coolant reservoir TOYOTA AVENSIS 1999 Supplement

AC2AB–01
I12494
I12469
– AIR CONDITIONINGCOMPRESSOR AND MAGNETIC CLUTCH (1CD–FTV)
AC–27
REMOVAL
1. RUN ENGINE AT IDLE SPEED WITH A/C ON FOR
APPROX. 10 MINUTES WITH A/C ON
2. STOP ENGINE
3. DISCONNECT NEGATIVE (–) TERMINAL CABLE
FROM BATTERY
4. DISCHARGE REFRIGERANT FROM REFRIGERATION
SYSTEM
5. REMOVE ENGINE UNDER COVER RH
6. REMOVE DRIVE BELT
(See page AC–2)
7. DRAIN ENGINE COOLANT
8. REMOVE RESERVOIR TANK
(a) Remove the upper hose.
(b) Disconnect the lower hose.
(c) Disconnect the 2 bolts and reservoir tank.
9. DISCONNECT DISCHARGE AND SUCTION HOSES
Remove the 2 bolts and disconnect the both hoses.
NOTICE:
Cap the open fittings immediately to keep moisture or dirt
out of the system.
10. REMOVE COMPRESSOR
(a) Disconnect the connector.
(b) Remove the 3 bolts and compressor.

AC2AC–01
I12469
I12494
AC–28
– AIR CONDITIONINGCOMPRESSOR AND MAGNETIC CLUTCH (1CD–FTV)
INSTALLATION
1. INSTALL COMPRESSOR
(a) Install the compressor with the 3 bolts.
Torque: 25 N·m (250 kgf·cm, 18 ft·lbf)
(b) Connect the connector.
2. CONNECT DISCHARGE AND SUCTION HOSES
Connect the both hoses with the 2 bolts.
Torque: 10 N·m (100 kgf·cm, 7 ft·lbf)
CAUTION:
Hoses should be connected immediately after the caps
have removed.
HINT:
Lubricate 2 new O–rings with compressor oil and install the
hoses.
3. INSTALL RESERVOIR TANK
(a) Connect the reservoir tank with the 2 bolts.
(b) Connect the lower hose.
(c) Install the upper hose.
4. REFILL ENGINE COOLANT
5. INSTALL AND CHECK DRIVE BELT
(See page AC–3)
6. INSTALL ENGINE UNDER COVER RH
7. CONNECT NEGATIVE (–) TERMINAL CABLE TO BAT-
TERY
8. EVACUATE AIR IN REFRIGERATION SYSTEM AND
CHARGE WITH REFRIGERANT
Specified amount: 450
50 g (15.87
1.76 oz.)
9. INSPECT FOR LEAKAGE OF REFRIGERANT
Using a gas leak detector, check the tightening torque at the
joints.
10. INSPECT A/C OPERATION

AC2AG–01
I12494
AC–32
– AIR CONDITIONINGCONDENSER FAN (1CD–FTV)
REMOVAL
1. DRAIN ENGINE COOLANT
2. REMOVE RESERVOIR TANK
(a) Disconnect the upper hose.
(b) Disconnect the lower hose.
(c) Remove the 2 bolts and reservoir tank.
3. REMOVE CONDENSER FAN
(a) Disconnect the connector.
(b) Remove the 3 bolts and condenser fan.

AC2AJ–01
I12494
– AIR CONDITIONINGCONDENSER FAN (1CD–FTV)
AC–35
INSTALLATION
1. INSTALL CONDENSER FAN
(a) Install the fan with the 3 bolts.
(b) Connect the fan connector.
2. INSTALL RESERVOIR TANK
(a) Install the reservoir tank with the 2 bolts.
(b) Install the lower hose.
(c) Install the upper hose.
3. FILL ENGINE COOLANT