fuse diagram TOYOTA AVALON 2001 Service Repair Manual
[x] Cancel search | Manufacturer: TOYOTA, Model Year: 2001, Model line: AVALON, Model: TOYOTA AVALON 2001Pages: 1897, PDF Size: 26.61 MB
Page 619 of 1897
F07886
Driver Side J/B
ECU-IG
No. 2
DI-232- DIAGNOSTICSANTI-LOCK BRAKE SYSTEM WITH ELECTRONIC
BRAKE FORCE DISTRIBUTION (EBD)
388 Author: Date:
2001 AVALON (RM808U)
INSPECTION PROCEDURE
1 Check ECU-IG No. 2 fuse.
PREPARATION:
Remove ECU-IG No. 2 fuse from driver side J/B.
CHECK:
Check continuity of ECU-IG No. 2 fuse.
OK:
Continuity
NG Check for short circuit in all the harness and
components connected to ECU-IG No. 2 fuse
(See attached wiring diagram).
OK
2 Check battery positive voltage.
OK:
Voltage: 10 - 14 V
NG Check and repair the charging system (See
page CH-1).
OK
Page 680 of 1897
F07886
Driver Side J/B
ECU-IG
No. 2
DI-298
- DIAGNOSTICSABS WITH EBD & BA & TRAC & VSC SYSTEM
454 Author: Date:
2001 AVALON (RM808U)
INSPECTION PROCEDURE
1 Check ECU-IG No. 2 fuse.
PREPARATION:
Remove the ECU-IG No. 2 fuse from the driver side J/B.
CHECK:
Check continuity of the ECU-IG No. 2 fuse.
OK:
Continuity
NG Check for short circuit in all the harness and
components connected to ECU-IG No. 2 fuse
(See attached wiring diagram).
OK
2 Check battery positive voltage.
OK:
Voltage: 10 - 14 V
NG Check and repair the charging system (See
page CH-1).
OK
Page 848 of 1897
I13617
Cruise Control ECU
4 3
3
W-B8 Stop Light Switch
4Cruise Control Actuator
13
II1
IJJ9
J/CL
9P-B P-B G-B GNDL
AC4
S4
C15
W-B II1
- DIAGNOSTICSCRUISE CONTROL SYSTEM
DI-563
719 Author: Date:
2001 AVALON (RM808U)
DTC 12 Actuator Magnetic Clutch Circuit
CIRCUIT DESCRIPTION
This circuit turns on the magnetic clutch inside the actuator during cruise control operation according to the
signal from the ECU. If a malfunction occurs in the actuator or speed sensor, etc. during cruise control opera-
tion, the rotor shaft between the motor and control plate is released.
When the brake pedal is depressed, the stop light switch turns on, supplying electrical power to the stop light.
Power supply to the magnetic clutch is mechanically cut and the magnetic clutch is turned OFF.
When driving downhill, if the vehicle speed exceeds the set speed by 15 km/h (9 mph), the ECU turns the
safety magnet clutch OFF. If the vehicle speed later drops to within 10 km/h (6 mph), cruise control at the
set speed is resumed.
DTC No.Detection ItemTrouble Area
12Short in actuator magnetic clutch circuit.
Open (0.8 sec.) in actuator magnetic clutch circuit.
STOP Fuse
Stop light switch
Actuator magnetic clutch
Harness or connector between cruise control ECU and
actuator magnetic clutch, actuator magnetic clutch and body
ground
Cruise control ECU
WIRING DIAGRAM
DI08N-15
Page 853 of 1897
I00292
Vehicle Speed Sensor
ECUCombination Meter
Cruise Control ECU
4 pulses/
1 rotation
of rotor shaft4 pulses/
1 rotation
of rotor shaft
I13616
Cruise Control ECU
12 Combination Meter
3C10
V-W V-W
Y-R BR
to
ABS ECU3F1
M322
M3 M37
BR IJ1 11
EBM3
to ECU-IG Fuse 18
SPD
C15
J/B No. 3
1 DI-568
- DIAGNOSTICSCRUISE CONTROL SYSTEM
724 Author: Date:
2001 AVALON (RM808U)
DTC 21 Open in Vehicle Speed Sensor Circuit
CIRCUIT DESCRIPTION
The signal from the vehicle speed sensor circuit is sent to cruise control ECU as vehicle speed signal.
The rotor shaft is driven by the gear of the transmission.
For each rotation of the shaft, the vehicle speed sensor sends a 4-pulse signal through the combination
meter to the cruise control ECU (See the following installation).
This signal is converted inside the combination meter and sent as a 4-pulse signal to the cruise control ECU.
The ECU calculates the vehicle speed from this pulse frequency.
DTC No.Detection ItemTrouble Area
21Speed signal is not input to the cruise control ECU while cruise
control is set.
Combination meter
Harness or connector between cruise control ECU and com-
bination meter, combination meter and vehicle speed sensor
Vehicle speed sensor
Cruise control ECU
WIRING DIAGRAM
DI08P-18
Page 879 of 1897
I13608
Cruise Control ECU
2
STP
G-W
R3
3C 1B
1
4Stop Light Switch
2
95
FL BlockC15
C15 3
II1
BatterySTOP
W
B 1D33
3D
P-B
W-B
IJ AJ9 J/C W-BP-BG-B8
L F61
F101
ALT
FL MAIN1D11
1G1
II1 13
43
C4
Cruise Control Actuator
S4 Stop Light Switch
S4J/B No. 3
Driver Side J/B Driver Side J/B
G-W
G-W DI-578
- DIAGNOSTICSCRUISE CONTROL SYSTEM
734 Author: Date:
2001 AVALON (RM808U)
Stop Light Switch Circuit
CIRCUIT DESCRIPTION
When the brake pedal is depressed, the stop light switch sends a signal to the ECU. When the ECU receives
this signal, it cancels the cruise control.
A fail-safe function is provided so that the cancel functions normally, even if there is a malfunction in the stop
light signal circuit.
The cancel conditions are: Battery positive voltage at terminal STP-
When the brake is ON, battery positive voltage normally is applied through the STOP fuse and stop light
switch to terminal STP- of the ECU, and the ECU turns the cruise control OFF.
If the harness connected to terminal STP- has an open circuit, terminal STP- will have battery positive volt-
age and the cruise control will be turned OFF.
Also, when the brake is ON, the magnetic clutch circuit is cut mechanically by the stop light switch, turning
the cruise control OFF. (See page DI-563 for operation of the magnetic clutch)
WIRING DIAGRAM
DI08T-17
Page 1071 of 1897
DI-496- DIAGNOSTICSPOWER SEAT CONTROL SYSTEM (w/ Driving Position
Memory)
652 Author: Date:
2001 AVALON (RM808U)
3 Check POWER SEAT fuse.
NG Check for short in all the harness and compo-
nents connected to the POWER SEAT fuse, and
repair them (See attached wiring diagram).
OK
Check and repair harness or connector be-
tween Seat Position Control ECU and battery.
Page 1074 of 1897
- DIAGNOSTICSPOWER SEAT CONTROL SYSTEM (w/ Driving Position
Memory)DI-499
655 Author: Date:
2001 AVALON (RM808U)
3 Check ECU-B No. 2 fuse.
NG Check for short in all the harness and compo-
nents connected to ECU-B No. 2 fuse and repair
them (See attached wiring diagram).
OK
Check and repair harness or connector be-
tween Seat Position Control ECU and battery.
Page 1240 of 1897
I14465
DOME FuseDOOR No.1
Fuse
I11587
1 (+B2)
2 (+B1) 11 (E)
- DIAGNOSTICSTHEFT DETERRENT SYSTEM
DI-535
691 Author: Date:
2001 AVALON (RM808U)
INSPECTION PROCEDURE
1 Check DOME and DOOR No. 1 fuses.
PREPARATION:
Remove DOOR No. 1 and DOME fuse from instrument panel
J/B.
CHECK:
Check continuity of DOME and DOOR No. 1 fuses.
OK:
Continuity
NG Check for short in all the harness and compo-
nents connected to the DOME and DOOR No. 1
fuses (See attached wiring diagram).
OK
2 Check voltage between terminals each of +B1 and +B2 and E of theft deterrent
ECU connector.
PREPARATION:
Disconnect the theft deterrent ECU connector.
CHECK:
Measure voltage between terminals each of +B1 and +B2 and
E of theft deterrent ECU connector.
OK:
Voltage: 10 - 14 V
OK Proceed to next circuit inspection shown on
problem symptom table (See page DI-531).
NG
Page 1245 of 1897
I14465
ECU-IG Fuse
I11586
14 (IG) (-) (+)
- DIAGNOSTICSTHEFT DETERRENT SYSTEM
DI-541
697 Author: Date:
2001 AVALON (RM808U)
INSPECTION PROCEDURE
1 Check CIG and ECU-IG fuses.
PREPARATION:
(a) Remove the fuse box opening cover.
(b) Remove ECU-IG fuses from instrument panel J/B.
CHECK:
Check continuity of ECU-IG fuses.
OK:
Continuity
NG Check for short in all the harness and compo-
nents connected to the ECU-IG fuses (See at-
tached wiring diagram).
OK
2 Check voltage between terminal IG of theft deterrent ECU and body ground.
PREPARATION:
(a) Disconnect the theft deterrent ECU connectors.
(b) Turn ignition switch ON.
CHECK:
Measure voltage between terminal IG of theft deterrent ECU
connector and body ground.
OK:
Voltage: 10 - 14 V
NG Check and repair harness and connector be-
tween theft deterrent ECU and battery (See page
IN-30).
OK
Check and replace theft deterrent ECU.