clock TOYOTA IQ 2012 User Guide

338 4-3. Do-it-yourself maintenance
iQ_WE_74014E1NR-FE engine
Make sure to check the oil type and prepare the items needed before
adding oil.
Remove the oil filler cap, turning it counterclockwise.
Add engine oil slowly.
Checking the dipstick.
Reinstall the filler cap, turning it clockwise.
The approximate quantity of oil needed to raise the level between low and
full on the dipstick is indicated as follows:
1.5 L (1.6 qt., 1.3 Imp.qt.)
Engine oil selectionP. 4 5 0
Items Clean funnel

375 4-3. Do-it-yourself maintenance
4
Maintenance and care
iQ_WE_74014ETurn the cover clockwise.
Turn the bulb base counterclock-
wise.
Unplug the connector while
depressing the lock release.
When installing, reverse the steps listed.

376 4-3. Do-it-yourself maintenance
iQ_WE_74014ERight side
Pinch the latches and remove
the washer inlet from the
bracket.
Press the claw and remove
the washer inlet from the
bracket.
Turn the cover counterclockwise.

377 4-3. Do-it-yourself maintenance
4
Maintenance and care
iQ_WE_74014ETurn the bulb base counterclock-
wise.
Unplug the connector while
depressing the lock release.
When installing, reverse the steps listed.
Front fog lights (if equipped)
Remove the front spats bolts.

378 4-3. Do-it-yourself maintenance
iQ_WE_74014ERemove the fender liner clip.
Slide off the fender liner.
Unplug the connector while
depressing the lock release.
Turn the bulb counterclockwise.
When installing, reverse the steps listed.

379 4-3. Do-it-yourself maintenance
4
Maintenance and care
iQ_WE_74014EFront position lights
Turn the bulb base counterclock-
wise.
Remove the light bulb.
When installing, reverse the steps listed.

380 4-3. Do-it-yourself maintenance
iQ_WE_74014EFront turn signal lights
Turn the bulb base counterclock-
wise.
Remove the light bulb.
When installing, reverse the steps listed.

381 4-3. Do-it-yourself maintenance
4
Maintenance and care
iQ_WE_74014EBack-up lights/rear fog light, tail/stop lights and rear turn sig-
nal lights
Open the back door and remove
the cover.
Use a flathead screwdriver which
is wrapped with a cloth.
Turn the bulb bases counter-
clockwise.
Tail/stop light
Rear turn signal light
Back-up light or rear fog light
Remove the light bulb.
Tail/stop light
Rear turn signal light
Back-up light or rear fog light
When installing, reverse the steps listed.

382 4-3. Do-it-yourself maintenance
iQ_WE_74014ELicense plate lights
Disengage the claws.
Use a flathead screwdriver which
is wrapped with a cloth.
Remove the license plate light.
Turn the bulb base counterclock-
wise.
Remove the light bulb.

5
411 5-2. Steps to take in an emergency
When trouble arises
iQ_WE_74014E
Emergency repair method
Take out the repair kit from the plastic bag.
Remove the valve cap from the
valve of the punctured tire.
Remove the air release cap from
the hose.
You will use the air release cap
again. Therefore keep it in a safe
place.
Connect the hose to the valve.
Screw the end of the hose clock-
wise as far as possible.