hood release TOYOTA HIGHLANDER HYBRID 2009 XU40 / 2.G Owners Manual

16
Rear view monitor system
(vehicles without navigation
system)
P. 216
Tilt and telescopic steering lock release
lever
P. 108
Glove box P. 373
Pictorial indexInstrument panel
Power back door
main switch
∗ P. 80
Parking brake pedal P. 187
Hood release lever P. 428
Auxiliary box P. 381
Power (ignition) switch P. 178
Multi-information
display
P. 195
Fuel filler door opener P. 118
Fog light switch
Headlight switch
Turn signal lever P. 209
P. 205
P. 186
Windshield wiper and
washer switch
Rear window wiper and
washer switch
P. 210
P. 212
Gauges and
meters
P. 189
Floor mat P. 395
Horn P. 188

428
4-3. Do-it-yourself maintenance
Hood
Release the lock from the inside of the vehicle to open the hood.
Pull the hood release lever.
The hood will pop up slightly.
Lift the auxiliary catch lever
and lift the hood.
Hold the hood open by insert-
ing the supporting rod into
either of the slots.
STEP1
STEP2
STEP3

5
When trouble arises
535
5-2. Steps to take in an emergency
■
Overheating
The following symptoms may occur when your vehicle is overheating:
●Hybrid system output decreases.
● Steam is coming from the engine area.
CAUTION
■To prevent an accident or injury when inspecting under the hood of
your vehicle
●If steam is seen coming from under the hood, do not open the hood until
the steam has subsided. The engine compartment may be very hot, caus-
ing serious injury such as burns.
● With a hybrid vehicle, there are times when the gasoline engine automati-
cally starts to run or the cooling fans suddenly start to operate. Do not
touch or approach the rotating parts of the belt or fans. Doing so may lead
to fingers, clothes or tools getting caught, resulting in an accidental injury.
● Do not loosen the coolant reservoir cap while the hybrid system and radia-
tor are hot.
Serious injury, such as burns, may result from hot coolant and steam
released under pressure.
NOTICE
■When adding engine/power control unit coolant
Wait until the hybrid system has cooled down before adding engine/power
control unit coolant.
When adding coolant, do so slowly. Adding cool coolant to a hot hybrid sys-
tem too quickly can cause damage to the hybrid system.

592
GAS STATION INFORMATION
Auxiliary catch leverP. 428Fuel filler doorP. 1 1 8
Hood release lever P. 4 2 8Fuel filler door opener P. 1 1 8Tire inflation pressure
P. 547
Back door openerP. 7 8
Fuel tank capacity (Reference) 1 7.2 gal. (65.0 L, 14.3 lmp.gal.)
Fuel typeUnleaded gasoline with an Octane Rating
of 87 (Research Octane Number 91)
Cold tire inflation
pressure
P. 5 4 7
Engine oil capacity
Drain and refill
(Reference)qt. (L, Imp.qt.)
Without filter 4.8 (4.5, 4.0)
With filter 5.0 (4.7, 4.1)
Engine oil type Toyota Genuine Motor Oil or equivalent
Oil grade: P. 542
ILSAC multigrade engine oil
Recommended oil viscosity: SAE-5W-20 or SAE-0W-20