buttons TOYOTA COROLLA 2001 Owners Manual

'01 Corolla U (L/O 0005)
332001MY_COROLLA_U (OM12720U)
To connect the extender to the seat
belt, insert the tab into the seat belt
buckle so that the ªPRESSº signs on
the buckle±release buttons of the ex-
tender and the seat belt are both facing
outward as shown.
You will hear a click when the tab locks
into the buckle.
When releasing the seat belt, press on
the buckle±release button on the extender,
not on the seat belt. This helps prevent
damage to the vehicle interior and extend-
er itself.
When not in use, remove the extender
and store in the vehicle for future use.
CAUTION

After inserting the tab, make sure
the tab and buckle are locked and
that the seat belt extender is not
twisted.

Do not insert coins, clips, etc. in
the buckle as this may prevent you
from properly latching the tab and
buckle.

If the seat belt does not function
normally, immediately contact your
Toyota dealer.
ÐFront seat belt pretensioners
The driver and front passenger 's seat
belt pretensioners are designed to be
activated in response to a severe fron-
tal impact.
When the airbag sensor detects the shock
of a severe frontal impact, the front seat
belt is quickly drawn back in by the re-
tractor so that the belt snugly restrains
the front seat occupants.
The seat belt pretensioners are activated
even with no passenger in the front seat.
Collisions occurring at certain speeds and
angles may cause the seat belt preten-
sioners and SRS airbags not to operate
all together.
ProCarManuals.com

'01 Corolla U (L/O 0005)
1092001MY_COROLLA_U (OM12720U)
Details of specific buttons, controls and
features are described in the alphabetical
listing that follows.
ÐControls and features

Ty p e 1
ProCarManuals.com

'01 Corolla U (L/O 0005)
11 02001MY_COROLLA_U (OM12720U)
1 2 3 4 5 6 (Preset buttons)
These buttons are used to preset and
tune in radio stations.
To preset a station to a button: Tune in
the desired station (see ªTUNEº button).
Push and hold down the button until you
hear a beepÐthis will set the station to
the button. The button number will appear
on the display.
To tune in to a preset station: Push the
button for the station you want. The but-
ton number and station frequency will ap-
pear on the display.
These systems can store one AM and one
FM station for each button. The preset
station memory will be canceled out if the
power source is interrupted (battery dis-
connected or fuse blown).
AM´FM
Push ªAM´FMº to switch between the AM
and FM bands. ªAMº or ªFMº will appear
on the display.
If the audio system is off, you can turn
on the radio by pushing ªAM´FMº.BAL (Balance)
Turn the ªBALº knob with pulling to adjust
the balance between the right and left
speakers.
PWR´VOL (Power´Volume)
Push ªPWR´VOLº to turn the audio system
on and off. Turn ªPWR´VOLº to adjust the
volume.
ST (Stereo reception) display
Your radio automatically changes to stereo
reception when a stereo broadcast is re-
ceived. ªSTº appears on the display. If the
signal becomes weak, the radio reduces
the amount of channel separation to prev-
ent the weak signal from creating noise.
If the signal becomes extremely weak, the
radio switches from stereo to mono recep-
tion.
TONE
Move the ªTONEº ring around ªBALº to
adjust the tone.TUNE
Tuning
Your Toyota has an electronic tuning radio
(ETR). Push and release the ª
º (up) or
ªº (down) side of ªTUNEº to step up or
down the station band. (If you hear a
beep, you held the button too long and
the radio will go into the seek mode.)
Seeking
In the seek mode, the radio finds and
plays the next station up or down the
station band.
To seek a station, push and hold the ª
º
or ªº side of ªTUNEº until you hear a
beep. Do this again to find another sta-
tion.
ProCarManuals.com

'01 Corolla U (L/O 0005)
1112001MY_COROLLA_U (OM12720U)
Details of specific buttons, controls, and
features are described in the alphabetical
listing that follows.
Ty p e 2
ProCarManuals.com

'01 Corolla U (L/O 0005)
11 22001MY_COROLLA_U (OM12720U)
1 2 3 4 5 6 (Preset buttons)
These buttons are used to preset and
tune in radio stations.
To preset a station to a button: Tune in
the desired station (see ªTUNEº button).
Push and hold down the button until you
hear a beepÐthis will set the station to
the button. The button number will appear
on the display.
To tune in to a preset station: Push the
button for the station you want. The but-
ton number and station frequency will ap-
pear on the display.
These systems can store one AM and one
FM station for each button. The preset
station memory will be canceled out if the
power source is interrupted (battery dis-
connected or fuse blown).
(Eject button)
Push this button to eject a cassette.
AM´FM
Push ªAM´FMº to switch between the AM
and FM bands. ªAMº or ªFMº will appear
on the display.
If the audio system is off, you can turn
on the radio by pushing ªAM´FMº. Also,
push ªAM´FMº to switch from cassette op-
eration to radio operation.BAL (Balance)
Move the ªBALº ring around ªTONEº to
adjust the balance between the right and
left speakers.
FF (Fast forward)
Push the ªFFº to fast forward a cassette
tape.
To stop the tape while it is fast forward-
ing, lightly push the ªREWº.
If a tape fast forwards completely, the
cassette player will play the other side of
the tape, using the auto±reverse feature.
PROG (Program)
Push ªPROGº to select the other side of
a cassette tape.
Auto±reverse feature: After the cassette
player reaches the end of a tape side, it
automatically reverses and begins to play
the other side. This is true whether the
cassette was playing or fast forwarding.
REW (Rewind)
Push the ªREWº to rewind to a tape.
To stop the tape while it is rewinding,
lightly push the ªFFº.
If a tape side rewinds completely, the cas-
sette player will stop and then play that
same side.ST (Stereo reception) display
Your radio automatically changes to stereo
reception when a stereo broadcast is re-
ceived. ªSTº appears on the display. If the
signal becomes weak, the radio reduces
the amount of channel separation to prev-
ent the weak signal from creating noise.
If the signal becomes extremely weak, the
radio switches from stereo to mono recep-
tion.
TA P E
Push ªTAPEº to switch from radio opera-
tion to cassette operation. If the audio
system is off, you can turn on the cas-
sette player by pushing ªTAPEº. In both
cases, a cassette must already be loaded
in the player.
TONE
Turn the ªTONEº knob to adjust the tone.
ProCarManuals.com

'01 Corolla U (L/O 0005)
11 42001MY_COROLLA_U (OM12720U)
Details of specific buttons, controls, and
features are described in the alphabetical
listing that follows.
Ty p e 3
ProCarManuals.com

'01 Corolla U (L/O 0005)
11 52001MY_COROLLA_U (OM12720U)
1 2 3 4 5 6 (Preset buttons)
These buttons are used to preset and
tune in radio stations.
To preset a station to a button: Tune in
the desired station (see ªTUNEº button).
Push and hold down the button until you
hear a beepÐthis will set the station to
the button. The button number will appear
on the display.
To tune in to a preset station: Push the
button for the station you want. The but-
ton number and station frequency will ap-
pear on the display.
These systems can store one AM and two
FM stations for each button (The display
will show ªAMº, ªFM1º or ªFM2º when you
push ªAMº or ªFMº).
(Eject button)
Push this button to eject a cassette.
After you turn the ignition to ªLOCKº, you
will be able to eject a cassette but you
will not be able to reinsert it.
(Reverse/Fast forward buttons)
Cassette Player
Push the fast forward button to fast for-
ward a cassette tape. ªFFº will appear on
the display. Push the reverse button to
rewind a tape. ªREWº will appear on the
display.
To stop the tape while it is fast forward-
ing, push the fast forward button or
ªTAPEº; to stop the tape while it is re-
winding, push the reverse button or
ªTAPEº.
If a tape side rewinds completely, the cas-
sette player will stop and then play that
same side. If a tape fast forwards com-
pletely, the cassette player will play the
other side of the tape, using the auto±re-
verse feature.
Compact Disc Player
If you want to fast forward or reverse
through a compact disc track, push and
hold in the fast forward or reverse button.
When you release the button, the compact
disc player will resume playing.AM
Push ªAMº to switch the AM band. ªAMº
will appear on the display.
If the audio system is off, you can turn
on the radio by pushing ªAMº. Also, push
ªAMº to switch from cassette or compact
disc operation to radio operation.
AUDIO CONTROL / MODE
Manual tone adjustment functionÐ
This knob is used to adjust the tone
manually.
For low±pitch tone adjustment, push
ªAUDIO CONTROL / MODEº repeatedly
until ªBASº appears on the display. Then
turn the knob to suit your preference.
The display will show the range from
ªBAS ±5º to ªBAS 5º.
For high±pitch tone adjustment, push
ªAUDIO CONTROL / MODEº repeatedly
until ªTREº appears on the display. Then
turn the knob to suit your preference.
The display will show the range from
ªTRE ±5º to ªTRE 5º.
ProCarManuals.com

'01 Corolla U (L/O 0005)
1202001MY_COROLLA_U (OM12720U)
Details of specific buttons, controls, and
features are described in the alphabetical
listing that follows.
Ty p e 4
ProCarManuals.com

'01 Corolla U (L/O 0005)
1212001MY_COROLLA_U (OM12720U)
1 2 3 4 5 6 (Preset buttons)
These buttons are used to preset and
tune in radio stations.
To preset a station to a button: Tune in
the desired station (see ªTUNEº button).
Push and hold down the button until you
hear a beepÐthis will set the station to
the button. The button number will appear
on the display.
To tune in to a preset station: Push the
button for the station you want. The but-
ton number and station frequency will ap-
pear on the display.
These systems can store one AM and two
FM stations for each button (The display
will show ªAMº, ªFM1º or ªFM2º when you
push ªAM´FMº).
(Eject button)
Push this button to eject a compact disc.
After you turn the ignition to ªLOCKº, you
will be able to eject a disc but you will
not be able to reinsert it.
(Reverse/Fast forward buttons)
If you want to fast forward or reverse
through a compact disc track, push and
hold in the fast forward or reverse button.
When you release the button, the compact
disc player will resume playing.
AM´FM
Push ªAM´FMº to switch between the AM
and FM bands. ªAMº, ªFM1º or ªFM2º will
appear on the display. These systems al-
low you to set twelve FM stations, two for
each button.
If the audio system is off, you can turn
on the radio by pushing ªAM´FMº. Also,
push ªAM´FMº to switch from compact
disc operation to radio operation.
AUDIO CONTROL / MODE
Manual tone adjustment functionÐ
This knob is used to adjust the tone
manually.
For low±pitch tone adjustment, push
ªAUDIO CONTROL / MODEº repeatedly
until ªBASº appears on the display. Then
turn the knob to suit your preference.
The display will show the range from
ªBAS ±5º to ªBAS 5º.For high±pitch tone adjustment, push
ªAUDIO CONTROL / MODEº repeatedly
until ªTREº appears on the display. Then
turn the knob to suit your preference.
The display will show the range from
ªTRE ±5º to ªTRE 5º.
Sound balance adjustment functionÐ
This knob is also used to adjust the
sound balance between the front and rear,
and the right and left speakers.
For front/rear adjustment, push ªAUDIO
CONTROL / MODEº repeatedly until ªFAdº
appears on the display. Then turn the
knob to adjust the front/rear balance.
The display will show the range from ªFAd
F7º to ªFAd R7º.
For left/right adjustment, push ªAUDIO
CONTROL / MODEº repeatedly until ªBALº
appears on the display. Then turn the
knob to adjust the left/right balance.
The display will show the range from ªBAL
L7º to ªBAL R7º.
ProCarManuals.com