fuse TOYOTA HIGHLANDER 2001 Service Owners Manual

2005 HIGHLANDER (EWD592U)
326
J POWER SOURCE (Current Flow Chart)
FuseSystemPage
10ADOME
Key Reminder and Seat Belt Warning
Navigation System
Theft Deterrent System
VSC and Tire Pressure Warning System
Wireless Door Lock Control226
266
208
180
200
10AH-LP LH UPRHeadlight (w/ Daytime Running Light)
Headlight (w/o Daytime Running Light)11 8
122
10AH-LP RH UPRHeadlight (w/ Daytime Running Light)
Headlight (w/o Daytime Running Light)11 8
122
10AHORNHorn
Theft Deterrent System242
208
15AHAZARDTrailer Towing
Turn Signal and Hazard Warning Light152
130
15ASECURITYTheft Deterrent System208
20AEFI NO.1
Cruise Control (2AZ-FE)
Cruise Control (3MZ-FE)
Electronically Controlled Transmission and A/T Indicator (2AZ-FE)
Electronically Controlled Transmission and A/T Indicator (3MZ-FE)
Engine Control (2AZ-FE)
Engine Control (3MZ-FE)172
164
11 0
102
88
74
20APOWER OUTLET2Power Outlet246
20ATOWINGTrailer Towing152
25ADOOR LOCK
Door Lock Control
Theft Deterrent System
Wireless Door Lock Control194
208
200
25ARAD NO.1Audio System (6 Speaker)
Audio System (8 Speaker)280
272
40AMAIN
Automatic Light Control
Headlight (w/ Daytime Running Light)
Headlight (w/o Daytime Running Light)
Light Auto Turn Off System
Theft Deterrent System146
11 8
122
148
208
instrument Panel J/B (See Page 28)
FuseSystemPage
7.5AIG1
Automatic Glare-Resistant EC Mirror
Automatic Light Control
Back-Up Light
Cruise Control (2AZ-FE)
Cruise Control (3MZ-FE)
Door Lock Control
Electronically Controlled Transmission and A/T Indicator (2AZ-FE)
Electronically Controlled Transmission and A/T Indicator (3MZ-FE)
Front Fog Light264
146
134
172
164
194
11 0
102
126
*These are the page numbers of the first page on which the related system is shown.

2005 HIGHLANDER (EWD592U)
327
J
FuseSystemPage
7.5AIG1
Headlight (w/ Daytime Running Light)
Headlight (w/o Daytime Running Light)
Interior Light
Key Reminder and Seat Belt Warning
Light Auto Turn Off System
Mirror Heater and Front Deicer
Moon Roof
Navigation System
Power Outlet
Power Window
Seat Heater
SRS
Theft Deterrent System
Trailer Towing
Turn Signal and Hazard Warning Light
Wireless Door Lock Control11 8
122
136
226
148
254
216
266
246
188
256
155
208
152
130
200
7.5AOBDEngine Control (2AZ-FE)
Engine Control (3MZ-FE)88
74
7.5APANELIllumination142
7.5ARAD NO.2
Air Conditioning (Automatic A/C)
Air Conditioning (Manual A/C)
Audio System (6 Speaker)
Audio System (8 Speaker)
Automatic Light Control
Door Lock Control
Headlight (w/ Daytime Running Light)
Headlight (w/o Daytime Running Light)
Interior Light
Key Reminder and Seat Belt Warning
Navigation System
Power Window
Remote Control Mirror
Shift Lock
Theft Deterrent System
Wireless Door Lock Control298
304
280
272
146
194
11 8
122
136
226
266
188
240
232
208
200
10AECU-IG
Charging
Navigation System
Shift Lock
Theft Deterrent System
VSC and Tire Pressure Warning System70
266
232
208
180
10AHEATER
Air Conditioning (Automatic A/C)
Air Conditioning (Manual A/C)
Charging
Combination Meter298
304
70
282
*These are the page numbers of the first page on which the related system is shown.

2005 HIGHLANDER (EWD592U)
328
J POWER SOURCE (Current Flow Chart)
FuseSystemPage
10AHEATER
Cruise Control (2AZ-FE)
Cruise Control (3MZ-FE)
Electronically Controlled Transmission and A/T Indicator (2AZ-FE)
Electronically Controlled Transmission and A/T Indicator (3MZ-FE)
Engine Control (2AZ-FE)
Engine Control (3MZ-FE)
Interior Light
Key Reminder and Seat Belt Warning
Mirror Heater and Front Deicer
Navigation System
Radiator Fan and Condenser Fan (2AZ-FE)
Radiator Fan and Condenser Fan (3MZ-FE)
Rear Heater
Rear Window Defogger
SRS
VSC and Tire Pressure Warning System172
164
11 0
102
88
74
136
226
254
266
294
290
312
252
155
180
10AIGN
Combination Meter
Cruise Control (2AZ-FE)
Cruise Control (3MZ-FE)
Electronically Controlled Transmission and A/T Indicator (2AZ-FE)
Electronically Controlled Transmission and A/T Indicator (3MZ-FE)
Engine Control (2AZ-FE)
Engine Control (3MZ-FE)
Engine Immobilizer System
SRS
VSC and Tire Pressure Warning System282
172
164
11 0
102
88
74
100
155
180
10ATAIL
Front Fog Light
Taillight
Trailer Towing126
128
152
15ACIGCigarette Lighter244
15AIG2
Engine Control (2AZ-FE)
Engine Control (3MZ-FE)
Starting and Ignition88
74
66
15APWR OUTLET1Power Outlet246
15ARR WIPRear Wiper and Washer224
15ASEAT HTRSeat Heater256
20AD RR DOORPower Window188
20AFR DEFMirror Heater and Front Deicer254
20AFR FOGFront Fog Light126
20AP FR DOOR
Door Lock Control
Interior Light
Power Window194
136
188
*These are the page numbers of the first page on which the related system is shown.

2005 HIGHLANDER (EWD592U)
329
J
FuseSystemPage
20AP FR DOORTheft Deterrent System
Wireless Door Lock Control208
200
20AP RR DOORPower Window188
20AS/ROOFMoon Roof216
20ASTOP
Cruise Control (2AZ-FE)
Cruise Control (3MZ-FE)
Electronically Controlled Transmission and A/T Indicator (2AZ-FE)
Electronically Controlled Transmission and A/T Indicator (3MZ-FE)
Engine Control (2AZ-FE)
Engine Control (3MZ-FE)
Shift Lock
Stop Light
Trailer Towing
VSC and Tire Pressure Warning System172
164
11 0
102
88
74
232
132
152
180
20AWASHERFront Wiper and Washer
Rear Wiper and Washer220
224
25AD FR DOORInterior Light
Power Window136
188
25AWIPERFront Wiper and Washer220
30APOWERPower Seat (Driver's Seat)
Power Seat (Front Passenger's Seat)234
238
40AAM1Power Outlet
Starting and Ignition246
66
*These are the page numbers of the first page on which the related system is shown.

BR3890
- DIAGNOSTICSABS WITH EBD & BA & TRAC & VSC SYSTEM
05-767
957 Author
: Date
:
(b) Clear DTCs.
(1) Using SST, connect terminals Tc and CG of the
DLC3.
SST 09843-18040
(2) Turn the ignition switch to the ON position.
(3) Clear the DTCs stored in the ECU by depressing the
brake pedal 8 or more times within 5 sec.
(4) Check that the ABS warning light and VSC warning
light shows normal blinking patterns.
(5) Remove the SST from the DLC3.
SST 09843-18040
HINT:
Cancellation cannot be preformed by removing the battery
cable or the ECU-IG fuse.
3. DTC CHECK/CLEAR (USING HAND-HELD TESTER)
(a) Check DTCs.
(1) Connect the hand-held tester to the DLC3.
(2) Turn the ignition switch to the ON position.
(3) Read the DTCs following the prompts on the tester
screen.
HINT:
Refer to the hand-held tester operator's manual for further de-
tails.
(b) Clear the DTCs.
(1) Connect the hand-held tester to the DLC3.
(2) Turn the ignition switch to the ON position.
(3) Operate the hand-held tester to erase the codes.
HINT:
Refer to the hand-held tester operator's manual for further de-
tails.
4. DATA LIST
HINT:
According to the DATA LIST displayed on the Hand-held tester, you can read the value and status of the
switch, sensor, actuator and so on without parts removal. Reading the DATA LIST as a first step of trouble-
shooting is one of the methods to shorten the labor time.
(a) Connect the Hand-held tester to the DLC3.
(b) Turn the ignition switch ON.
(c) From the display on the tester, read the ºDATA LISTº.
*: 2WD only
ItemMeasurement Item /
Range (Display)Normal ConditionDiagnostic Note
ABS MOT RELAYABS motor relay / ON or
OFFON : Motor relay ON-
SOL RELAYSolenoid relay / ON or
OFFON : Solenoid relay ON-
VSC / TRC OFF SW*TRAC control switch / ON
or OFFON : TRAC control switch ON-
IDLE SWMain idle switch / ON or
OFF
ON : Accelerator pedal re-
leased
OFF : Accelerator pedal
depressed
-

I30328
w/o Navigation System
I38758
w/ Navigation System
I30337
ECU-B Fuse Engine Room J/B
F46779
- DIAGNOSTICSAIR CONDITIONING SYSTEM
05-1 119
1309 Author
: Date
:
2005 HIGHLANDER REPAIR MANUAL (RM1144U)
(c) If the slower display is desired, press the FRONT DEF
switch and change it to stepped operation. Each time the
FRONT DEF switch is pressed, the display changes by 1
step.
4. CLEARING DTC
(a) To clear diagnostic trouble code, there are 2 ways.
(1) During sensor check, press the FRONT DEF switch
and REAR DEF switch at the same time.
(2) Pull the ECU-B fuse in engine room J/B for 20 sec.
or longer to clear the DTC memory.
5. DTC CHECK USING HAND-HELD TESTER
(a) Connect the hand-held tester to the DLC3.
(b) Power switch ON (ready).
(c) Read the DTC following the prompts on the tester screen.
Please refer to the hand-held tester operator's manual
for further details.
(d) Clear the DTCs.
HINT:
After repairing the malfunctions, clear the DTC.
(1) Connect the hand-held tester to DLC3.
(2) Turn the ignition switch to the ON position.
(3) Erase the DTCs following the prompts on the tester
screen.
HINT:
Refer to the hand-held tester operator's manual for further de-
tails.

To Ignition SW
IG Terminal
Fuse
Voltmeter SW 1
Relay
SW 2Solenoid[A]
[B]
[C]
Ohmmeter
SW
Ohmmeter
Diode
Digital Type Analog Type
2005 HIGHLANDER (EWD592U)
12
C TROUBLESHOOTING
VOLTAGE CHECK
(a)Establish conditions in which voltage is present at the check
point.
Example:
[A] - Ignition SW on
[B] - Ignition SW and SW 1 on
[C] - Ignition SW, SW 1 and Relay on (SW 2 off)
(b)Using a voltmeter, connect the negative lead to a good ground
point or negative battery terminal, and the positive lead to the
connector or component terminal.
This check can be done with a test light instead of a voltmeter.
CONTINUITY AND RESISTANCE CHECK
(a)Disconnect the battery terminal or wire so there is no voltage
between the check points.
(b)Contact the two leads of an ohmmeter to each of the check
points.
If the circuit has diodes, reverse the two leads and check
again.
When contacting the negative lead to the diode positive side
and the positive lead to the negative side, there should be
continuity.
When contacting the two leads in reverse, there should be no
continuity.
(c)Use a volt/ohmmeter with high impedance (10 kW/V
minimum) for troubleshooting of the electrical circuit.

To Ignition SW
IG Terminal
Test Light
Relay Light
SW 2 SolenoidDisconnectShort [A]
Disconnect
DisconnectSW 1Fuse Case
Short [B]
Short [C]
Pull Up
Press Down Press DownPull Up
2005 HIGHLANDER (EWD592U)
13
C
FINDING A SHORT CIRCUIT
(a)Remove the blown fuse and disconnect all loads of the fuse.
(b)Connect a test light in place of the fuse.
(c)Establish conditions in which the test light comes on.
Example:
[A] - Ignition SW on
[B] - Ignition SW and SW 1 on
[C] - Ignition SW, SW 1 and Relay on (Connect the
Relay) and SW 2 off (or Disconnect SW 2)
(d)Disconnect and reconnect the connectors while watching the
test light.
The short lies between the connector where the test light
stays lit and the connector where the light goes out.
(e)Find the exact location of the short by lightly shaking the
problem wire along the body.
CAUTION:
(a) Do not open the cover or the case of the ECU unless
absolutely necessary. (If the IC terminals are touched,
the IC may be destroyed by static electricity.)
(b) When replacing the internal mechanism (ECU part) of
the digital meter, be careful that no part of your body or
clothing comes in contact with the terminals of leads
from the IC, etc. of the replacement part (spare part).
DISCONNECTION OF MALE AND FEMALE
CONNECTORS
To pull apart the connectors, pull on the connector itself, not
the wire harness.
HINT : C h e c k t o s e e w h a t k i n d o f connector you are
disconnecting before pulling apart.