battery location TESLA MODEL Y 2022 Owner´s Manual

2. Adjust the charge limit by touching Set Limit, and
drag the arrow below the battery to indicate the level of charging you want. The setting you choose applies
to immediate and scheduled charging sessions.3.
The current automatically sets to the maximum
current available from the attached charge cable,
unless it was previously reduced to a lower level. If
needed, touch
- or + to change the current (for
example, you may want to reduce the current if you
are concerned about overloading a domestic wiring circuit shared by other equipment). It is not possible to set the charging current to a level that exceeds the
maximum available from the attached charge cable. When you change the current,
Model Y remembers
the location. If you charge at the same location, you
do not need to change it again.
NOTE: If Model Y is charging and detects unexpected

Jacking Procedure
Follow the steps below to lift Model Y. Ensure that any
non-Tesla repair facility is aware of these lifting points.
1.
Position Model Y centrally between the lift posts.
2.
Position the lift arm pads under the designated body lift points at the locations shown.
WARNING: DO NOT position the lift arm pads
under the Battery or side rails, as shown in red.
3.
Adjust the height and position of the lift arm pads to ensure that they are correctly located.
4.
With assistance, raise the lift to the desired height, ensuring the lift arm pads remain in their correct positions.
5.
Engage any lift safety locks. Follow the lift
manufacturer

If the outlet is worn, it should be replaced with a high-quality outlet. Consider upgrading to a Tesla Wall Connector
for greater convenience and highest charging speed.
(UMC_a017)
Charge rate reduced - Wall plug temperature high
Wall outlet and wiring inspection recommended
High temperature detected by Mobile Connector alerts indicate the outlet used to charge is becoming too warm, so
charging has been slowed to protect the outlet.
This is not typically an issue with your vehicle or your Mobile Connector, but rather an issue with the outlet. A warm outlet may be caused by a plug that is not fully inserted, a loose building wiring connection to the outlet, or an outlet that is beginning to wear out.
To regain normal charge speed, make sure your adapter is fully plugged into the outlet. If charging speed does not
return to normal, contact an electrician to inspect the outlet and building wiring connections to the outlet and
complete any repairs needed.
If the outlet is worn, it should be replaced with a high-quality outlet. Consider upgrading to a Tesla Wall Connector
for greater convenience and highest charging speed.
(VCFRONT_a180)
Electrical system power reduced
Vehicle may shut down unexpectedly
The electrical system cannot maintain the voltage required to support all vehicle features.
If this alert is present while you are driving, it is possible your vehicle will shut down unexpectedly.
It is also possible that your vehicle will not restart after the current drive.
It is recommended that you eliminate or reduce your use of any non-essential features. This can help your vehicle maintain adequate electrical power for essential functions. It may also prevent your vehicle from shutting down
before you reach your immediate destination, although this is not guaranteed.
If this alert remains active, schedule service immediately. Without service, your vehicle may shut down unexpectedly
or may not restart.
(VCFRONT_a182)
12V battery must be replaced - Schedule service
Software will not update until battery is replaced
The 12V battery is showing degraded performance and needs to be replaced. Until the 12V battery is replaced,
vehicle software updates will not complete.
It is recommended that you have the 12V battery replaced at your earliest convenient opportunity.
You can schedule service via the Tesla Mobile App, or with an independent service provider that offers 12V battery
replacement for your vehicle. Please note that independent service provider options may vary, based on your vehicle
configuration and your location.
Your vehicle is OK to drive with this alert present. However, if you delay the 12V battery replacement, your vehicle
may eventually not have enough power to start or to restart after a recent drive.
If the 12V battery is too low to turn on the vehicle or open the doors, follow the instructions in Jump Starting the 12V
Battery on page 199.
For more information on the battery system, see Battery Information on page 158.
Troubleshooting Alerts
238MODEL Y Owner

F
factory defaults, restoring: 127
factory reset: 127
fan speed, interior: 128
favorites (Media Player): 139
Favorites (navigation): 134
FCC certifications: 207
features, downloading new: 153
firmware (software) updates: 153
flash drives, playing audio files from: 139
flashers, warning: 55
floor mats: 174
fluids: 164, 176
replacement intervals: 164
reservoirs, checking: 176
fog lights: 53
forward collision warning: 117
front passenger detection: 40
front trunk: 16
G
garage doors, opening: 149
gates, opening: 149
GAWR: 182
gears: 52
glovebox: 19
Glovebox PIN: 145
Gross Axle Weight Rating: 182
Gross Vehicle Weight Rating: 182
ground clearance: 184
GVWR: 182
H
hazard warning flashers: 55
head supports: 27
headlights: 53, 54
after exit: 54
controlling: 53
high beams: 54
heating: 128
high beam headlights: 54
high voltage: 156, 165, 189
Battery specifications: 189
components: 156
safety: 165
hills, stopping on: 66
Home location: 136
HomeLink: 108, 149
programming and using: 149
when using Summon: 108
hood: 16
horn: 47
hub caps: 168
I
I