odometer TOYOTA CAMRY HYBRID 2007 XV40 / 8.G Owners Manual

’07Camry hybrid_U (L/O 0610)
134
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
The following information is displayed
on the multiinformation display when
the “POWER” switch is set at ON.
Outside temperature and cruise in-
formation
Odometer and two trip meters
Messages
During ordinary driving, the information is
displayed. However, in case the vehicle
has a system malfunction or if there is
some information that the driver should be
informed of, a message appears on the
display. See “—Messages” on page 140
for details.
If the electrical power source has been
disconnected from the cruise information
display, the display will automatically be
set to the initial mode.
When the instrument panel lights are
turned on, the brightness of the display
will be reduced.
At extremely low temperatures, the mul-
ti −information display may respond slow-
ly.
CAUTION
Do not adjust the display while the
vehicle is moving. Be sure to adjust
the display only when the vehicle is
stopped.
Multiinformation display—

’07Camry hybrid_U (L/O 0610)
135
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
Each time you push the “DISP” button,
the display toggles through the follow-
ing information.1. Outside temperature
2. Cruising range
3. Average fuel consumption after refuel- ing
4. Driving distance
5. Average vehicle speed
6. Cruise information off
7. Zoom display of odometer and trip me- ter
8. Energy monitor
9. Eco drive level
The display will return to the outside tem-
perature display with pushing and holding
the “DISP” button for 1 second.
The displayed values in the cruise infor-
mation display indicate general driving
conditions. Accuracy varies with driving
habits and road conditions.
When the “POWER” switch is set at ON,
the last previously used mode displayed
just before the “POWER” switch is turned
off will appear.
—Outside temperature and cruise information

’07Camry hybrid_U (L/O 0610)
137
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
6. Cruise information off
The display indicates only odometer and
two trip meters.
7. Zoom display of odometer and trip meter
The odometer and one of the trip meters
are displayed simultaneously. See
“—Odometer and two trip meters” de-
scribed below. 8. Energy monitor
The operating condition of the hybrid
system appears on the display.
See “Energy monitor” on page 3 for de-
tails.
9. Eco drive level
The eco drive level is visually displayed
on the multiinformation display, and it
indicates the average fuel consumption
after the hybrid system is turned on. In
accordance with the average fuel con-
sumption, the levels are displayed as
follows:
Level 0—25 MPG or less or 9.0 L/100 km or more
Level 1—26 to 30 MPG or 8.8 to 8.0 L/100 km
Level 2—31 to 35 MPG or
7.8 to 7.0 L/100 km
Level 3—36 MPG or more or 6.8 L/100 km or lessThe brightness of the arcs around the fuel
economy meter and speedometer change
according to the eco drive level. The high-
er the fuel economy, the brighter the light
becomes.
Level 0—Does not illuminate
Level 1—Illuminates weakly
Level 2—Illuminates brightly
Level 3—Illuminates most brightly
This function works even if a display other
than the eco drive level is shown on the
multi−information display.

’07Camry hybrid_U (L/O 0610)
138
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
When the hybrid system is turned off, the
eco drive level is displayed for a few
seconds to show the average fuel con-
sumption for the most recent trip.
If the average fuel consumption is in level
3, “EXCELLENT!” is simultaneously dis-
played under the eco drive level.Normal display
Zoom display
This meter displays the odometer and
two trip meters.
Selecting the zoom display of the
odometer and trip meter when the
cruise information is displayed causes
the odometer and one of the trip me-
ters to be displayed simultaneously.1. Odometer—Shows the total distance the vehicle has been driven.
2. Two trip meters—Show two different distances independently driven since
the last time each trip meter was set
to zero.
You can use one trip meter to calculate
the fuel economy and the other to
measure the distance on each trip. All
trip meter data is cancelled if the elec-
trical power source is disconnected.
—Odometer and two trip
meters

’07Camry hybrid_U (L/O 0610)
139
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
3. Trip meter reset knob—Resets the twotrip meters to zero, and also change
the meter display.
To change the meter display, quickly
push and release the knob. The meter
display changes in the order from the
odometer to trip meter A to trip meter
B, then back to the odometer each
time you push.
To reset the trip meter A to zero, dis-
play the meter A reading, then push
and hold the knob until the meter is
set to zero. The same process can be
applied for resetting the trip meter B.

’07Camry hybrid_U (L/O 0610)
148
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
(s)
This message is to remind the driver to
change the engine oil.
Change the engine oil as soon as pos-
sible.
If the driving range after the previous oil
change reaches 8000 km (5000 miles), the
message appears with the master warning
light and a warning tone sounds. The
message stays on with the “POWER”
switch set at ON.
The engine oil maintenance data must be
reset after the engine oil change. See
“Resetting the engine oil maintenance
data” below for the procedure to reset the
system.Resetting the engine oil maintenance
data
The engine oil maintenance data must be
reset after replacement of the engine oil.
Reset the data by the following procedure:
1. Turn off the hybrid system with the trip meter A reading shown.
For details, see “—Odometer and two trip
meters” on page 138 in this Section. 2. The “POWER” switch must be set at ON while holding down the trip meter
reset knob. A message “OIL MILEAGE
RESET MODE” will appear on the dis-
play.
3. Hold down the knob at least 5 sec- onds. A message “COMPLETE” will ap-
pear and the message “OIL MILEAGE
RESET MODE” goes off. (t)This message appears when the washer
fluid level becomes very low.
Fill the tank as soon as possible.
The message appears with the master
warning light a warning tone sounds.
(u)
This message appears when the driver ’s
door is opened with the “POWER”
switch turned off and the moon roof
opened.
When you leave your vehicle, be sure to
close the moon roof.
The message appears with the master
warning light and a warning tone sounds.

’07Camry hybrid_U (L/O 0610)
363
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
The tires on your Toyota have built−in
tread wear indicators to help you
know when the tires need replace-
ment. When the tread depth wears to
1.6 mm (0.06 in.) or less, the indica-
tors will appear. If you can see the
indicators in two or more adjacent
grooves, the tire should be replaced.
The lower the tread, the higher the
risk of skidding.
The effectiveness of snow tires is
lost if the tread wears down below
4 mm (0.16 in.).
If you have tire damage such as
cuts, splits, cracks deep e nough to
expose the fabric, or bulges indi-
cating internal damage, the tire
should be repl aced.
If a tire often goes flat or cannot be
properly repaired due to the size or
location of a cut or other damage, it
should be replaced. If you are not
sure, consult with your Toyota dealer. If air loss occurs while driving, do not
continue driving. Driving even a short
distance can damage a tire beyond
repair.
An y ti res wh i ch are over 6 years
old must be checked by a qualified
technician even if damage is not
obvious.
Tires deteriorate with age even if they
have never or seldom been used.
This applies also to the spare tire and
tires stored for future use.
REPLACING YOUR TIRES
When replacing a tire, use a tire of
the same size and construction,
and the same or greater maximum
load as the originally installed
tires.
Using any other size or type of tire
may seriously affect handling, ride,
speedometer/odometer calibration,
ground clearance, and clearance be-
tween the body and tires or snow
chains.
Check that the maximum load of the
replaced tire is greater than 1/2 of the
Gross Axle Weight Ratings (GAWR)
of either the front axle or the rear
axle, whichever is greater. As for the
maximum load of the tire, see the load
limit at maximum cold tire inflation
pressure mentioned on the sidewall
of the tire, and as for the Gross Axle
Weight Ratings (GAWR), see the Cer-
tification Label.
For details about the side wall of the
tire and the Certification Label, see
pages 285 and 283.