “AUTO” switch (8).
3) Set the desired temperature by turning
the temperature selector (1).
The blower speed, air intake and air flow
are controlled automatically to maintain the
set temperature.
NOTE:
When you select the recirculated air mode,
the automatic operation system is deacti-
vated if you push the “AUTO” switch (8).
(5)
(6)
(1)(6)
(7) (8)
Folding Rear Seats: 3

10-2
GENERAL INFORMATION
74LH0-74E
Radio frequency identification
(RFID) tag As per Ministry of Road Transport and
Highways, the Radio frequency identifica-
tion (RFID) tag (1) is mandatory for each
vehicle for the purpose of electronic toll
collection or any other purpose as may be
defined by the Government of India.
In case of any damage to RFID tag or
replacement of front windscreen, please
contact your nearest MARUTI SUZUKI
Authorized workshop.
74LHM1001
As seen from inside of the vehicle
74LHM1002
NOTE:
The picture shown is for indicative purpose
only. Internal structure of actual device
mounted on vehicle may be different.
As seen from outside of the vehicle
74LHM1003
NOTE:
The picture shown is for indicative purpose
only. Internal structure of actual device
mounted on vehicle may be different.
NOTE:
RFID tag needs to be registered by gov-
ernment authorized agency (if applica-
ble).
Any attempt to remove the tag from the
windscreen will result in permanent dam-
age to the tag.
Use of chemical cleaners to clean the
windscreen area where the tag is
mounted can damage the tag.
Use of any sharp objects on the tag can
damage the tag.
(1)
EXAMPLE
EXAMPLE
EXAMPLE