tow bar TOYOTA AVENSIS 1999 Supplement

F02277
89.3 – 90.3 mm
(3.52 – 3.56 in.)
W01994
Vinyl Tape
SA–8
– SUSPENSION AND AXLEFRONT DRIVE SHAFT
(b) RH drive shaft:
Using a steel plate and press, install a new dust cover until
the distance from the tip of center drive shaft to the dust
cover reaches the specification, as shown in the illustra-
tion.
3. TEMPORARILY INSTALL NEW OUTBOARD AND IN-
BOARD JOINT BOOTS WITH NEW BOOT CLAMPS
HINT:
Before installing the boots (and dynamic damper), wrap
the spline of the outboard joint shaft with vinyl tape to pre-
vent them from being damaged.
Before installing the boots (and dynamic damper), place
new clamps to each of them and then install boots to drive
shaft.
(a) Temporarily install a new outboard joint boot with 2
clamps to the drive shaft.
(b) Temporarily install the dynamic damper with clamp to the
drive shaft.
(c) Temporarily install a new inboard joint boot with 2 clamps
to the drive shaft.
4. INSTALL TRIPOD
(a) Place the beveled side of the tripod axial spline toward the
outboard joint.
(b) Align the matchmarks placed before removal.
(c) Using a brass bar and hammer, tap in the tripod to the
drive shaft.
NOTICE:
Do not tap the roller.
(d) Using a snap ring expander, install a new snap ring.
5. INSTALL BOOT TO OUTBOARD JOINT
Before assembling the boot, pack the outboard joint shaft and
boot with grease in the boot kit.
Grease capacity: (Color = Black)
85 – 105 g (3.00 – 3.70 oz.)
6. INSTALL INBOARD JOINT SHAFT TO OUTBOARD
JOINT SHAFT
(a) Pack the inboard joint shaft and boot with grease in the
boot kit.
Grease capacity: (Color = Yellow)
120 – 130 g (4.23 – 4.59 oz.)
(b) Align the matchmarks placed before removal.
(c) Install the inboard joint shaft to the outboard joint shaft.
(d) Temporarily install the boot to the inboard joint shaft.