change time TOYOTA COROLLA 2011 10.G Quick Reference Guide

2011
Corolla

This Quick Reference Guide is not a full description of Corolla
operations. Every Corolla owner should review the Owner’s
Manual that accompanies this vehicle.
Pay special attention to the boxed
information highlighted in
color throughout the Owner’s Manual. Each box contains safe
operating instructions to help you avoid injury or equipment
malfunction.
All information in this Quick Reference Guide is current at
the time of printing. Toyota reserves the right to make
changes at any time without notice.
414868M2.qxd:414868M2 11/18/10 9:35 AM Page B

11
OVERVIEW
FEATURES/OPERATIONS
SAFETY AND EMERGENCY FEATURES



High beam flasher
Low beam

Daytime Running Light system (DRL) Headlights turn on automatically
upon starting engine. The brightness of the headlights will automatically
change depending on the darkness of the surroundings.
Front fog lights come on only when the headlights are on low beam.
Right turn
Lane change
Lane change Left turn High beam
Headlights
Parking lights
Turn

Designed for 12V car accessories.
The ignition switch must be in the “ACC” or “ON” position.
414868M2.qxd:414868M2 11/18/10 9:35 AM Page 11

20
System reset initialization
1. Push and hold “ SET” button until the indicator blinks
three times.
2. Wait a few minutes to allow initialization to complete.

Pull up
Moving the lever to “LOCK” will allow the door to be opened only from
the outside.
Rear door


After adjusting tire pressures, or after tires have been rotated or
replaced, turn the ignition switch to “ON” and press and hold the
“ SET” button until indicator blinks three times. Let the vehicle sit for a
few minutes to allow initialization to complete.
Refer to the load label on the door jamb or the Owner’s Manualfor tire
inflation specifications.
If the tire pressure indicator flashes for more than 60 seconds and then
remains on, take the vehicle to your local Toyota dealer.
NOTE: The warning light may come on due to temperature changes or
changes in tire pressure from natural air leakage. If the system has not
been initialized recently, setting the tire pressures to factory
specifications should turn off the light.
SAFETY AND EMERGENCY FEATURES
414868M2.qxd:414868M2 11/18/10 9:35 AM Page 20