service reset TOYOTA LAND CRUISER 2003 J100 Navigation Manual

6
2003 Land Cruiser 100 Navigation (OM60A00U)
You can find your destination using various
methods. See page 7 through 22 for the de-
tailed steps.
1. By Home (
switch on the Destina-
tion screen): You can select your own home
without entering the address each time. In
this case, it is necessary to register your
home beforehand. See page 7 for the de-
tailed steps.
2. By Preset destination (
— switches on the Destination screen): Yo u
can select one of 5 preset destinations di-
rectly. In this case, it is necessary to register
the destinations beforehand. See page 7
for the detailed steps.
3. By Address: You can input the house
number and the street address by using the
input keys. See page 8 for the detailed
steps.
4. By Point of Interest: You can select one
of the many points of interest that have been
already stored in the system’s database.
There are more than 50 categories to choose
from including restaurants, banks and auto-
motive places. See page 10 for the detailed
steps. 5. By Marked point:
You can register your
own favorite destinations as a “Marked
Point”. The system allows you to store up
100 marked points. See page 17 for the de-
tailed steps.
6. By Previous destination: You can select
a destination from any of the last 20 pre-
viously set destinations. See page 17 for the
detailed steps.
7. By Emergency: You can select one of the
three points of emergency service points
that have been already stored in the sys-
tem’s database. See page 18 for the detailed
steps.
8. By Intersection: Yo u c a n e n t e r t h e
names of two intersecting streets. This is
helpful if you do not know the specific street
address of your destination but know the
general vicinity. See page 19 for the detailed
steps.
9. By Freeway Entrance/Exit: You can en-
ter the name of the freeway (interstate) en-
trance or exit. See page 20 for the detailed
steps.
10. By Previous starting point: You can en-
ter a point where the system has started to
guide last time. See page 21 for the detailed
steps. 11. By Map selection: You can select a des-
tination simply by touching the location on
the displayed map. See page 22 for the de-
tailed steps.
INFORMATION

When inputting the destination, the
response to the switch may be slow.
 “Points of interest” registration is
made based on the NAVTECH “Stan-
dard POI Inclusion List” and infoU-
SA POI data.
 If there is no point registered,
switches such as “Marked point”,
“Previous destination” or “Previous
starting point” are dimmed and not
available.
 The route for returning may not be
the same as that for going.
 The route guidance to the destina-
tion may not be the shortest route or
a route without traffic congestion.
 Route guidance may not be available
if there is no road data for the speci-
fied location.