recommended oil TOYOTA CAMRY 2008 XV40 / 8.G Owners Manual

321
4-3. Do-it-yourself maintenance
4
Maintenance and care
Install the filler cap, turning it clockwise.
The approximate quantity of oil needed to raise the level between low and
full on the dipstick is indicated as follows:
2.4 L 4-cylinder (2AZ-FE) engine
1.2 qt. (1.1 L, 1.0 lmp. qt.)
3.5 L V6 (2GR-FE) engine
1.6 qt. (1.5 L, 1.3 lmp. qt.)
■ Recommended viscosity
2.4 L 4-cylinder (2AZ-FE) engine
5W-20 or 0W-20
*1: SAE 5W-20 or 0W-20 motor oilmay be used. However, SAE
0W-20 is the best choice for
fuel economy, and good start-
ing in cold weather.
3.5 L V6 (2GR-FE) engine
SAE 5W-30 is the best choice for
good fuel economy, and good
starting in cold weather.
*2: If SAE 5W-30 oil is not avail-able, SAE 10W-30 oil may be
used. However, it should be
replaced with SAE 5W-30 at
the next oil change.
STEP3
Outside temperature
*1
*2
Outside temperature

431
6-1. Specifications
6
Vehicle specifications
Lubrication system
Oil capacity
(drain and refill)
With filter
Without filter 2.4 L 4-cylinder (2AZ-FE) engine
4.5 qt. (4.3 L, 3.8 Imp.qt.)
3.5 L V6 (2GR-FE) engine
6.4 qt. (6.1 L, 5.4 Imp.qt.)
2.4 L 4-cylinder (2AZ-FE) engine
4.3 qt. (4.1 L, 3.6 Imp.qt.)
3.5 L V6 (2GR-FE) engine
6.0 qt. (5.7 L, 5.0 Imp.qt.)
Oil grade
ILSAC multi-grade engine oil
Recommended oil
viscosity Use Toyota approved “Toyota Genuine Motor
Oil” or equivalent to satisfy the grade and vis-
cosity shown below.
2.4 L 4-cylinder (2AZ-FE) engine
3.5 L V6 (2GR-FE) engineOutside temperature
*1
Outside temperature
*2

434 6-1. Specifications
Electrical system
Manual transaxle
Automatic transaxle
*: The fluid capacity is a reference quantity. If replacement is neces-
sary, contact your Toyota dealer.
Battery
Open voltage at
68 F (20 C): 12.6  12.8 V Fully charged
12.2  12.4 V Half charged
11 . 8
 12.0 V Discharged
(Voltage checked 20 minutes after the
engine and all the lights turned off)
Charging rates 5 A max.
Gear oil capacity (Reference) 2.6 qt. (2.5 L, 2.2 Imp.qt.)
Gear oil type API GL-4 or 5
Recommended gear oil
viscosity SAE 75W-90
Fluid capacity
(drain and refill)2.4 L 4-cylinder (2AZ-FE) engine:
3.7 qt. (3.5 L, 3.1 Imp.qt.)
Fluid capacity
3.5 L V6 (2GR-FE) engine:
6.76 qt. (6.4 L, 5.63 Imp.qt.)*
Fluid type
Toyota Genuine ATF WS

448 6-1. Specifications
Warning: The temperature grades of a tire assume that it is properly
inflated and not overloaded.
Excessive speed, underinflation, or excessive loading, either sepa-
rately or in combination, can cause heat buildup and possible tire fail-
ure.
Glossary of tire terminology
Tire related termMeaning
Cold tire inflation pres-
sure Tire pressure when the vehicle has been
parked for three hours or more, or has not
been driven more than 1 mile or 1.5 km under
that condition
Maximum inflation
pressure The maximum cold inflated
pressure to which a
tire may be inflated, s hown on the sidewall of
the tire
Recommended infla-
tion pressure Cold tire inflation pressure recommended by a
manufacturer
Accessory weight The combined weight (in excess of those stan-
dard items which may be replaced) of auto-
matic transmission, power steering, power
brakes, power windows, power seats, radio
and heater, to the extent that these items are
available as factory-installed equipment
(whether installed or not)
Curb weight The weight of a motor vehicle with standard
equipment, including the maximum capacity of
fuel, oil and coolant, and if so equipped, air
conditioning and additional weight optional
engine
Maximum loaded vehi-
cle weight The sum of:
(a) Curb weight
(b) Accessory weight
(c) Vehicle capacity weight
(d) Production options weight

476
GAS STATION INFORMATION
Auxiliary catch leverP. 313Trunk openerP. 4 6Fuel filler door P. 7 3
Hood lock release lever
P. 3 1 3
Fuel filler door opener P. 7 3Tire inflation pressure
P. 436
Fuel tank capacity 18.5 gal. (70 L, 15.4 lmp.gal.)
Fuel type Unleaded gasoline only P. 74, 430
Cold tire inflation pressure P. 436
Engine oil
capacity
(Drain and refill)
2.4 L 4-cyl-
inder (2AZ-
FE) engineqt. (L, lmp.qt)
With filter 4.5 (4.3, 3.8)
Without filter 4.3 (4.1, 3.6)
3.5 L V6
(2GR-FE)
engine With filter 6.4 (6.1, 5.4)
Without filter 6.0 (5.7, 5.0)
Engine oil type Toyota Genuine Motor Oil or equivalent
Oil grade: ILSAC multigrade engine oil
P. 4 3 1
Recommended oil viscosity:
SAE 5W-20 or 0W-20 (2.4 L 4-cylinder
[2AZ-FE] engine) SAE 5W-30 (3.5 L V6
[2GR-FE] engine)