lights TOYOTA COROLLA 2001 Owner's Manual
[x] Cancel search | Manufacturer: TOYOTA, Model Year: 2001, Model line: COROLLA, Model: TOYOTA COROLLA 2001Pages: 249, PDF Size: 2.87 MB
Page 152 of 249

'01 Corolla U (L/O 0005)
792001MY_COROLLA_U (OM12720U)
Interior light
To turn on the interior light, slide the
switch.
The interior light switch has the following
positions:
ªONºÐKeeps the light on all the time.
ªOFFºÐTurns the light off.
ªDOORºÐTurns the light on when any of
the door is opened. The light remains on
for a certain time after all the doors are
closed. When all the doors are locked or
the ignition switch is turned to ªACCº or
ªONº after all the doors are closed, the
light goes off.
Ignition switch light
For easy access to the ignition switch,
the ignition switch light comes on when
any of the doors are opened.
The light remains on for a certain time
after all the doors are closed. When all
the doors are locked or the ignition switch
is turned to ªACCº or ªONº after all the
doors are closed, the light goes off.
Personal lights
With electric moon roof
Without electric moon roof
ProCarManuals.com
Page 160 of 249

'01 Corolla U (L/O 0005)
872001MY_COROLLA_U (OM12720U)
(f) Stop and check.
(g) Take vehicle to
Toyota dealer.
(h) Close all doors.
(i) Take vehicle to
Toyota dealer
immediately. or
(j) Add washer
fluid.If the indicator or
buzzer comes on...Do this.
(k) Remove key.Key reminder
buzzer
(l) Turn off lights.Light reminder
buzzer If the indicator or
buzzer comes on...Do this.(a) Brake System Warning Light
This light comes on in the following cases
when the ignition key is in the ªONº posi-
tion.When the parking brake is applied...
When the brake fluid level is low...
CAUTION
It is dangerous to continue driving
normally when the brake fluid level is
low.
Have your vehicle checked at your
Toyota dealer in the following case:
The light does not come on even if the
parking brake is applied when the igni-
tion key is in the ªONº position.
ProCarManuals.com
Page 211 of 249

'01 Corolla U (L/O 0005)
1382001MY_COROLLA_U (OM12720U)
Clock
The digital clock indicates the time.
The key must be in the ªACCº or ªONº
position.
To reset the hour: Push the ªHº button.
To reset the minutes: Push the ªMº button.
If the electrical power source has been
disconnected from the clock, the time dis-
play will automatically be set to 1:00 (one
o'clock).
When the instrument panel lights are
turned on, the brightness of the time in-
dication will be reduced.
Outside temperature display
Centigrade display
Fahrenheit display
The outside temperature display indi-
cates the outside air temperature.
The key must be in the ªONº position.
If there is some abnormality in the con-
nection of the outside air temperature sen-
sor, ª±Eº or ªEº will appear on the display.
If ª±Eº or ªEº appears on the display,
contact your Toyota dealer.
ProCarManuals.com
Page 237 of 249

'01 Corolla U (L/O 0005)
2202001MY_COROLLA_U (OM12720U)
Checking and replacing fuses
Ty p e A
Ty p e C Ty p e BGood Blown
Good Good
Blown Blown
If the headlights or other electrical
components do not work, check the
fuses. If any of the fuses are blown,
they must be replaced.
See ªFuse locationsº in Section 7±1 for
locations of the fuses.
Turn the ignition switch and inoperative
component off. Pull a suspected fuse
straight out and check it.
Determine which fuse may be causing the
problem. The lid of the fuse box shows
the name of the circuit for each fuse. See
Section 8 of this manual for the functions
controlled by each circuit.Type A fuses can be pulled out by the
pull±out tool. The location of the pull±out
tool is shown in the illustration.
If you are not sure whether the fuse has
blown, try replacing the suspected fuse
with one that you know is good.
If the fuse has blown, push a new fuse
into the clip.
Only install a fuse with the amperage rat-
ing designated on the fuse box lid.
If you do not have a spare fuse, in an
emergency you can pull out the ªA/Cº or
ªS±HTRº fuse, which may be dispensable
for normal driving, and use it if its
amperage rating is the same.
If you cannot use one of the same amper-
age, use one that is lower, but as close
as possible to, the rating. If the amperage
is lower than that specified, the fuse
might blow out again but this does not
indicate anything wrong. Be sure to get
the correct fuse as soon as possible and
return the substitute to its original clip.
It is a good idea to purchase a set of
spare fuses and keep them in your ve-
hicle for emergencies.
ProCarManuals.com
Page 239 of 249

'01 Corolla U (L/O 0005)
2222001MY_COROLLA_U (OM12720U)
Light bulbsBulb
No.WTy p e
Headlights
(high beam)900560A
Headlights
(low beam)900651B
Front fog lightsÐ55C
Parking/front side
marker/front turn
signal lights3157NA27/8E
Rear side marker
lights1943.8E
Rear turn signal
lights315627E
Stop/tail lights315727/8E
Back±up lights92118E
License plate lights1943.8E
High mounted
stoplight92118E
Personal light
(with electric moon
roof)Ð10D
Personal lights
(without electric
moon roof)1924.3E
Light bulbsBulb
No.WTy p e
Interior lightÐ8F
Trunk light1684.9E
A: HB3 halogen bulbs
B: HB4 halogen bulbs
C: H3 halogen bulbs
D: Single end bulbs
E: Wedge base bulbs
F: Double end bulbs
ÐHeadlights
1. Open the hood.
RIGHT±HAND HEADLIGHT: Remove
the bolts and take out the relay
block.
Put the relay block in the appropriate
place other than on the engine.
NOTICE
Do not place the relay block on the
engine.
ProCarManuals.com
Page 242 of 249

'01 Corolla U (L/O 0005)
2252001MY_COROLLA_U (OM12720U)
ÐFront fog lights
1. Loosen the retainer nut and take out
the beam unit.2. Turn the cover counterclockwise and
remove it.3. Disconnect the cords.
ProCarManuals.com
Page 243 of 249

'01 Corolla U (L/O 0005)
2262001MY_COROLLA_U (OM12720U)
4. Release the bulb retaining spring
and remove the bulb. Install a new
bulb and the bulb retaining spring.
To install the bulb, align the cutouts of the
bulb with the protrusions of the mounting
hole.5. Connect the cords and install the
cover by turning it clockwise.
6. Install the fog light and tighten the
nut.Use a Phillips±head screwdriver.
ÐParking/front side marker/
front turn signal lights
ProCarManuals.com
Page 244 of 249

'01 Corolla U (L/O 0005)
2272001MY_COROLLA_U (OM12720U)
Remove and install the clips as shown in
the following illustrations.Removing clips (type A): Use a flat±bladed
screwdriver or equivalent.
Installing clips (type A)
ÐRear side maker, rear turn
signal, and stop/tail lights
ProCarManuals.com
Page 246 of 249

'01 Corolla U (L/O 0005)
2292001MY_COROLLA_U (OM12720U)
ÐBack±up lights
ÐLicense plate lights
( lef t sid e)
ProCarManuals.com
Page 247 of 249

'01 Corolla U (L/O 0005)
2302001MY_COROLLA_U (OM12720U)
ÐLicense plate lights
(right side)
ProCarManuals.com