belt TOYOTA HILUX 2013 (in English) Owner's Guide

133 1-7. Safety information
1
Before driving
HILUX_OM_OM0K189E_(EE)
CAUTION
Child restraint precautions
Vehicles with SRS side airbags and curtain shield airbags: Do not allow
the child to lean his/her head or any part of his/her body against the door
or the area of the seat, front and rear pillars or roof side rails from which
the SRS side airbags or SRS curtain shield airbags deploy even if the child
is seated in the child restraint system. It is dangerous if the SRS side air-
bags and curtain shield airbags inflate, and the impact could cause death
or serious injury to the child.
Make sure you have complied with all installation instructions provided by
the child restraint manufacturer and that the system is properly secured. If
it is not secured properly, it may cause death or serious injury to the child
in the event of a sudden braking, sudden swerving or an accident.
When children are in the vehicle
Do not allow children to play with the seat belt. If the seat belt becomes
twisted around a child’s neck, it may lead to choking or other serious injuries
that could result in death.
If this occurs and the buckle cannot be unfastened, scissors should be used
to cut the belt.
When the child restraint system is not in use
Keep the child restraint system properly secured on the seat even if it is
not in use. Do not store the child restraint system unsecured in the pas-
senger compartment.
If it is necessary to detach the child restraint system, remove it from the
vehicle. This will prevent it from injuring passengers in the event of a sud-
den braking, sudden swerving or an accident.

134
1-7. Safety information
HILUX_OM_OM0K189E_(EE)
Installing child restraints
Follow the child restraint system manufacturer’s instructions. Firmly
secure child restraints to the seats using a seat belt.
2-point type seat belt (if
equipped)
3-point type seat belts (An
ELR belt requires a locking
clip)

135 1-7. Safety information
1
Before driving
HILUX_OM_OM0K189E_(EE)
Installing child restraints using a seat belt (2-point type seat belt)
(if equipped)
Forward-facing  Child seat
Place the child restraint system
on the rear seat facing the front
of the vehicle.
Run the seat belt through the
child restraint system and insert
the plate into the buckle. Make
sure that the belt is not twisted.
While pushing the child restraint
system down into the seat, allow
the belt to tighten by pulling its
free end until the child restraint
system is securely in place.
STEP1
STEP2
STEP3

136 1-7. Safety information
HILUX_OM_OM0K189E_(EE)
Installing child restraints using a seat belt (3-point type seat belt)
Rear-facing  Baby seat/child seat
Place the child restraint system
on the rear seat facing the rear
of the vehicle.
Run the seat belt through the
child restraint system and insert
the plate into the buckle. Make
sure that the belt is not twisted.
Keep the lap portion of the belt
tight.
Install a locking clip near the
plate of the lap and shoulder belt
by inserting the lap and shoulder
webbing through the recesses of
the locking clip.
STEP1
STEP2
STEP3

137 1-7. Safety information
1
Before driving
HILUX_OM_OM0K189E_(EE)Forward-facing Child seat
Place the child restraint system
on the seat facing the front of the
vehicle.
Run the seat belt through the
child restraint system and insert
the plate into the buckle. Make
sure that the belt is not twisted.
Keep the lap portion of the belt
tight.
Install a locking clip near the
plate of the lap and shoulder belt
by inserting the lap and shoulder
webbing through the recesses of
the locking clip.
STEP1
STEP2
STEP3

138 1-7. Safety information
HILUX_OM_OM0K189E_(EE)Junior seat
Place the child restraint system
on the seat facing the front of the
vehicle.
Sit the child in the child restraint
system. Fit the seat belt to the
child restraint system according
to the manufacturer’s instruc-
tions and insert the plate into the
buckle. Make sure that the belt is
not twisted.
Check that the shoulder belt is
correctly positioned over the
child’s shoulder and that the lap
belt is as low as possible.
(P. 78)
STEP1
STEP2

139 1-7. Safety information
1
Before driving
HILUX_OM_OM0K189E_(EE)
Removing a child restraint installed with a seat belt
2-point type seat belt (if
equipped): Push the buckle
release button.
3-point type seat belt: Push the
buckle release button and fully
retract the seat belt.
When installing a child restraint system in the seat with ELR belt
You need a locking clip to install the child restraint system. Follow the
instructions provided by the manufacturer of the system. If your child
restraint system does not provide a locking clip, you can purchase the fol-
lowing item from any authorized Toyota dealer or repairer, or another duly
qualified and equipped professional.
Locking clip for child restraint system
(Part No. 73119-22010)

142 1-7. Safety information
HILUX_OM_OM0K189E_(EE)
CAUTION
When installing a child restraint system
Vehicles with front bench seat: Do not
install a child restraint system in the
center position. This seat position is not
designed to hold a child restraint sys-
tem.
If used in the center position, depend-
ing on its type, the child restraint sys-
tem may interfere with the proper
usage of the driver’s and front passen-
ger’s seat belts. It may also hamper
your driving.
Extra-cab models: Do not install a child
restraint system on the rear seat.
These seats are not designed to hold a
child restraint system.
Double-cab models: Do not install a
rear-facing child (convertible) seat in
the rear center position. This seat posi-
tion is not designed to hold a rear-fac-
ing child (convertible) seat. Otherwise,
the child or front seat occupant(s) may
be killed or seriously injured in the
event of sudden braking, sudden
swerving or an accident.

143 1-7. Safety information
1
Before driving
HILUX_OM_OM0K189E_(EE)
CAUTION
When installing a child restraint system
If child restraint system regulations exist in the country where you reside,
please contact any authorized Toyota dealer or repairer, or another duly
qualified and equipped professional for the child restraint system installa-
tion.
When a junior seat is installed, always ensure that the shoulder belt is
positioned across the center of the child’s shoulder. The belt should be
kept away from the child’s neck, but not so that it could fall off the child’s
shoulder. Failing to do so may result in death or serious injury in the event
of a sudden braking, sudden swerving or an accident.
Ensure that the belt and plate are securely locked and the seat belt is not
twisted.
Push and pull the child restraint system from side to side and forward to be
sure it is secure.
After securing a child restraint system, never adjust the seat.
Follow all installation instructions provided by the child restraint system
manufacturer.

234 2-5. Driving information
HILUX_OM_OM0K189E_(EE)
CAUTION
Secure all items in the occupant compartment, as they may shift and injure
someone in the event of a sudden braking, sudden swerving or an acci-
dent.
Never allow anyone to ride in the rear deck. It is not designed for passen-
gers. They should ride in their seats with their seat belts properly fastened.
Otherwise, they are much more likely to suffer death or serious bodily
injury, in the event of a sudden braking, sudden swerving or an accident.
Load and distribution
Do not overload your vehicle.
Do not apply loads unevenly.
Improper loading may cause deterioration of steering or braking control
which may cause death or serious injury.