radio TOYOTA LAND CRUISER 2003 J100 Navigation Manual

11 6
2003 Land Cruiser 100 Navigation (OM60A00U)
Audio System
Quick reference for your audio system
Page
1. Audio operation screen display button 117
. . . . . . . . . . . . . . . . . . . . . . .
2. Function switch display screen 118
. . . . . . . . . . . . . . . . . . . . . .
3. Cassette tape slot 125 . . . . . . . . . . . .
4. Frequency turning knob 122 . . . . . . .
5. [Radio mode] Preset tuning 122 . . .
[Tape mode] Side change of
cassette tape 127 . . . . . . . . . . . . . . . .
[DISC mode] Disc selection 131 . . .
6. Traffic function button 123 . . . . . . . . .
7. Mode selectors 118 . . . . . . . . . . . . . . .
8. Stopping and ejecting a cassette tape 125 . . . . . . . . . . . . . . . .
9. [Radio mode] Seek tuning 123 . . . . .
[Tape/DISC mode] Direct access
to a desired program 127/131 . . . . .
10. Turning the system on and adjusting the volume 117 . . . . . . . . .

11 8
2003 Land Cruiser 100 Navigation (OM60A00U)
Push the ”AM”, ”FM”, ”TAPE” or ”DISC”
button to turn on that mode. The selected
mode turns on directly.
Push these buttons if you want to switch from
one mode to another.
If the tape or disc is not set, the cassette play-
er or compact disc player does not turn on.
You can turn off the cassette player by eject-
ing the cassette tape. If the audio system
was previously off, then the entire audio sys-
tem will be turned off when you eject the cas-
sette tape. If another function was previously
playing, it will come on again.
UNG604
UNG605
The switches for radio, cassette tape and
disc player operation are displayed on
the liquid crystal display. Touch them
lightly and directly on the screen.

120
2003 Land Cruiser 100 Navigation (OM60A00U)
UNG608
BASS ”+” or ””: Adjusts low−pitched
tones.
MID ”+” or ””: Adjusts mid −pitched tones.
TREB ”+” or ””: Adjusts high−pitched
tones.
”Front” or ”Rear”: Adjusts sound balance
between the front and rear speakers.
”L” or ”R”: Adjusts sound balance between
the left and right speakers.
”OK”: The previous screen returns. The antenna automatically extends when
the radio is on or the radio RDS system is on,
and retracts when the radio mode is off.
I17003
To adjust the height of the antenna manu-
ally, push the switch.
Clean the antenna mast periodically with a
clean dry cloth.
CAUTION
Before extending the antenna,
confirm
that no one is close enough to get
injured.
NOTICE
 To prevent damage to the antenna,
make sure it is retracted before
driving your vehicle through an
automatic car wash.
 Antenna mast have to be extended
higher than 100 mm (3.94 in) length
when the audio is on. Extend the an-
tenna mast when the radio signal is
weak.
(d) Your radio antenna

122
2003 Land Cruiser 100 Navigation (OM60A00U)
UNG610
Push these buttons to choose either an
AM or FM station.
”AM”, ”FM1”, ”FM2” or ”FM TYPE” appears
on the display.
Turn this knob to step up the station band
or to step down.
Your radio automatically changes to stereo
reception when a stereo broadcast is re-
ceived. ”ST” appears on the display. If the
signal becomes weak, the radio reduces the
amount of channel separation to prevent the
weak signal from creating noise. If the signal
becomes extremely weak, the radio
switches from stereo to mono reception. In
this case, ”ST” disappears from the display.
UNG604
1. Tune in the desired station.
2. Touch one of the station selector
switches (16) and hold it until a beep is
heard. This sets the station to the switch
and the frequency appears on the switch.
Each switch can store FM1, FM2 and AM. To
change the preset station to a different one,
follow the same procedure.
The preset station memory is cancelled
when the power source is interrupted by bat-
tery disconnection or a blown fuse.
Radio operation
(a) Listening to the radio(b) Presetting a station

123
2003 Land Cruiser 100 Navigation (OM60A00U)
Your vehicle has an electronic tuning radio
(ETR). Tune in the desired station using one
of the following methods.
Preset tuning: Touch the switch (1−6) or
push the ”
” or ”” bu tto n of th e ”CH” button
for the station you want. The switch (1 −6) is
highlighted in green and station frequency
appears on the display.
Manual tuning: Turn the ”TUNE” knob brief-
ly. Each time you turn the knob, the radio will
step up or down to another frequency.
Seek t uning: Push the ”” or ”” button of
the ”SEEK” button and hold it until you hear
a beep. The radio will begin seeking up or
down for a station of the nearest frequency
and will stop on reception. Each time you
push the button, the stations will be searched
out one after another.
UNG612
Scan tuning: Touch the ”SCAN” switch
briefly. ”SCAN” appears on the display. The
radio will find the next station up or down the
band, stay there for a few seconds, and then
scan again. To select a station, touch the
”SCAN” switch a second time.
Preset scan tuning: Touch the ”SCAN”
switch and hold it until you hear a beep. ”P.
SCAN” appears on the display. The radio will
tune in the next preset station up or down the
band, stay there for a few seconds, and then
move to the next preset station. To select a
station, touch the ”SCAN” switch a second
time.
TRAF (T raffic) function: A station that reg-
ularly broadcasts traffic information is
automatically sought.
When you push the ”TRAF” button, ”TRAF
SEEK” appears on the display and the radio
will start seeking any traffic program station.
If any traffic program station is not found,
”NOTHING” appears and the previous mode
returns.
If the traffic program station is found, the
name for traffic program station is displayed
and ”TRAF” is lit for a while until traffic an-
nouncement is received.
(c) Selecting a station(d) RDS (Radio Data System)

124
2003 Land Cruiser 100 Navigation (OM60A00U)
UNG615
When you touch the ”RDS SRCH” switch
during FM reception, ”RDS SEARCH” ap-
pears and the radio starts to search RDS sta-
tion.
If any RDS station cannot be found, ”NO
RDS Stations Found” appears and the pre-
vious mode returns.
If RDS stations are found, the stations are
read and preset by program type. The FM
TYPE mode screen displays the ”** RDS
Stations Found” (** indicates the number of
stations which are found) and then RDS sta-
tions appear in the order of frequency. If in one program type, more than 6 stations
are found, the 6 stations are preset in the or-
der of the lower frequency.
Each time you push the ”
” or ””, the
program type changes as in the following:
 ROCK
 EASY LIS (Easy listening)
 CLS/JAZZ (Classical music and Jazz)
 R&B (Rhythm and Blues)
 INFORM (Information)
 RELIGION
 MISC.
 ALERT (Emergency message)
UNG617
If ”MSG” appears during FM reception,
touching the ”MSG” switch displays the mes-
sage display screen which indicates the text
message from the RDS station.
(e) TYPE (Program type)(f) Radio text message

125
2003 Land Cruiser 100 Navigation (OM60A00U)
UNG618
If a new message is received with the first
text message on the display, ”MSG” appears
on the corner of the screen again. When you
touch the ”LATEST MESSAGE” switch, the
new message appears.
The RDS audio system can store three mes-
sages consisting of 64 characters in
memory. To store a message in memory,
touch the ”STORE” switch until you hear a
beep.
If 3 messages are already stored in memory,
the oldest message will be overwritten by the
new message. To recall a radio text message, touch the
”RECALL”
switch. Each time you touch the
switch, the available messages will be dis-
played beginning with the newest one.
When you touch the ”OK” switch, the pre-
vious screen returns.
unc614
When you insert a cassette tape, the ex-
posed tape should face to the right.
The player will automatically start when you
insert a cassette tape. At this time, ”Tape”
appears on the display.
If a metal or chrome equivalent cassette tape
is put in the cassette player, the player will
automatically recognize it and ”MTL” ap-
pears on the display.
To stop or eject the cassette tape, push the
”
” button.
Cassette tape player
o
peration
(a) Playing a cassette tape

146
2003 Land Cruiser 100 Navigation (OM60A00U)
Manufactured under license from Dolby
Laboratories. “Dolby”, “Pro Logic”, and
the doubleD symbol are trademarks of
Dolby Laboratories. Confidential unpub-
lished works.
19921997 Dolby Laboratories. All
rights reserved.
This product incorporates copyright
protection technology that is protected
by method claims of certain U.S. patents
and other intellectual property rights
owned by Macrovision Corporation and
other rights owners. Use of this copyright
protection technology must be autho-
rized by Macrovision Corporation, and is
intended for home and other limited view-
ing uses only unless otherwise autho-
rized by Macrovision Corporation. Re-
verse engineering or disassembly is
prohibited.
“DTS” is a trademark of Digital Theater
Systems, Inc.
NOTICE
To ensure correct audio/video system
operation:
 Be careful not to spill beverages
over the audio system.
 Do not put anything other than a cas-
sette tape or magazine into the cas-
sette tape slot or DVD player.
 The use of a cellular phone inside or
near the vehicle may cause a noise
from the speakers of the audio
system which you are listening to.
However, this does not indicate a
malfunction.
Radio reception
Usually, the problem with radio reception
does not mean there is a problem with your
radio − it is just the normal result of conditions
outside the vehicle. For example, nearby buildings and terrain
can interfere with FM reception.
Power lines
or telephone wires can interfere with AM sig-
nals. And of course, radio signals have a lim-
ited range, and the farther you are from a sta-
tion, the weaker its signal will be. In addition,
reception conditions change constantly as
your vehicle moves.
Here are some common reception problems
that probably do not indicate a problem with
your radio:
FM
Fading and drifting stations − Generally,
the effective range of FM is about 40 km (25
miles). Once outside this range, you may no-
tice fading and drifting, which increase with
the distance from the radio transmitter. They
are often accompanied by distortion.
Multipath − FM signals are reflective, mak-
ing it possible for two signals to reach your
antenna at the same time. If this happens,
the signals will cancel each other out, caus-
ing a momentary flutter or loss of reception.
Static and fluttering − These occur when
signals are blocked by buildings, trees, or
other large objects. Increasing the bass lev-
el may reduce static and fluttering.
Car audio/video system
o
perating hints

147
2003 Land Cruiser 100 Navigation (OM60A00U)
Station swapping − If the FM signal you are
listening to is interrupted or weakened, and
there is another strong station nearby on the
FM band, your radio may tune in the second
station until the original signal can be picked
up again.
AM
Fading − AM broadcasts are reflected by the
upper atmosphere − especially at night.
These reflected signals can interfere with
those received directly from the radio station,
causing the radio station to sound alternately
strong and weak.
Station interference − When a reflected sig-
nal and a signal received directly from a radio
station are very nearly the same frequency,
they can interfere with each other, making it
difficult to hear the broadcast.
Static − AM is easily affected by external
sources of electrical noise, such as high ten-
sion power lines, lightening, or electrical mo-
tors. This results in static.
Caring for your cassette player and tapes
For high performance from your cassette
player and tapes:
Clean the tape head and other parts regular-
ly. 
A dirty tape head or tape path can de-
crease sound quality and tangle your cas-
sette tapes. The easiest way to clean
them is by using a cleaning tape. (A wet
type is recommended.)
Use high −quality cassettes:
 Low−quality cassette tapes can cause
many problems, including poor sound, in-
consistent playing speed, and constant
auto−reversing. They can also get stuck
or tangled in the cassette player.
 Do not use a cassette if it has been dam-
aged or tangled or if its label is peeling off.
 Do not leave a cassette in the player if you
are not listening to it, especially if it is hot
outside.
 Store cassettes in their cases and out of
direct sunlight.
 Avoid using cassettes with a total playing
time longer than 100 minutes (50 minutes
per side). The tape used in these cas-
settes is thin and could get stuck or
tangled in the cassette player. Caring for your DVD player and discs

The player is intended for use with 12 cm
(4.7 in.) discs only.
 Extremely high temperature can keep
your DVD player from working. On hot
days, use air conditioning to cool the ve-
hicle interior before you listen to a disc.
 Bumpy roads or other vibrations may
make your multi
−disc player skip.
 I

f moisture gets into your DVD player, you
may not hear any sound even though your
DVD player appears to be working. Re-
move the magazine from the player and
wait until it dries.
CAUTION
DVD players use an invisible laser
beam which could cause hazardous
radiation exposure if directed outside
the unit. Be sure to operate the player
correctly.

160
2003 Land Cruiser 100 Navigation (OM60A00U)
Audio mode changeRadio operation
Tape operation
Command
Radio
AM
FM
FM 1
FM 2
DVD Changer
CD Changer 1*
CD Changer 2*
Cassette
Tape
Audio On
Audio Off
Action
Changes to Radio mode.
Changes to AM mode.
Changes to FM mode.
Changes to FM 1 mode.
Changes to FM 2 mode.
Changes to DVD Changer mode.
Changes to CD Changer 1 mode.
Changes to CD Changer 2 mode.
Changes to Tape Changer mode.
Turns audio on.
Turns audio off.
Command
CommandAction
Action
Seek Up
Seek Down
Fast Forward
Rewind
Reverse
Program
Next Track
Previous Track
Skip Backward Seeks Up.
Seeks
Down.
Fast forwards the tape.
Rewinds the tape.
Reverses the tape.
Plays Next track.
Plays Previous track.
Plays Skip backward.
* The command can be used only when you connect the other CD changer.