radiator TOYOTA AVENSIS 1999 Supplement


B02390
HEAT METHOD: When the problem seems to occur when the suspect area is heated. 2
NOTICE:3 WATER SPRINKLING METHOD:
(1)
(2)
4 OTHER: When a malfunction seems to occur when electrical load is excessive.When the malfunction seems to occur on a rainy day or in a
high–humidity condition. Heat the component that is the likely cause of the malfunction
with a hair dryer or similar object. Check to see if the malfunction
occurs.
Sprinkle water onto the vehicle and check to see if the malfunc-
tion occurs.
Turn on all electrical loads including the heater blower, head
lights, rear window defogger, etc. and check to see if the mal-
function occurs.ON HINT:
If a vehicle is subject to water leakage, the leaked water may
contaminate the ECU. When testing a vehicle with a water leak-
age problem, special caution must be taken.
Malfunc-
tion
Do not heat to more than 60 C (140 F). (Temperature
is limited not to damage the components.)
Do not apply heat directly to parts in the ECU. (1)
(2)
Never sprinkle water directly into the engine compart-
ment, but indirectly change the temperature and hu-
midity by applying water spray onto the radiator front
surface.
Never apply water directly onto the electronic compo-
nents. NOTICE: IN–24
– INTRODUCTIONHOW TO TROUBLESHOOT ECU CONTROLLED
SYSTEMS

D06629
D06639
A
B
D06633
D06636
B AA
D06634
– MANUAL TRANSAXLE (E251)MANUAL TRANSAXLE UNIT
MX–5
6. REMOVE STARTER
(a) Remove the 2 bolts and disconnect the radiator reservoir
from the radiator.
(b) Disconnect the starter connector.
(c) Remove the nut, and disconnect the starter wire.
Torque: 15 N·m (153 kgf·cm, 11 ft·lbf)
(d) Remove the 2 bolts and starter.
Torque: 39 N·m (400 kgf·cm, 29 ft·lbf)
7. DISCONNECT CLUTCH RELEASE CYLINDER AND
LINE
(a) Remove the 2 set bolts of the clutch line bracket.
Torque:
Bolt A: 12 N·m (120 kgf·cm, 9 ft·lbf)
Bolt B: 4.9 N·m (50 kgf·cm, 43 in.·lbf)
(b) Remove the 2 bolts and disconnect the release cylinder
and line.
Torque: 12 N·m (120 kgf·cm, 9 ft·lbf)
8. DISCONNECT GROUND CABLE
Remove the set bolt of the ground cable from the transaxle.
9. DISCONNECT VEHICLE SPEED SENSOR AND
BACK–UP LIGHT SWITCH CONNECTORS
10. DISCONNECT CONTROL CABLE
(a) Remove the 2 clips and washers.
(b) Remove the 2 clips from the cables.
11. REMOVE 4 TRANSAXLE UPPER SIDE MOUNTING
BOLTS
Torque:
Bolt A: 64 N·m (650 kgf·cm, 47 ft·lbf)
Bolt B: 29 N·m (296 kgf·cm, 21 ft·lbf)
12. INSTALL ENGINE SUPPORT FIXTURE
Install the engine hanger in the correct direction.
Parts No.:
Engine hanger: 12281–27010
Bolt: 96122–61020
Torque: 37 N·m (377 kgf·cm, 27 ft·lbf)