change time TOYOTA FJ CRUISER 2008 1.G Owners Manual

22
For your information
Main Owners Manual
Please note that this manual applies to all models explains and all equip−
ment, including options. Therefore, you may find some explanations for
equipment not installed on your vehicle.
All specifications provided in this manual are current at the time of printing.
However, because of the Toyota policy of continual product improvement, we
reserve the right to make changes at any time without notice.
Depending on specifications, the vehicle shown in the illustrations may differ
from your vehicle in terms of equipment.
Accessories, spare parts and modification of your Toyota
A wide variety of non−genuine spare parts and accessories for Toyota
vehicles are currently available in the market. You should know that Toyota
does not warrant these products and is not responsible for their
performance, repair, or replacement, or for any damage they may cause to,
or adverse effect they may have on, your Toyota vehicle.
This vehicle should not be modified with non−genuine Toyota products.
Modification with non−genuine Toyota products could affect its performance,
safety or durability, and may even
violate governmental regulations. In
addition, damage or performance problems resulting from the modification
may not be covered under warranty.
Installation of a mobile twoway radio system
As the installation of a mobile two−way radio system in your vehicle could
affect electronic systems such as the multiport fuel injection system/sequen−
tial multiport fuel injection system, cruise control system, anti−lock brake sys−
tem, SRS airbag system and seat belt pretensioner system, be sure to check
with your Toyota dealer for precautionary measures or special instructions
regarding installation.

109
2−1. Driving procedures
2
When driving
CAUTION
 When driving on slippery road surfaces
 Sudden braking, acceleration and steering may cause tire slippage and
reduce your ability to control the vehicle, resulting in an accident.
Sudden changes in engine speed, such as engine braking caused by up−
shifting or down−shifting, may cause the vehicle to skid, resulting in an
accident.
 After driving through a puddle, lightly depress the brake pedal to make
sure that the brakes are functioning properly. Wet brake pads may prevent
the brakes from functioning properly. If the brakes on only one side are wet
and not functioning properly, steering control may be affected, resulting in
an accident.
 When shifting the shift lever
 Vehicles with an automatic transmission, be careful not to shift the shift
lever with the accelerator pedal depressed.
This may lead to unexpected rapid acceleration of the vehicle that may
cause an accident and result in death or serious injury.
 When the vehicle is stopped
 Do not race the engine.
If the vehicle is in any gear other than P (automatic transmission only) or
N, the vehicle may accelerate suddenly and unexpectedly, and may cause
an accident.
 Do not leave the vehicle with the engine running for a long time.
If such a situation cannot be avoided, park the vehicle in an open space
and check that exhaust fumes do not enter the vehicle interior.
 Vehicles with an automatic transmission, always keep a foot on the brake
pedal while the engine is running to prevent an accident caused by the
vehicle moving.

132 2−3. Operating the lights and wipers
 Daytime running light system (if equipped)
To make your vehicle more visible to other drivers, the headlights turn on
automatically (at a reduced intensity) whenever the engine is started and the
parking brake is released. Daytime
running lights are not designed for use at
night.
Automatic light off system
When the headlights come on: The headlights and tail lights turn off 30
seconds after all doors and glass hatch are closed with the engine switch
turned to the ACC or LOCK position. (The lights turn off immediately if
the LOCK button on the wireless remote control is pressed twice after all
doors are locked.)
 When only the tail lights come on: The tail lights turn off automatically
with the engine switch turned to the ACC or LOCK position and the
driver ’s door is opened.
If the driver ’s door is kept open, the lights automatically turn off after 30 min−
utes.
To turn the lights on again, turn the engine switch to the ON position, or turn
the headlight switch off once and then back to the or position.
 Customization that can be configured at Toyota dealer
Settings (automatic light off system) can be changed. (Customizable
features
P. 386)
NOTICE
 To prevent battery discharge
Do not leave the lights on longer than necessary when the engine is not run−
ning.

186 3−1. Using the air conditioning system and defogger
When the dial is set to , air
flows to the feet and the wind−
shield defogger operates.
The air intake selector is automat−
ically set to outside air mode.
To return the recirculated air
mode, press .
When the dial is set to , air
flows to the windshield and side
windows.
The air intake selector is automat−
ically set to outside air mode.
In this position, the air intake
selector cannot be changed to the
recirculated air mode.
 Switching between outside air and recirculated air modes
Press .
The mode switches between (outside air mode) and
(recirculated air mode) each time the switch is pressed.

190
3−1. Using the air conditioning system and defogger
Rear window defogger
 The rear window defogger can be operated when
The engine switch is in the ON position.
NOTICE
 To prevent battery discharge
Turn the rear window defogger off when the engine is off.
Clear the rear window using the defogger.
ON/OFF
Press the button to turn on the
rear window defogger. The
indicator light will come on.
The defogger will automatically
turn off after 15 to 240 minutes.
The operation time changes
according to the ambient tem−
perature and vehicle speed.
Pressing the button again also
turns the defogger off.

195
3−2. Using the audio system
3
Interior features
Setting station presets (excluding XM® Satellite Radio)
Search for desired stations by turning or or
pressing “
” or “
” on or .
Press and hold the button (from or
to or
) that the station is to be set to until you hear a beep.
Scanning radio stations (excluding XM® Satellite Radio)
 Scanning the preset radio stations
Press and hold or until you hear a beep.
Preset stations will be played for 5 seconds each.
When the desired station is reached, press the button once
again.
 Scanning all radio stations within range
Press or .
All stations with reception will be played for 5 seconds each.
When the desired station is reached, press the button once
again.
XM® Satellite Radio (type B)
 Receiving XM
® Satellite Radio
Press and select the XM
® band.
The display changes as follows each time is pressed.
AM
SAT1 SAT2
SAT3

196 3−2. Using the audio system
Turn to select the desired channel in the all categories
or press “ ” or “” on to select the desired channel in
the current category.
 Setting XM
® Satellite Radio channel presets
Select the desired channel. Press and hold the button (from
to ) that the channel is to be set to until you hear a beep.

Changing the channel category
Press “
” or “ ” on the .
 Scanning XM
® Satellite Radio channels

Scanning channels in the current category
Press .
When the desired channel is reached, press
again.

Scanning preset channels
Press and hold until you hear a beep.
When the desired channel is reached, press
again.

Displaying text information
Press .
The display will show up to 10 characters.
The display changes as follows each time the button is pressed.
 CH NAME
TITLE (SONG/PROGRAM TITLE)

NAME (ARTIST NAME/FEATURE)

CH NUMBER

198 3−2. Using the audio system
 If the satellite radio does not operate normally
If a problem occurs with the XM
® tuner, a message will appear on the dis−
play. Refer to the table below to identify the problem, and take the suggested
corrective action.
ANTENNAThe XM
® antenna is not connected. Check
whether the XM® antenna cable is attached
securely.
There is a short−circuit in the antenna or the sur−
rounding antenna cable. See a Toyota certified
dealer.
UPDATINGYou have not subscribed to the XM
® Satellite
Radio. The radio is being updated with the latest
encryption code. Contact the XM
® Satellite Radio
for subscription information. When a contract is
canceled, you can choose the “CH000” and all
free−to−air channels.
The premium channel you selected is not autho−
rized. Wait for about 2 seconds until the radio
returns to the previous channel or “CH001”. If it
does not change automatically, select another
channel. If you want to listen to the premium chan−
nel, contact the XM
® Satellite Radio.
NO SIGNALThe XM
® signal is too weak at the current location.
Wait until your vehicle reaches a location with a
stronger signal.
LOADING
The unit is acquiring audio or program information.
Wait until the unit has received the information.
OFF AIR
The channel you selected is not broadcasting any
programming. Select another channel.
−−−−−
There is no song/program title or artist name/fea−
ture associated with the channel at that time. No
action needed.

203
3−2. Using the audio system
3
Interior features
Repeat play
 Repeating a track
Press (RPT) or (RPT).

Repeating all of the tracks on a CD (with CD changer only)
Press and hold (RPT) or (RPT) until you hear a beep.
Random playback
 Current CD
Press (RAND) or (RAND).
Tracks are played in a random order until the button is pressed once
more.
 All CDs (with CD changer only)
Press and hold (RAND) or (RAND) until you hear a
beep.
Tracks on all loaded CDs are played in a random order until the button is
pressed once more.
Switching the display
Press or .
Each time the switch is pressed, the display changes in the order of Track
no./Elapsed time
CD title
Track name.

204 3−2. Using the audio system
 Display
Up to 12 characters can be displayed at a time.
If there are 13 characters or more, pressing and holding or
for
1 second or more will display the remaining characters.
A maximum of 24 characters can be displayed.
If or is pressed for 1 second or more again or has not been
pressed for 6 seconds or more, the display will return to the first 12 charac−
ters.
Depending on the contents recorded, the characters may not be displayed
properly or may not be displayed at all.
Canceling random playback
Press (RAND) or
(RAND) again.
 Canceling repeat play
Press (RPT) or (RPT) again.
 Error messages
Refer to the following table and take the appropriate measures. If the prob−
lem is not rectified, take the vehicle to your Toyota dealer.
MessageCauseCorrection
Procedures
ERROR 1The disc may be dirty
or damaged
The disc may be
inserted upside downClean the disc
Insert the disc cor−
rectly
ERROR 3There is a problem
within the systemEject the disc or mag−
azine
ERROR 4 Over−currentAsk your Toyota
dealer
WAI TOperation is stopped
due to a high temper−
ature inside the playerEject the disc and
allow the player to
cool down
CD OPENThe external CD
changer lid is open
Close the lid