4WD TOYOTA FJ CRUISER 2008 1.G User Guide

176 2−5. Driving information
CAUTION
 To avoid accident or injury
 The total trailer weight (trailer weight plus the weight of cargo) must not
exceed 5000 lb. (2265 kg)
If a trailer and cargo weight over 2000 lb. (907 kg), use a sway control
device with sufficient capacity.
 The gross combined weight (sum of your vehicle weight plus its load and
the total trailer weight) must not exceed the following.
2WD models
9200 lb. (4173 kg)
4WD models
9500 lb. (4309 kg)
Do not exceed the trailer hitch assembly weight, gross vehicle weight,
gross axle weight and trailer tongue load capacities.
 Never load more weight in the back than in the front of the trailer. About
60% of the load should be in the front half of the trailer, and the remaining
40% in the rear.
 The tow hitch receiver installed on your vehicle must never be used on
another vehicle.
Hitches
If you wish to install a trailer hitch, your Toyota dealer should be consulted.
Use only a hitch that conforms to the total trailer weight requirement.
Follow the directions supplied by the hitch manufacturer.
Lubricate the hitch ball with a light coat of grease.

Remove the trailer hitch whenever y ou are not towing a trailer to reduce
the possibility of additional damage caused by the hitch if your vehicle is
struck from behind.

309
4−3. Do−it−yourself maintenance
4
Maintenance and care
17 RADIO NO.1 20 A Audio system
18 ECU−B 10 AAir conditioning system, multiplex
communication system, SRS air−
bag system, front passenger occu−
pant classification system
19 ALT−S 7.5 A Charging system
20 HORN 10 A Horn
21 A/F HEATER 15 AMultiport fuel injection system/
sequential multiport fuel injection
system
22 TRN−HAZ 15 ATurn signal lights, emergency
flashers
23 ETCS 10 AMultiport fuel injection system/
sequential multiport fuel injection
system, electronic throttle control
system
24 EFI 20 AEFI NO.2, multiport fuel injection
system/sequential multiport fuel
injection system
25 DR/LCK 20 ADoor lock system, multiplex com−
munication system
26 TOWING 15 A Towing converter
27 RADIO NO.2 20 A Audio system
28 AM1 50 AACC, ECU−IG, IG1, RR WSH, FR
WIP−WSH, 4WD/DIFF and STA
29 J/B 50 A TAIL, PWR OUTLET, POWER
30 ABS MTR 40 A
Anti−lock brake system, vehicle sta−
bility control system, traction con−
trol system, active traction control
system, AUTO LSD system
FuseAmpereCircuit

311
4−3. Do−it−yourself maintenance
4
Maintenance and care
 Under the instrument panel
FuseAmpere Circuit
1 IGN 10 AMultiport fuel injection system/
sequential multiport fuel injection
system, anti−lock brake system,
vehicle stability control system,
traction control system, active trac−
tion control system, AUTO LSD
system, SRS airbag system, front
passenger occupant classification
system
2 GAUGE 7.5 A Meter and gauge
3 FR WIP−WSH 30 A Windshield wipers and washer
4 4WD/DIFF 20 AFour−wheel drive system, rear dif−
ferential lock system
5 PWR OUTLET 15 A Power outlet
6 RR WSH 15 A
Rear window wiper and washer,
multiplex communication system
1
5678
91011
1223 4

5
When trouble arises
323 5−1. Essential information
 Emergency towing procedure
The engine switch must be in the ACC (engine off) or the ON
(engine running) position.
4WD models with an automatic transmission: Shift the front−wheel
drive control lever in H2.
4WD models with a manual transmission: Unlock the center differ−
ential.
Put the shift lever in N.
Release the parking brake.
CAUTION
 Caution while towing
 Use extreme caution when towing the vehicle.
Avoid sudden starts or erratic driving maneuvers which place excessive
stress on the emergency towing eyelet and the cables or chains.
 If the engine is not running, the power assist for the brakes and steering
will not function, making steering and braking more difficult.
NOTICE
 To prevent causing serious damage to the transmission
(vehicles with an automatic transmission)
Never tow this vehicle from the rear with the four wheels on the ground.
This may cause serious damage to the transmission.
Emergency towing eyelet precautions
Before emergency towing, check that the eyelet is not broken or damaged.
Fasten the towing cable or chain securely to the eyelet.
Do not jerk the eyelet. Apply steady and even force.

To avoid damaging the eyelet, do not pull from the side or at a vertical
angle. Always pull straight ahead.

5
When trouble arises
325 5−1. Essential information
Towing with a wheel lifttype truck from the rear
2WD models
Turn the engine switch to the
ACC position.
4WD models
Vehicles with a manual transmis−
sion: Use a towing dolly under
the front wheels.
Vehicles with an automatic trans−
mission: When not using a tow−
ing dolly, turn the engine switch
to the ACC position, shift the
shift lever to N and shift the front−
wheel drive control lever in H2.
NOTICE
 To prevent causing serious damage to the transmission (4WD models)
Never tow this vehicle wheels on the ground.
To prevent damaging the vehicle
Do not tow the vehicle with the key removed or in the LOCK position.
The steering lock mechanism is not strong enough to hold the front wheel
straight.
 When raising the vehicle, ensure adequate ground clearance for towing at
the opposite end of the raised vehicle. Without adequate clearance, the
vehicle could be damaged while being towed.

5
When trouble arises
359
5−2. Steps to take in an emergency
If the vehicle becomes stuck
 Emergency hook Carry out the following procedures if the tires spin or the vehicle
becomes stuck in mud, dirt, or snow.
Stop the engine. Set the parking brake and put the shift
lever in P (vehicles with an automatic transmission) or N
(vehicles with a manual transmission).
Remove the mud, snow, or sand from around the stuck tire.
Place wood, stones or some other material to help provide
traction under the tires.
2WD models: Push the AUTO LSD switch. (
P. 150)
4WD models with an automatic transmission: Shift the
front−wheel drive control lever to L4. Then push the RR
DIFF LOCK switch (if equipped). ( P. 152)
4WD models with a manual transmission: Shift the four−
wheel drive control lever to LL. Then push the RR DIFF
LOCK switch (if equipped). ( P. 152)
Carefully apply the accelerator to free the vehicle.
When your vehicle becomes stuck and
cannot move, the emergency hook is
used for another vehicle to pull your vehi−
cle out in an emergency.
Your vehicle is not designed to tow
another vehicle.
Do not use the rear hook. It is not
designed for towing.

362
6−1. Specifications
Maintenance data (fuel, oil level, etc.)
Dimensions and weight
*: Unladen vehicle
Overall length 183.9 in. (4670 mm)
Overall width 75.0 in. (1905 mm)
Overall
height*2WD models 71.3 in. (1810 mm)
4WD models 72.0 in. (1830 mm)
Wheelbase 105.9 in. (2690 mm)
Front tread 63.2 in. (1605 mm)
Rear tread 63.2 in. (1605 mm)
Vehicle capacity weight
(Occupants + luggage)
1190 lb. (540 kg)
Towing capacity
(Trailer weight + cargo)
5000 lb. (2265 kg)

367
6−1. Specifications
6
Vehicle specifications
Differential
Automatic transmission
*: The fluid capacity is the quantity of reference. If replacement is necessary,
contact your Toyota dealer.
Oil capacityFront
(4WD models)
Vehicles with a manual transmission
1.5 qt. (1.4 L, 1.2 Imp.qt.)
Vehicles with an automatic transmission
1.7 qt. (1.6 L, 1.4 Imp.qt.)
Rear
Vehicles with a rear differential lock
3.1 qt. (2.9 L, 2.6 Imp.qt.)
Vehicles without a rear differential lock
3.2 qt. (3.0 L, 2.6 Imp.qt.)
Oil type and
viscosityFront
(4WD models)Hypoid gear oil API GL−5
Vehicles with an automatic transmission
SAE75W−85
Vehicles with a manual transmission
Above 0
F (−18C): SAE90
Below 0
F (−18
C): SAE80W or 80W−90
RearHypoid gear oil API GL−5
Above 0 F (−18C): SAE90
Below 0
F (−18
C): SAE80W or 80W−90
Fluid capacity
*11.3 qt. (10.7 L, 9.4 Imp.qt.)
Fluid type Toyota Genuine ATF WS
NOTICE
 Automatic transmission fluid type
Using automatic transmission fluid other than “Toyota Genuine ATF WS”
may cause deterioration in shift quality, locking up of your transmission
accompanied by vibration, and ultimately damage the automatic
transmission of your vehicle.

368 6−1. Specifications
Manual transmission
Clutch
Transfer (4WD models)
Gear oil capacity (Reference) 1.9 qt. (1.8 L, 1.6 Imp.qt.)
Gear oil type Gear oil API GL−4 or GL−5
Recommended gear oil viscosity SAE 75W−90
Clutch free play 0.2 0.6 in. (5
15 mm)
Fluid type FMVSS No. 116 DOT 3 or SAE J1703
Oil capacity
Vehicles with an automatic transmission
1.1 qt. (1.0 L, 0.9 Imp.qt.)
Vehicles with a manual transmission
1.5 qt. (1.4 L, 1.2 Imp.qt.)
Oil type
Vehicles with an automatic transmission
Hypoid gear oil API GL−4 or GL−5
Vehicles with a manual transmission
Hypoid gear oil API GL−5
Recommended oil viscosity SAE 75W−90

392
Abbreviation list
Abbreviation/Acronym list
ABBREVIATIONS MEANING
2WDTwo Wheel Drive
4WD Four Wheel Drive
ABS Anti−Lock Brake System
ACC Accessory
AI−SHIFT Artificial Intelligence shifting
ALR Automatic Locking Retractor
A−TRAC Active Traction Control
AUTO LSD Automatic Limited Slip Differential
CRS Child Restraint System
E/M English/U.S. Customary System and metric
ECU Electronic Control Unit
EDR Event Data Recorder
ELR Emergency Locking Retractor
GAWR Gross Axle Weight Rating
GVWR Gross Vehicle Weight Rating
I/M Emission inspection and maintenance
INT Intermittent
LED Light Emitting Diode
LT Light truck
M + S Mud + Snow
MMT Methylcy clopentadienyl Manganese Tricarbonyl
MTBE Methyl Tertiary Butyl Ether
OBD On Board Diagnostics
RES Resume
RR DIFF LOCK Rear differential lock
SRS Supplemental Restraint System
TIN Tire Identification Number