ECO mode TOYOTA 4RUNNER 2004 N210 / 4.G Navigation Manual
[x] Cancel search | Manufacturer: TOYOTA, Model Year: 2004, Model line: 4RUNNER, Model: TOYOTA 4RUNNER 2004 N210 / 4.GPages: 161, PDF Size: 4.06 MB
Page 141 of 161
4Runner_Navi_U (L/O 0308)
133
2004 4RUNNER Navigation from Aug. ’03 Prod. (OM35813U)
(b) Tone and balance
How good an audio program sounds to
you is largely determined by the mix of
the treble, midrange, and bass levels. In
fact, different kinds of music and vocal
programs usually sound better with differ-
ent mixes of treble, mid−range and bass.
A good balance of the left and right ste-
reo channels and of the front and rear
sound levels is also important.
Keep in mind that if you are listening to
a stereo recording or broadcast, changing
the right/left balance will increase the vol-
ume of one group of sounds while de-
creasing the volume of another.
NZN030
Touching the “SOUND” switch dis-
played on the screen at the audio con-
trol mode will display the sound con-
trol mode. Adjust the tone and balance
as follows.
To adjust the tone, touch the “+” or
“ ” switches on the screen. To adjust
the balance between the front and rear
speakers, touch the “Front” or “Rear”
switch on the screen, and to adjust
the balance between the left and right,
touch the “L” or “R” switch on the
screen.
BASS: Adjusts low−pitched tones.
MID: Adjusts mid−pitched tones.
TREB: Adjusts high−pitched tones.
As the orange display goes up, each tone
is more emphasized.(c) Surround function
Touching the “SURROUND” switch dis-
played on the screen at the audio con-
trol mode will turn on or off the sur-
round function.
Page 144 of 161
4Runner_Navi_U (L/O 0308)
136
2004 4RUNNER Navigation from Aug. ’03 Prod. (OM35813U)
Each radio mode (AM, FM1 or FM2) can
store up to 6 stations. To change the
preset station to a different one, follow
the same procedure.
The preset station memory is cancelled
when the power source is interrupted by
battery disconnection or a blown fuse.(c) Selecting a station
Tune in the desired station using one of
the following methods.
Preset tuning: Touch the switch (1−6) for
the station you want. The switch is high-
lighted in green and the station frequency
appears on the screen.
Seek tuning: Push the “SEEK/TRACK”
button on either side. The radio will begin
seeking up or down for a station of the
nearest frequency and will stop on recep-
tion. Each time you push the button, the
stations will be searched automatically
one after another.
To scan all the frequencies: Touch the
“SCAN” switch on the screen or push the
“SCAN” button briefly. “SCAN” appears on
the screen. The radio will find the next
station and stay there for a few seconds,
and then scan again. To select a station,
touch the “SCAN” switch or push the
“SCAN” button again.To scan the preset stations: Touch the
“SCAN” switch on the screen or push the
“SCAN” button for longer than 2 seconds.
“P. SCAN” appears on the screen. The
radio will tune in the next preset station,
stay there for a few seconds, and then
move to the next preset station. To select
a station, touch the “SCAN” switch or
push the “SCAN” button again.
Page 148 of 161
4Runner_Navi_U (L/O 0308)
140
2004 4RUNNER Navigation from Aug. ’03 Prod. (OM35813U)
L00173
To stop and eject the cassette tape, push
the “OPEN” button to lower the display.
Push the “TAPE
” button.
L00177
Push the “TAPE” button if a cassette
tape is already in the slot.
Dolby Noise Reduction
∗ feature: If you
are listening to a tape that was recorded
with Dolby
∗ Noise Reduction, touch the
“
” switch on the screen. The symbol
is highlighted in green.
The Dolby NR mode reduces tape noise
by about 10 dB. For best sound repro-
duction, play your tapes with the Dolby
NR on or off according to the mode used
for recording the tape.
To play a tape recorded without Dolby
NR, touch the switch once again.