ECO mode TOYOTA CAMRY HYBRID 2007 XV40 / 8.G Owners Manual

’07Camry hybrid_U (L/O 0610)
3
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
Navigation system indicators (models with
navigation system only)
1. Transition of fuel consumption in thepast 30 minutes (“Consumption”):
See “Trip information (with navigation
system)” in Section 1 −10 on page 255.
2. Best fuel economy (lowest fuel con- sumption) among average (“Best”):
See “Trip information (with navigation
system)” in Section 1 −10 on page 255.
3. Average fuel consumption (“Average”): See “Trip information (with navigation
system)” in Section 1 −10 on page 255. Toyota hybrid system performs various
controls depending on the operating
condition. The condition appears on the
multiinformation display and/or naviga-
tion system screen (with navigation
system) when the display and/or screen
is in “Energy Monitor” mode. See
“—Outside temperature and cruise in-
formation” on page 135 in Section 16
and “Trip information” on page 255 in
Section 110 for the operation of the
display and screen.
These are representative examples of
energy monitor displays. Depending on
the condition, the energy monitor dis-
plays the graphics different from those
shown below. Depending on conditions,
the graphic does not reflect the actual
motion of the vehicle.
Multi
−information display
Navigation system screen
When the vehicle is powered only by
the traction motor.
Energy monitor—

’07Camry hybrid_U (L/O 0610)
15
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
1. Headlight and turn signal switches
2. Wiper and washer switches
3. Engine immobilizer system indicatorlight
4. Clock
5. “AIRBAG ON” and “AIRBAG OFF” indicator lights and front passenger
seat belt reminder light
6. Emergency flasher switch
7. Audio system or navigation system including audio system (For the
navigation system, see the separate
“Navigation System Owner ’s Manual”.)
8. Air conditioning controls
9. Tire pressure warning system reset switch
10. Rear window and outside rear view mirror defogger switch
11. AUX adapter
12. Power outlet
13. Auxiliary boxes
14. “POWER” switch
15. Air conditioning economy mode switch
16. Fuel filler door opener switch
17. Power rear view mirror control switches

’07Camry hybrid_U (L/O 0610)
38
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
DISABLING THE SMART KEY SYSTEM
The following functions can be disabled:
A function that allows you to lock/un-
lock the doors and open the trunk by
simply carrying a key
A function that causes the vehicle to
beep if keys are forgotten inside the
vehicle or trunk and a door is closed
A function that recalls the position of
the driver ’s seat and side rear view
mirror
A function that shifts the power supply
mode and starts the hybrid system
when the electronic key is in the ve-
hicle.
Warning lights and buzzers
For details, contact your Toyota dealer.
If the smart key system does not oper-
ate properly because of a system mal-
function, consult your Toyota dealer.
Make sure to bring all of the keys. They
may be necessary to repair the system. When you carry the registered key with
smart key system into the actuation area,
you can lock and unlock the side doors
without using the key. For further informa-
tion of actuation area, see “Smart key
system” on page 32 in this Section.
Locking operation
Push the lock button on the front out-
side door handle slowly and firmly. All
the doors lock simultaneously. At this
time one beep will be heard and turn
signal lights flash once.
For three seconds after the doors have
been locked, the doors cannot be un-
locked via the smart key system. This
feature allows the operator to confirm that
the doors are locked.
In the following cases, the doors cannot
be locked by pushing the lock button and
a beep will sound as an indicator.
Side doors—
—Locking and unlocking with
smart key system

’07Camry hybrid_U (L/O 0610)
40
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
SELECTING DOORS TO BE UNLOCKED
WITH ENTRY FUNCTION
The unlocking operation has 2 modes.
To change the mode, within 1 m (3 ft.)
of the vehicle press the lock switch and
the alarm, trunk opener or unlock
switch simultaneously for five seconds.
The “POWER” switch must be turned off.
When the mode is changed, the buzzer
will sound and an indicator is displayed on
the multi−information display as follows: Mode
Door to be
unlocked
Wirelessremotecontrol
buzzerIndicator
and meter buzzer
1All doors2 beeps
1 beep
2
Driver ’s
door only
(from
driver ’s
door
switch)
All doors
(from front
passenger ’
s door
switches)
3 beeps
1 beep
Repeating the above process allows you
to toggle between 1 and 2.
Move the lock knob.
To lock: Push the knob forward.
To unlock: Pull the knob backward.
The front doors can be opened by pulling
the inside handle even if the lock knobs
are in the locked position.
CAUTION
Do not pull the inside handle of the
front doors while driving. The doors
will open and an accident may occur.
Toyota strongly recommends that all
children be placed in the rear seat of
the vehicle.
—Locking and unlocking with
inside lock knob

’07Camry hybrid_U (L/O 0610)
133
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
When the needle is in the blue zone, the
coolant temperature is cold. Heat may not
be available while the coolant temperature
is the blue zone.
Your vehicle may overheat during severe
operating conditions, such as:
Driving up a long hill on a hot day.
Reducing speed or stopping after high
speed driving.
Idling for a long period with the air
conditioning on in stop−and− go traffic.
NOTICE
Do not remove the thermostat in
the engine cooling system as this
may cause the engine to overheat.
The thermostat is designed to con-
trol the flow of coolant to keep the
temperature of the engine within
the specified operating range.
 Do not continue driving with an
overheated engine. See “If your ve-
hicle overheats” on page 317 in
Section 4.The fuel economy meter indicates the
current fuel consumption in analog
form when the engine is running. When
only the traction motor powers the ve-
hicle, the needle indicates “E MODE”.
The needle may indicate the best rate
on the meter when the engine is run-
ning but the fuel is not consumed.
The needle may indicate the best rate
on the meter when fuel consumption is
less than the indicated value.
The needle may indicate the worst rate
on the meter when fuel consumption is
more than the indicated value.
Fuel economy meter

’07Camry hybrid_U (L/O 0610)
135
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
Each time you push the “DISP” button,
the display toggles through the follow-
ing information.1. Outside temperature
2. Cruising range
3. Average fuel consumption after refuel- ing
4. Driving distance
5. Average vehicle speed
6. Cruise information off
7. Zoom display of odometer and trip me- ter
8. Energy monitor
9. Eco drive level
The display will return to the outside tem-
perature display with pushing and holding
the “DISP” button for 1 second.
The displayed values in the cruise infor-
mation display indicate general driving
conditions. Accuracy varies with driving
habits and road conditions.
When the “POWER” switch is set at ON,
the last previously used mode displayed
just before the “POWER” switch is turned
off will appear.
—Outside temperature and cruise information

’07Camry hybrid_U (L/O 0610)
148
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
(s)
This message is to remind the driver to
change the engine oil.
Change the engine oil as soon as pos-
sible.
If the driving range after the previous oil
change reaches 8000 km (5000 miles), the
message appears with the master warning
light and a warning tone sounds. The
message stays on with the “POWER”
switch set at ON.
The engine oil maintenance data must be
reset after the engine oil change. See
“Resetting the engine oil maintenance
data” below for the procedure to reset the
system.Resetting the engine oil maintenance
data
The engine oil maintenance data must be
reset after replacement of the engine oil.
Reset the data by the following procedure:
1. Turn off the hybrid system with the trip meter A reading shown.
For details, see “—Odometer and two trip
meters” on page 138 in this Section. 2. The “POWER” switch must be set at ON while holding down the trip meter
reset knob. A message “OIL MILEAGE
RESET MODE” will appear on the dis-
play.
3. Hold down the knob at least 5 sec- onds. A message “COMPLETE” will ap-
pear and the message “OIL MILEAGE
RESET MODE” goes off. (t)This message appears when the washer
fluid level becomes very low.
Fill the tank as soon as possible.
The message appears with the master
warning light a warning tone sounds.
(u)
This message appears when the driver ’s
door is opened with the “POWER”
switch turned off and the moon roof
opened.
When you leave your vehicle, be sure to
close the moon roof.
The message appears with the master
warning light and a warning tone sounds.

’07Camry hybrid_U (L/O 0610)
160
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
When the key is in the vehicle, press-
ing the “POWER” switch (hybrid system
startup switch) allows you to start and
stop the hybrid system or choose at
the ACC, ON, or “POWER” switch off.
When the brake pedal is not depressed,
pressing the “POWER” switch changes the
mode as follows. Press the switch slowly
and firmly.First time—ACC (accessory) mode (
illu-
minates amber)
Accessories such as the radio operate.
Second time—ON mode (illuminates am-
ber)
All accessories on.
Third time—Power off (indicator light
off)
Pressing the “POWER” switch again re-
turns the mode switch to ACC.If a buzzer sounds and the master warn-
ing light comes on for 5 seconds when
pressing the “POWER” switch, this indi-
cates that the key is not in the vehicle.
The message “KEY IS NOT DETECTED”
will also appear on the multi −information
display.
If the brake pedal is depressed, the in-
dicator light will turn green, regardless
of which mode is selected. When the
indicator light is green, pressing the
“POWER” switch once turns the hybrid
system on. (For starting tips, see “How
to start the hybrid system” on page 301
in Section 3.)
“POWER” switch

’07Camry hybrid_U (L/O 0610)
161
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
When the “POWER” switch is changed
from ON (with the hybrid system turned
off) to off and then changed to ACC,
“DEPRESS THE BRAKE PEDAL” will
appear on the multi−information display.
If the amber indicator light on the
“POWER” switch blinks, this indicates a
malfunction of the push start system. Turn
off the hybrid system immediately and
contact your Toyota dealer.
Approximately five hours after the hybrid
system is turned off, you may hear s ound
coming from underneath the trunk for sev-
eral minutes. This is normal operation and
does not indicate a malfunction. (See
“Leak detection pump” on page ix.)
It is not a malfunction if the needle on all
meters and gauges move slightly when the
“POWER” switch is set at ACC, ON or
when the hybrid system is turned on.
NOTICE
Do not leave the “POWER” switch at
ACC or ON with the hybrid system
turned off. The 12 volt battery will
discharge.
When the 12 volt battery is discon-
nected or run down, the push button
start function memorizes the current
mode. After you reconnect, replace, or re-
charge the battery, the memorized mode
is selected automatically. In any of these
cases, turn off the hybrid system if the
hybrid system is turned on.

’07Camry hybrid_U (L/O 0610)
166
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
“ABS” warning light
When the “POWER” switch is set at
ON, the “ABS” warning light comes on.
It will go off when the “READY” light
comes on. If the “ABS” warning light
does not come on when the “POWER”
switch is set at ON, contact your
Toyota dealer.
If the “ABS” warning light remains on
after the “POWER” switch is set at ON
or if it comes on while driving, the
antilock brake system function may
not operate properly. Although the
brake system operates without the func-
tion, drive carefully and have your ve-
hicle checked by a Toyota dealer as
soon as possible. For details, see “Ser-
vice reminder indicators and warning
buzzers” on page 150 in Section 16.
Message “CHECK VSC SYSTEM”
If “CHECK VSC SYSTEM” appears on
the multiinformation display, the trac-
tion control and vehicle stability control
functions may not operate properly. Al-
though the brake system operates nor-
mally without these functions, drive
carefully and have your vehicle checked
by a Toyota dealer as soon as possible.
For details, see “—Messages” on page
140 in Section 16.BRAKE ASSIST FUNCTION
The brake assist function is designed to
assist with emergency braking. When the
driver suddenly depresses the brake ped-
al, the device treats it as emergency brak-
ing and adds braking force.
If you slam the brakes on or apply the
brakes more firmly, more powerful braking
will be applied.
CAUTION
The brake assist function is not de-
signed to shorten braking distance.
Always drive at a moderate speed and
maintain a safe distance from the ve-
hicle in front of you. Depending on
road conditions, braking distance may
be longer than that of a vehicle with-
out the brake assist device. If tire
chains are used, braking distance
may become longer.