glove box TOYOTA LAND CRUISER 2008 J200 Navigation Manual
[x] Cancel search | Manufacturer: TOYOTA, Model Year: 2008, Model line: LAND CRUISER, Model: TOYOTA LAND CRUISER 2008 J200Pages: 268, PDF Size: 7.16 MB
Page 106 of 268
OTHER FUNCTIONS
126
An antenna for the Bluetooth connec-
tion is built in the display. The indica-
tion of the Bluetooth connection may
turn yellow and the system may not
function when you use the Bluetooth
phone in the following conditions and
places.
Your cellular phone is hiding behind the
display (behind the seat or in the glove
box and console box).
Your cellular phone touches or is
covered with metal materials.
Leave the Bluetooth phone on the place
where “Blue” indication is displayed.
Bluetooth is a trademark owned by
Bluetooth SIG, Inc.
When you release your car:
A lot of personal data is registered
when you use the Hands free system.
When you release your car, initialize
your data. (See “(c) Delete personal
data” on page 180.)
If you initialize it, the former state will never
come back again. Pay much attention
when initializing the data.
You can initialize the following data in the
system.
Phone book data
Dialed numbers and received calls
Speed dial
Bluetooth phone data
Security code
FCC ID: BABBT015A
MADE IN JAPAN
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) this device
may not cause harmful interference, and
(2) this device must accept any interfer-
ence received, including interference
that may cause undesired operation.
CAUTION
Changes or modifications not ex-
pressly approved by the party re-
sponsible for compliance could void
the user’s authority to operate the
equipment.
CAUTION: Radio Frequency Radi-
ation Exposure
This equipment complies with FCC
radiation exposure limits set forth for
uncontrolled equipment and meets the
FCC radio frequency (RF) Exposure
Guidelines in Supplement C to OET65.
This equipment has very low levels of
RF energy that it deemed to comply
without maximum permissive expo-
sure evaluation (MPE). But it is desir-
able that it should be installed and op-
erated with at least 20 cm and more be-
tween the radiator and person’s body
(excluding extremities: hands, wrists,
feet and legs).
Co location: This transmitter must
not be co−located or operated in con-
junction with any other antenna or
transmitter.
Page 233 of 268
AIR CONDITIONING
253
If air flow control is not satisfactory,
check the center vents and side vents.
The center vents and side vents may be
opened or closed as shown.(f) Checking and replacing the air
conditioning filter
The air conditioning filter information
label is placed in the glove box as
shown and indicates that a filter has
been installed.
The air conditioning filter prevents dust
from entering the vehicle through the air
conditioning vent.
Page 234 of 268
AIR CONDITIONING
254
The air conditioning filter is behind the
glove box.
The air conditioning filter may clog after
long use. The filter may need to be re-
placed if the air flow of the air conditioner
and heater experiences extreme reduc-
tions in operating efficiency, or if the win-
dows become to fog up easily.
To maintain the air conditioning efficiency,
inspect and replace the air conditioning fil-
ter according to the maintenance sched-
ule. In dusty areas or areas with heavy
traffic flow, such as inner city or desert
areas, early replacement may be required.
(For scheduled maintenance information,
please refer to the “Warranty and Services
Guide/Owner’s Manual Supplement/
Scheduled Maintenance”.)
Before replacing the air conditioning filter,
turn the “ENGINE START STOP” switch
IGNITION ON mode and switch to recircu-
lated air mode, then turn the “ENGINE
START STOP” switch off.1. Open the glove box and remove the
partition.
2. Remove the filter cover.
Page 256 of 268
APPENDIX
276
Make sure the version of the database on
this screen.
To display the disc coverage area, touch
“Covered Area”. Confirm the covered
area on the screen.
Contact your dealer to find out if there is a
more recent update available.
To eject the map disc, open the glove box
and touch the “
DVD” switch.
The glove box must be opened first, or the
disc will come into contact with the glove
box door and be reinserted.