tire size TOYOTA AVENSIS 1999 Supplement

AB0163
Wire Harness
Diameter
Stripped Wire Harness Section
H03417
H03418
H03419
– SUPPLEMENTAL RESTRAINT SYSTEMSIDE AIRBAG ASSEMBLY
RS–15
(c) Using a service–purpose wire harness, tie down the side
airbag assembly.
Wire harness: Stripped wire harness section
1.25 mm
2
or more (0.0019 in2 or more)
HINT:
To calculate the square of the stripped wire harness section :
Square = 3.14 x (Diameter)
2 divided by 4
CAUTION:
If a wire harness which is too thin or some other thing is
used to tie down the side airbag assembly, it may be
snapped by the shock when the airbag is deployed. This is
highly dangerous. Always use a wire harness for vehicle
use which is at least 1.25 mm
2 (0.0019 in2).
(1) Install the 2 nuts in the side airbag assembly.
(2) Wind the wire harness around the stud bolts of the
side airbag assembly as shown in the illustration.
(3) Position the side airbag assembly inside the tire
with the airbag deployment direction facing inside.
Tire size : Must exceed the following dimensions:–
Width 185 mm (7.28 in.)
Inner diameter 360 mm (14.17 in.)
CAUTION:

Make sure the wire harness is tight. It is very danger-
ous when a loose wire harness results in the side air-
bag assembly coming free due to the shock from the
airbag deploying.

H11607
AB0158
SSTBattery
H11608
Tires
(5 or More)
R05403
– SUPPLEMENTAL RESTRAINT SYSTEMCURTAIN SHIELD AIRBAG ASSEMBLY
RS–29
(2) Position the inflater of curtain shield airbag inside
the tire with the airbag explosion direction facing in-
side.
Tire size : Must exceed the following dimensions:
Width 185 mm (7.28 in.)
Inner diameter 360 mm (14.17 in.)
CAUTION:

Make sure the wire harness is tight. It is very danger-
ous when a loose wire harness results in the curtain
shield airbag coming free due to the shock from the
airbag exploding.

Always tie down the curtain shield airbag with the ex-
plosion facing inside.
NOTICE:
The tire will be marked by the airbag explosion, so use the
redundant tire.
(c) Check functioning of the SST.
SST 09082–00700, 09082–00750
(d) Place the tires.
(1) Place at least 2 tires under the tire to which the cur-
tain shield airbag is tied.
(2) Place at least 2 tires over the tire to which the curtain
shield airbag is tied. The top tire should have the
wheel installed.
(3) Tie the tires together with 2 wire harnesses.
CAUTION:
Make sure that the wire harnesses are tight. It is very dan-
gerous when loose wire harnesses results in the tires com-
ing free due to the shock from the airbag exploding.
HINT:
Place the SST connector and wire harness inside tires. Secure
at least 1 m (3 ft) of slack for the wire harness.