headlights TOYOTA AVALON 2018 Owners Manual (in English)

2
OVERVIEW
Instrument panel
Steering wheel controls
Audio control switches2Paddle shift switches
Telephone switches2
Voice command switch2
DISP switch
Dynamic Radar Cruise
Control (DRCC)
Vehicle-to-vehicle
distance switch
Tilt and telescopic steering
lock release lever
Blind Spot Monitor (BSM) main switch
1
Hood lock release lever
Rear sunshade switch1
Pre-Collision System (PCS) switch
VSC OFF switchTrunk opener Multi-Information Display (MID)Windshield wiper and washer switchEmergency flasher switch
Gauges and meters“ENGINE START STOP” switchLane Departure Alert
with Steering Assist
(LDA w/SA) switch
Dynamic Radar Cruise
Control (DRCC) switch or
Cruise control switch
Headlights, turn signals and
Automatic High Beam (AHB)
controls

14
FEATURES & OPERATIONS
Daytime Running Light system (DRL) Automatically turns on the headlights to make
vehicle more visible to other drivers. Not for use at night.
Automatic light cut off system When the headlights are on: Automatically turns lights off
after 30-second delay, or lock switch on remote may be pushed after locking. When the tail
lights are on, it automatically turns lights off when driver’s door is opened.
Right turn
Lane change
1
Lane change2
Left turn
1
The right hand signals will flash three times.
2
The left hand signals will flash three times.
Garage door openers manufactured under license from HomeLink
®* can be
programmed to operate garage doors, estate gates, security lighting, etc.
Refer to “Garage door opener,” Section 5-4 in the Owner’s Manual for more details.
For programming assistance, contact HomeLink
® at 1-800-355-3515, or visit http://
www.homelink.com.
* HomeLink® is a registered trademark of Johnson Controls, Inc.
Indicator light
Buttons Headlights
Parking lightsHigh beam
flasher
High beam Auto
OFFLow beam
Lights & turn signals
Garage door opener (HomeLink®) (if equipped)
HEADLIGHTS
TURN SIGNALS

33
OVERVIEW FEATURES & OPERATIONS TOYOTA SAFETY SENSE SAFETY & EMERGENCY FEATURES
AHB is a safety system designed to help drivers see more of what’s ahead at
nighttime without dazzling other drivers. When enabled, AHB uses an in-vehicle
camera to help detect the headlights of oncoming vehicles and tail lights of
preceding vehicles, then automatically switches between high and low beams
as appropriate to provide the most light possible and enhance forward visibility.
By using high beams more frequently, the system may allow earlier detection of
pedestrians and obstacles.
Refer to a Toyota Owner’s Manual for additional information on AHB operation,
settings adjustments, limitations, and precautions before attempting to use it.
Automatic High Beams (AHB)
(1) With the engine switch in IGNITION ON mode, turn the headlight switch to
“AUTO” position.
(2) Push lever away from you.
The AHB indicator will come on when the headlights are turned on automatically
to indicate that the system is active.
Note: Pull the lever back toward you to turn the AHB system off.
The AHB indicator will turn off. To turn switch to “
” position and the manual
high beam indicator “
” turns on.
When all of these conditions are met, high beams will be automatically turned on
(after approximately 1 second):
t7FIJDMFTQFFEJTBCPWFBQQSPYJNBUFMZNQI LNI

t5IFBSFBBIFBEPGUIFWFIJDMFJTEBSL
t5IFSFBSFOPPODPNJOHPSQSFDFEJOHWFIJDMFTXJUIIFBEMJHIUTPSUBJMMJHIUT
turned on.
t5IFSFBSFGFXTUSFFUMJHIUTPOUIFSPBEBIFBE
If any of these conditions occur, the system is designed to automatically turn off
high beams:
t7FIJDMFTQFFEESPQTCFMPXBQQSPYJNBUFMZNQI LNI

t5IFBSFBBIFBEPGUIFWFIJDMFJTOPUEBSL
t0ODPNJOHPSQSFDFEJOHWFIJDMFTIBWFIFBEMJHIUTPSUBJMMJHIUT
turned on.
t5IFSFBSFNBOZTUSFFUMJHIUTPOUIFSPBEBIFBE
"$5*7"5*/(5)&")#4:45&.
<00240030002f0025002a0035002a0030002f0034000300380029002600330026000300220029002300030038002a002d002d0003003500360033002f00030030002f001000300027002700030022003600350030002e00220035002a00240022002d002d00
3a0003>
(1) (2)