1872007 FJ CRUISER from Oct. ’06Prod. (OM35873U)
TS10009a
CALIBRATING THE COMPASS (circling
calibration)
Sometimes the direction display on the
compass may not change after a turn. To
rectify this, stop the vehicle and do as
follows.1. Push and hold the “SET” button for about 2 seconds. The zone number ap-
pears on the outside temperature dis-
play.
2. Push the “SET” button. “ −−” will start
moving.
TS10010
3. Drive the vehicle in a circle at 8 km/h (5 mph). If there is not enough space
to drive in a circle, drive around the
block.
When the compass display returns to the
outside temperature display, calibration is
complete.
When circling calibration fails, “Er” is dis-
played for 2 seconds and then “COM-
PASS” flashes. It also flashes when cir-
cling calibration is not completed.
If you want to cancel the calibration be-
fore it is complete, push the “SET” button
for about 2 seconds. Perform circling calibration just after
you have purchased your Toyota. And
then always perform circling calibration
after the battery has been removed, re-
placed or disconnected.
Do not perform circling calibration of
the compass in a place where the
earth’s magnetic field is subject to in-
terference by artificial magnetic fields
(underground parking, under a steel
tower, between buildings, roof parking,
near a crossing, near a large vehicle,
etc.).
During calibration, do not operate elec-
tric systems (power windows, etc.) as
they may interfere with the calibration.
