warning TOYOTA CAMRY 2020 Owners Manual (in English)
[x] Cancel search | Manufacturer: TOYOTA, Model Year: 2020, Model line: CAMRY, Model: TOYOTA CAMRY 2020Pages: 52, PDF Size: 2.03 MB
Page 6 of 52
4
For details, refer to “Indicators and warning lights,” Section 2, 2020 Owner’s
Manual.
Airbag SRS warning1
OVERVIEW
Instrument cluster
Automatic High Beam (AHB)
indicator1
Blind Spot Monitor (BSM)
indicator4
Anti-lock Brake System (ABS)
warning1
AIRBAG ON/OFF indicator Type A1
AIRBAG ON/OFF indicator Type B1
Indicator symbols
TachometerTachometerOutside temperature
Outside temperatureSpeedometer
Speedometer Odometer/trip meter
Odometer/trip meter Shift position
Shift positionFuel gauge
Fuel gauge Multi-information display
Multi-information display Engine coolant temperature display
Engine coolant temperature displayInstrument panel light control
Instrument panel light control
Service indicators and reminders
4.2-inch display
7-inch display
Page 7 of 52
5
Full-Speed Dynamic Radar Cruise
Control (DRCC) indicator/DRCC
SET indicator
Brake system warning1
Malfunction/
Check Engine indicator1
Driver’s and front passenger’s seat belt
reminder (alarm will sound when the
engine switch is “ON” position*/
”IGNITION ON”** mode)
Low Tire Pressure Warning1
Low fuel level warning
Security indicator
Fuel tank door positionMaster warning
1,2
Headlight low/high
beam indicators
Turn signal indicator
Pre-Collision System (PCS)
warning light1,2
Slip indicator1,3
Vehicle Stability Control OFF
indicator1
Eco driving indicator1
Parking brake indicator2
Rear passenger seat belt reminder
indicator Type A
Rear passenger seat belt reminder
indicator Type B
Brake hold operated indicator1,2,4
Brake hold standby indicator1
BSM w/Rear Cross Traffic Alert
(RCTA) Indicator4
BSM outside rear view mirror
indicators4
Brake system warning
(yellow indicator)1,4
Lane Departure Alert (LDA) indicator
(white/green/yellow3)
Electric power steering warning1
(red/yellow indicator)
Sport mode driving indicator4
ECO MODE indicator4
Low outside temperature indicator
Constant speed cruise control
indicator/Constant speed
cruise control SET indicator
1
If the indicator does not turn off within a few seconds of starting the engine, there may be a
malfunction. Have the vehicle inspected by your Toyota dealer.
2 If the indicator flashes, there may be a malfunction. Refer to the Owner’s Manual.3 If the indicator flashes, it indicates that the system is operating.4 If equipped.
OVERVIEW FEATURES & OPERATIONS TOYOTA SAFETY SENSE SAFETY & EMERGENCY FEATURES
* Vehicles without a Smart Key system
** Vehicles with a Smart Key system
Page 22 of 52
20
FEATURES & OPERATIONS
Multi-Information Display (MID)
w % * 4 1 - " : * ' & 2 6 * 1 1 & %
w % * 4 1 - " : * ' & 2 6 * 1 1 & %
Push “meter control switches” to change information in the following:
Push “meter control switches” to change information in the following:
Refer to the Owner’s Manual for more details.Drive information
Warning messages
Warning messages
Audio system-linked display
Audio system-linked display
Eco-friendly driving information
Settings display
Vehicle information
Driving assist system information
Driving assist system informationSettings display
Indicators
Menu icons
Shift position Outside temperatureSpeed limit display
(with navigation system)
Clock Full-Speed DRCC and
Lane Departure Alert display
Previous screen
Previous screen
Speedometer IndicatorsDisplay area Menu icons Shift position
Indicators
Enter/Select
Enter/Select
Scroll/search
screens
Scroll/search
screens
Odometer/trip
meter control
“ODO/TRIP” switch
Odometer/trip meter display
Display area Odometer/trip
meter control
display
Page 33 of 52
31
The Pre-Collision System uses a radar sensor and camera sensor to help detect a
vehicle or pedestrian in front of your vehicle.
As there is a limit to the degree of recognition accuracy and control performance
that this system can provide, do not overly rely on this system. This system will not
prevent collisions or lessen collision damage or injury in every situation. Do not use
PCS instead of normal braking operations under any circumstances. Do not attempt
to test the operation of the pre-collision system yourself, as the system may not
operate or engage, possibly leading to an accident. In some situations, such as
when driving in inclement weather such as heavy rain, fog, snow or a sandstorm or
while driving on a curve and for a few seconds after driving on a curve, a vehicle or
pedestrian may not be detected by the radar and camera sensors, preventing the
system from operating or engaging properly.
Refer to the Toyota Owner’s Manual for a list of additional situations in which the
system may not operate properly.
Refer to the Toyota Owner’s Manual for additional information on PCS w/PD
operation, settings adjustments, limitations, and precautions before attempting to
use it. Pre-Collision Warning
When the system determines that the possibility of a frontal collision is high, a
buzzer will sound and a warning message will be displayed on the Multi-Information
% J T Q M B Z . * %
U P V S H F U I F E S J W F S U P U B L F F W B T J W F B D U J P O
Pre-Collision Brake Assist
If the driver notices the hazard and brakes, the system may provide additional
braking force using Brake Assist. This system may prime the brakes and may apply
greater braking force in relation to how strongly the brake pedal is depressed.
Pre-Collision Braking
If the driver does not brake in a set time and the system determines that the
possibility of a frontal collision with a preceding vehicle is extremely high, the
system may automatically apply the brakes, reducing speed in order to help the
driver reduce the impact and in certain cases avoid the collision.
Pre-Collision System with Pedestrian
Detection (PCS w/PD)
OVERVIEW FEATURES & OPERATIONS TOYOTA SAFETY SENSE SAFETY & EMERGENCY FEATURES
Page 34 of 52
32
TOYOTA SAFETY SENSE™
CHANGING PCS ALERT TIMING
FarMiddle
(default)
Near
1 S F T T i” switches and select or from the Multi-Information Display
. * %
1 S F T T i
” switches and select “Warning sensitivity” from the MID and then
press “
”. The setting screen is displayed.
1 S F T T i
” each time to change the setting. Each time it is pressed, the
response to the PCS alert timing changes as shown above. You can press “
” to
go back to the menu.
Note: PCS is enabled each time the engine switch is turned to Ignition On.
The system can be disabled/enabled and the alert timing of the system can be
changed. (Alert timing only, brake operation remains the same).
Monocular camera sensor
Millimeter
wave radar
As part of the Pre-Collision System, this function is also designed to first provide an
alert and then automatic braking if needed.
Refer to the Toyota Owner’s Manual for additional limitations and information.Under certain conditions, the PCS system included with the TSS-P package may
also help to detect a pedestrian in front of your vehicle using the in-vehicle camera
and front grille-mounted radar. The in-vehicle camera of PCS detects a potential
pedestrian based on size, profile, and motion of the detected pedestrian. However,
a pedestrian may not be detected depending on the conditions, including the
surrounding brightness and the motion, posture, size, and angle of the potential
detected pedestrian, preventing the system from operating or engaging.
PCS PEDESTRIAN DETECTION
Page 38 of 52
36
TOYOTA SAFETY SENSE™
SWAY WARNING SYSTEM
SWS is a function of LDA and is designed to detect swaying based on the vehicle
location in the lane and the driver’s steering wheel operation. To help prevent
swaying, the system alerts the driver using a buzzer sound and a warning displays
in the MID.
Continuous lane deviations from
swaying.
Gentle swaying from driver’s
inattentiveness.
Acute steering wheel operation after the
number of operations decrease due to driver’s
inattentiveness.
1 S F T T i” switches and select or from the Multi-Information Display
. * %
1 S F T T i
” switches and select the “Sway sensitivity” setting function and then
press “
.”
1 S F T T i
” each time to change the setting.
1 S F T T i
” to go back to the menu.
1 S F T T i
” switches and select or from the Multi-Information Display
. * %
1 S F T T i
” switches and select the “Sway warning” setting function and then
press “
.”
1 S F T T i
” each time to change the setting.
1 S F T T i
” to go back to the menu.
Note: Operation of the LDA system and setting adjustments continues in the
same condition regardless of Ignition cycle until changed by the driver or the
system is reset.
ADJUSTING SWAY ALERT SENSITIVITY
DISABLING LDA SWAY WARNING SYSTEM
Page 40 of 52
38
TOYOTA SAFETY SENSE™
ADJUSTING DISTANCE
To change the vehicle-to-
vehicle distance
Push the “
” button
to cycle through the
settings, which will change
progressively.
This mode employs a radar sensor to detect the presence of a preceding vehicle
V Q U P B Q Q S P Y J N B U F M Z G U N
B I F B E
E F U F S N J O F T U I F D V S S F O U W F I J D M F U P W F I J D M F
following distance and operates to maintain a preset following distance from the
vehicle ahead. These distances vary based on vehicle speed.
(1) (2) (3)
Constant speed cruising when there are no vehicles ahead
The vehicle travels at the speed set by the driver. The desired vehicle-to-
vehicle distance can also be set by operating the vehicle-to-vehicle distance
control.
Deceleration cruising and follow-up cruising when a preceding vehicle
driving slower than the set speed appears
When a vehicle is detected running ahead of you, the system automatically
decelerates your vehicle. When a greater reduction in vehicle speed is
O F D F T T B S Z
U I F T Z T U F N B Q Q M J F T U I F C S B L F T U I F C S B L F M J H I U T X J M M D P N F P O B U U I J T
U J N F
5 I F T Z T U F N X J M M S F T Q P O E U P D I B O H F T J O U I F T Q F F E P G U I F W F I J D M F B I F B E
in order to maintain the vehicle-to-vehicle distance set by the driver. A warning
tone warns you when the system cannot decelerate sufficiently to prevent your
vehicle from closing in on the vehicle ahead. Note: Vehicle-to-vehicle distance will close in when traveling on long downhill
slopes.
LONG
(default setting)MIDDLE SHORT
Preceding
vehicle mark
Page 44 of 52
42
SAFETY & EMERGENCY FEATURES
Safety Connect® (if equipped)
Tire Pressure Monitoring (warning) System (TPMS)
The tire pressure detected by the tire pressure warning system can
C F E J T Q M B Z F E P O U I F N V M U J J O G P S N B U J P O E J T Q M B Z . * %
Refer to the load label on the door jamb or the Owner’s Manual for tire inflation
specifications.
If the tire pressure indicator flashes for more than 60 seconds and then remains on,
take the vehicle to your local Toyota dealer.
NOTE: The warning light may come on due to temperature changes or
changes in tire pressure from natural air leakage. If the system has not been
initialized recently, setting the tire pressures to factory specifications should
turn off the light.
The tire pressure warning system can be selected on “” of the multi-
J O G P S N B U J P O E J T Q M B Z . * %
System rest initialization
4 F M F D U “Vehicle Settings” and then push “” J O D I E J T Q M B Z
“” and then
push and hold “
w J O D I E J T Q M B Z
4 F M F D U i 5 1 8 4 w B O E U I F O Q V T I i
”.
4 F M F D U i 4 F U 1 S F T T V S F w U I F O Q V T I B O E I P M E i
” until the warning light blinks
three times.
Safety Connect is a subscription-based telematics service that uses Global
1 P T J U J P O J O H 4 Z T U F N ( 1 4
E B U B B O E F N C F E E F E D F M M V M B S U F D I O P M P H Z U P Q S P W J E F T B G F U Z
and security features to subscribers. Safety Connect is staffed with live agents at
the Toyota response center, which operates 24 hours per day, 7 days per week.
Services for subscribers include:
• Automatic collision notification
• Stolen vehicle locator
t & N F S H F O D Z B T T J T U B O D F i 4 0 4 w C V U U P O
• Enhanced roadside assistance
For additional information refer to the “Owner’s Manual” or visit www.Toyota.com/
connected-services.
Microphone
LED Indicators“SOS” button
4.2-inch display 7-inch display