ignition TOYOTA CAMRY 2017 XV50 / 9.G Quick Reference Guide
[x] Cancel search | Manufacturer: TOYOTA, Model Year: 2017, Model line: CAMRY, Model: TOYOTA CAMRY 2017 XV50 / 9.GPages: 23, PDF Size: 4.06 MB
Page 3 of 23

Steering wheel controls
FEATURES/OPERATIONS
23
Instrument panel
OVERVIEW
1 If equipped.2 For vehicles with Entune Premium Audio or Entune Audio Plus, refer to th\
e 
“Navigation System Owner’s Manual” and “2017 Entune™ Audi\
o Quick 
Reference Guide.”
Meter control  switches
Air conditioning controls
Emergency flasher button
Wiper and washer controls
Seat heater controls1
Tire Pressure Monitoring (warning) System 
(TPMS) reset switch1
Outside rearview mirror/
Rear window defogger button
Headlight and turn signal controls/
Headlight, turn signal and front DRL 
(Daytime Running Light)
 controls1
Lane Departure Alert (LDA) switch1
Blind Spot Monitor (BSM) main switch1
VSC OFF switch
Pre-Collison System (PCS) switch1
Tilt and telescopic 
steering lock release
Key ignition1
“ENGINE START STOP”  button (Smart Key)1Audio system1/
Navigation system1,2
Telephone controls2
Voice command button2
Dynamic Radar Cruise Control 
(DRCC) Vehicle-to-vehicle 
distance button
1
Cruise control
Paddle shift levers1
Steering wheel 
audio controls2
See ‘Air conditioning/heating’ section 
of this book for more details about  your unit. 
OVERVIEW
SAFETY AND EMERGENCY FEATURES  
Page 7 of 23

1011
* The “ENGINE START STOP”/ignition switch must be “ON” and t\
he brake pedal 
depressed to shift from Park.
Auto lock/unlockSteering lock release
Tilt and telescopic steering wheel
Parking brake
Automatic door locks can be programmed to operate in four different mode\
s, or 
turned OFF.
-Doors lock when shifting from Park.
-Doors lock when the vehicle speed goes above approximately 12 mph.
-Doors unlock when shifting into Park.
Vehicles without Smart Key system
-Doors unlock when the ignition switch is set from “ON” to “ACC\
” or “LOCK” and 
driver’s door is opened.
Vehicles with Smart Key system
-Doors unlock when the “ENGINE START STOP” switch is set to OFF an\
d driver’s 
door is opened.
Refer to the Owner’s Manual for more details. 
Park*
Reverse
Neutral
Drive
N
“S” mode
+ (“S” mode)
- (“S” mode)
- (“S” mode)+ (“S” mode)
Paddle shift switches
(if equipped)Shift lever
Automatic transmission
FEATURES/OPERATIONS
“S” SEQUENTIAL MODE
Shift the shift lever to “S” position from “D” position.
  + :   Upshifting
 
   - :   Downshifting
Downshifting increases power going uphill, or provides engine braking do\
wnhill. For 
best fuel economy during normal driving conditions, always drive with th\
e shift lever 
in the “D” position.
Turn
Smart Key system Without Smart Key system
Push
Set: Depress
Release: Depress again
NOTE: Do not attempt to adjust while the vehicle is in motion. Hold wheel, push lever down, set angle and length, and return lever.
Lock release
lever Angle
Length
Turn
OVERVIEW
FEATURES/OPERATIONS
SAFETY AND EMERGENCY FEATURES  
Page 9 of 23

1415
HEADLIGHTS
TURN SIGNALS
Right turn
Lane change1
Lane change2
Left turn
Windshield wipers & washersLights & turn signals
Power outlets-12V DC
Clock
FEATURES/OPERATIONS
Front console
The “ENGINE START STOP” switch/ignition switch must be in the “\
ACC” or “ON” 
position for use.Center console
Adjust frequency* Pull to wash and wipeMist
Interval wipe
Slow
Fast
* Intermittent windshield wiper frequency adjustment Rotate to increase/
decrease wipe frequency.
High beam
- Daytime Running Light system (DRL) Automatically turns on the headlights at 
a reduced intensity.
-  Automatic light cut off system  Automatically turns lights off after 30-second 
delay, or lock switch on remote may be pushed after locking.
High beam 
flasher
Parking lights
DRL OFF
Low beam
Headlights
1  The right hand signals will flash three times.2  The left hand signals will flash three times.
To find your system, refer to the Audio section in this guide.
For Entune
™ Audio
Push “SETUP” button next to the screen 
then select “General” in the touch screen to access clock setting.
For Entune
™ Audio Plus and Entune™ Premium Audio
Push “APPS” button next to the screen 
then select “General” in the touch screen to access clock setting.
OVERVIEW
FEATURES/OPERATIONS
SAFETY AND EMERGENCY FEATURES