alarm TOYOTA AVALON 2001 Service Repair Manual
[x] Cancel search | Manufacturer: TOYOTA, Model Year: 2001, Model line: AVALON, Model: TOYOTA AVALON 2001Pages: 1897, PDF Size: 26.61 MB
Page 165 of 1897
BE-136
- BODY ELECTRICALAUDIO SYSTEM
1740 Author: Date:
2001 AVALON (RM808U)
3. Europe models:
DIAGNOSIS CODE LIST
TermsMeaning
Physical addressThree-digit code (shown in hexadecimal) which is given to each component com-
prising the AVC-LAN.
Corresponding to the function, individual symbols are specified.
Logical addressTwo-digit code (shown in hexadecimal) which is given to each function comprising
the inner system of the AVC-LAN.
(a) Physical address 190: Radio receiver assembly
HINT:
*1: Even if no failure is detected, it may be stored depending on the battery condition or voltage for
starting an engine.
*2: It is stored when 180 sec. has passed after the power supply connector is pulled out after engine
start.
*3: It may be stored when the engine key is turned 1 min. again after engine start.
*4: It may be stored when the engine key is turned again after engine start.
*5: When 210 sec. has passed after pulling out the power supply connector of the master component
with the ignition switch in ACC or ON, this code is stored.
(1) Logical address: 01 (Communication control)
DTCDiagnosis itemDiagnosis contentCountermeasure and inspected parts
D6
*1Absence of MasterComponent in which this code is recorded
has been disconnected from system with
ignition in ACC or ON. Or, when this code
was recorded, multi-display assembly was
disconnected.Check harness for power supply system of
multi-display.
Check harness for communication system
of multi-display.
Check harness for power supply system of
radio and player.
Check harness for communication system
of radio and player.
D8
*2No Response to Connection CheckComponent shown by auxiliary code is or
had been disconnected from system after
engine is start.
D9Check harness for power supply system of
component shown by auxiliary code.
Check harness for communication system
of component shown by auxiliary code.
D9
*1Last Mode ErrorComponent operated (sounds and/or
images were provided) before engine stop is
or has been disconnected with ignition
switch in ACC or ON.Check harness for power supply system of
component shown by auxiliary code.
Check harness for communication system
of component shown by auxiliary code.
DANo Response to ON/OFF InstructionNo response is identified when changing
mode (audio and visual mode change).
Detected when sound and picture does not
change by button operation.Check harness for power supply system of
component shown by auxiliary code.
Check harness for communication system
of component shown by auxiliary code.
If error occurs again, replace component
shown by auxiliary code.
DB
*1Mode Status ErrorDual alarm is detected.Check harness for power supply of compo-
nent shown by auxiliary code.
Check harness for communication system
of component shown by auxiliary code.
DC
*3Transmission ErrorTransmission to component shown by auxil-
iary code has been failed.
(Detecting this DTC does not necessarily
mean actual failure.)If same auxiliary code is recorded in order
component, check harness for power supply
and communication system of all compo-
nents shown by code.
Page 1259 of 1897
DI4DL-03
- DIAGNOSTICSTHEFT DETERRENT SYSTEM
DI-519
675 Author: Date:
2001 AVALON (RM808U)
PRE-CHECK
1. THEFT DETERRENT SYSTEM
When the system is set to the theft deterrent mode and any of
the following conditions are met, the system sounds the horns
and flashes the headlights and the taillights for approx. 1 min-
ute.
At the same time the system locks all doors (If all door are not
locked at once, the system repeats door locking operation ev-
ery 6.38 seconds during the one minute alarm time).
There are 2 modes in this system, which are active mode and
passive mode.
All initial setting are performed in active mode. It can be
switched to passive mode by specified operation. (See step 4.
CHANGING METHOD OF PASSIVE MODE)
Condition:
Any of the doors (Including the engine hood and luggage
compartment door) is unlocked or opened without the
key. *1
The battery terminal is disconnected and reconnected.
The system receives panic signal from remote keyless
entry. *2
*1: Only active arming mode.
*2: When the ignition key is not inserted in the key cylinder.
There are 4 conditions in this system which are disarming
condition, disarming preparation condition, arming condition
and alarming condition.
(a) Disarming condition:
(1) When a user is near the vehicle.
(2) When the alarming function does not operate.
(3) When theft deterrent function is not performed.
(b) Disarming preparation condition:
(1) Time from a user locks a door to be leaves the ve-
hicle.
(2) Time until transferring to disarming condition.
(3) Theft deterrent function is not performed.
(c) Arming condition:
(1) When a user leaves the vehicle completely.
(2) When theft deterrent function is possible.
Page 1260 of 1897
DI-520
- DIAGNOSTICSTHEFT DETERRENT SYSTEM
676 Author: Date:
2001 AVALON (RM808U)
(d) Alarming condition:
Is this condition, once theft is detected, it is informed us-
ing light and sound to people around the vehicle.
Refer to the table for alarming method or time.
Horn
Al i th dSecurity hornAlarming methodHeadlight
Taillight
Alarming time60 seconds
Alarming outputContinuous 0.40 secs. (ON)
0.40 secs. (OFF)
In the arming condition when either of doors is unlocked and
with not key in the key cylinder, force lock signal is output.
Page 1261 of 1897
Disarming condition
Any of the following conditions is met
When all doors and engine hood are closed, lock all the doors using a key.
When all doors and engine hood are closed, lock all the doors using wireless remote function.
When all doors and engine hood are closed, open and close either of doors and engine hood
then close and lock all doors and engine hood.
Disarming preparation condition
Any of the following conditions is met
30 seconds elapse when the engine hood
is closed and all doors are locked.
Any of the following conditions is met
Close and open either of all doors and
engine hood.
Lock and unlock either of doors.
Insert a key into the ignition key cylinder.
Reconnect the battery.
Arming condition
Any of the following conditions is met
Unlock the locked doors using the wireless
remote function.
Unlock the locked doors using the key.
Insert the key into the ignition key cylinder
and turn the ignition key ON.
Any of the following conditions is met
Either of closed doors opens.
Either of locked doors is unlocked by any
operation other than key or wireless remote
function.
The closed engine hood is opened.
The battery is reconnected.
Ignition switch turned to ON.
Alarming condition
Any of the following conditions is met
Unlock the locked doors using the wireless
remote function.
Unlock the locked doors using the key.
Insert the key into the ignition key cylinder
and turn the ignition key ON.
In this mode, once theft is detected, it is
informed using light and sound to people
around the vehicle.
The alarming time described above passes.
(Key not inserted in ignition cylinder.)
- DIAGNOSTICSTHEFT DETERRENT SYSTEM
DI-521
677 Author: Date:
2001 AVALON (RM808U)
2. ACTIVE ARMING MODE
Page 1262 of 1897
DI-522
- DIAGNOSTICSTHEFT DETERRENT SYSTEM
678 Author: Date:
2001 AVALON (RM808U)
Indicator light output:
ConditionIndicator light
Disarming conditionOFF
Arming preparation conditionON
Arming conditionOFF
Alarming conditionON
HINT:
Even in disarming condition, the indicator light flash. (Due to the
signal output form immobilizer system). The indicator always
flashes receiving the signal from the immobilizer system at any
time in the arming condition.
Flashing frequency:
0.2 seconds (ON)
1.8 seconds (OFF)
3. PASSIVE ARMING MODE
This mode can be switched according to the specified op-
eration.
All initially set modes (when shipped from factory) are ac-
tive mode. (No passive mode)
Page 1263 of 1897
Perform any of the following and the system will go to Disarmed state (B):
Remove the key from the ignition, close the driver's door, then the ignition OFF.
Disarmed state (A)
Perform any of the following and the system
will return to Disarmed state (A):
Push the unlock switch on the wireless
remote.
Put the key in the lock on the driver's or the
passenger door and turn it towards unlock.
Put the key in the ignition.
Reconnect the battery.
Turn the ignition from OFF to ON.
Disarmed state (B)
Perform any of the following and the system
will go to Arming preparation:
Close all the doors, hood and
luggage compartment door.
Perform any of the following
and the system
will return to Disarmed state
(B):
Open any of the doors, the
hood or the
luggage compartment door.
Arming preparation
Perform any of the following
and the system
will go to Armed state:
Allow 30 seconds to elapse
with all the doors,
hood and luggage compart-
ment door closed.
Perform any of the following
and the system will return to
Disarmed state (A):
Push the unlock switch on
the wireless remote.
Put the key in the lock on
the driver's or the
passenger door and turn
it towards unlock.
Put the key in the
ignition and turn it ON.
Run the engine at 550 rpm
or faster for more than 10
seconds.
Armed state
Perform any of the following
and the system will go on to
Alarm sounding:
Open any of the doors and
allow the entry delay time
to pass.
Open the hood.
Open the luggage
compartment door with
something other than the
key or wireless remote.
Reconnect the battery.Perform any of the following
and the system will return to
Disarmed state (B):
Open the luggage
compartment door with the
wireless remote.
Open the luggage
compartment door with the
Key.
Perform any of the following and
the system
will return to Disarmed state (A):
Push the unlock switch on the
wireless
remote.
Put the key in the lock on the
driver's or the
passenger door and turn it to-
wards unlock.
Put the key in the ignition.
Reconnect the battery.
Turn the ignition from OFF to
ON.
- DIAGNOSTICSTHEFT DETERRENT SYSTEM
DI-523
679 Author: Date:
2001 AVALON (RM808U)
Page 1264 of 1897
Perform any of the following
and the system will return to
Armed state:
The alarm sounding
period passes.
Alarm sounding
Perform any of the following
and the system will return to
Disarmed state (A):
Push the unlock switch on
the wireless remote.
Put the key in the lock on
the driver's or the passenger
door and turn it towards
unlock.
Put the key in the ignition
and turn it ON.
Run the engine at 550 rpm
or faster for more than
10 seconds.Perform any of the following
and the system will return to
Disarmed state (B):
Open the luggage
compartment door with the
wireless remote.
Open the luggage
compartment door with the
Key.
DI-524
- DIAGNOSTICSTHEFT DETERRENT SYSTEM
680 Author: Date:
2001 AVALON (RM808U)
Page 1265 of 1897
Door
Indicator
Alarming output
System condition
Arming condition Alarming
condition Entry delay time Close
Open
ON
OFF
ON
OFF
- DIAGNOSTICSTHEFT DETERRENT SYSTEM
DI-525
681 Author: Date:
2001 AVALON (RM808U)
HINT:
In arming condition either closed door is opened, entry delay
occurs. (14 secs.)
During this time, the mode transfers to disarming condition
when the condition described above * is met.
When the condition is not met, the system judges theft occurs,
the mode transfers to alarming condition.
Indicator light output:
ConditionIndicator light
Disarming conditionOFF
Arming preparation conditionON
Arming condition
(Entry delay time)OFF
(ON)
Alarming conditionON
HINT:
Even in disarming condition, the indicator light flash. (Due to the
signal output form immobilizer system). The indicator always
flashes receiving the signal from the immobilizer system at any
time in the arming condition.
Flashing frequency:
0.2 seconds (ON)
1.8 seconds (OFF)
Page 1266 of 1897
DI-526
- DIAGNOSTICSTHEFT DETERRENT SYSTEM
682 Author: Date:
2001 AVALON (RM808U)
Transfer to active mode:
In each passive mode, when ºdisarming condition of ac-
tive mode " arming preparation transfer conditionº is
met, the active mode transfers to each condition. In this
case, active mode continues till disarming condition.
Passive mode when transfer condition is
met.Active mode transfer condition
Disarming conditionArming preparation condition
Arming preparation conditionArming preparation condition
Arming condition
(During entry delay time)Arming condition
(After alarming time has elapsed, arming
condition)
Alarming conditionAfter alarming time has elapsed, arming
condition