lock TOYOTA LAND CRUISER 2008 J200 Owner's Manual

36 1−2. Opening, closing and locking the doors
*1: A message will be shown on the multi−information display in the instru−
ment cluster.
*2: If the engine does not start when the electronic key is inside the vehicle,
the electronic key battery may be depleted or there may be difficulties
receiving signal front the key. (
P. 481)
nIf the smart key system does not operate properly
l
Locking and unlocking the doors: Use the mechanical key. ( P. 481)
lStarting the engine: P. 150
n
P. 410
nCustomization that can be configured at Toyota dealer
Settings (e.g. smart key system) can be changed. (Customizable features
P. 519)
AlarmSituation Correction procedure
Interior alarm
pings once and
exterior alarm
sounds 3 times
*1
The driver ’s door was
closed after the key was
carried outside the vehicle,
and the “ENGINE START
STOP” switch was not
turned OFFTurn the “ENGINE
START STOP” switch
OFF and close the
driver ’s door again
An occupant carried the
electronic key outside the
vehicle and closed the
door while the “ENGINE
START STOP” switch was
not OFF
Bring the electronic
key back into the vehi−
cle

37
1−2. Opening, closing and locking the doors
1
Before driving
nCertification for the smart key system
NOTE:
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interfer−
ence, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
FCC WARNING:
Changes or modifications not expressly approved by the party responsible
for compliance could void the user ’s authority to operate the equipment.
FCC ID:NI4TMLF−5

38 1−2. Opening, closing and locking the doors

39
1−2. Opening, closing and locking the doors
1
Before driving
CAUTION
nCaution regarding interference with electronic devices
lPeople with implanted pacemakers or cardiac defibrillators should keep
away from the smart key system antennas. (
P. 28)
The radio waves may affect the operation of such devices. If necessary,
the smart key system can be disabled. Ask your Toyota dealer for details,
such as the frequency of radio waves and timing of emitting the radio
waves. Then, consult your doctor to see if you should disable the smart
key system.
lUsers of any electrical medical device other than implanted pacemakers
and implanted cardiac defibrillators should consult the manufacturer of the
device for information about its operation under the influence of radio
waves. Radio waves could have unexpected effects on the operation of
such medical devices.
Ask your Toyota dealer for details for disabling the smart key system.

40
1−2. Opening, closing and locking the doors
Wireless remote control
The wireless remote control can be used to lock and unlock the vehi
cle.
Locks all doors
Unlocks all doors
Opens the windows and
moon roof (press and hold)
Sounds alarm
(press and hold) (
P. 97)
1
2
4
3
ITY12C025

41
1−2. Opening, closing and locking the doors
1
Before driving
n2step unlocking function
When you press the button, the driver ’s door is unlocked. Pressing
the button again within 3 seconds unlocks the other doors.
nOperation signals
Doors: A buzzer sounds and the emergency flashers flash to indicate that
the doors have been locked/unlocked. (Locked: Once; Unlocked: Twice)
Windows and moon roof: A buzzer s
ounds when the windows and moon roof
begin to open.
n
P. 3 0
n
P. 3 3
nAlarm
Using the wireless remote control to lock the door will set the alarm system.
(P. 97)
n
P. 481
nIf the wireless remote control does not operate properly
l
Locking and unlocking the doors: Use the mechanical key. ( P. 481)
lStarting the engine: ( P. 149)
n
P. 410
n
P. 3 0
nCustomization that can be configured at Toyota dealer
Settings (e.g. 2−step unlocking function) can be changed. (Customizable
features
P. 519)

42 1−2. Opening, closing and locking the doors
nCertification for wireless remote control
NOTE:
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interfer−
ence, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
NOTICE:
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part
15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. How−
ever, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
lReorient or relocate the receiving antenna.
lIncrease the separation between the equipment and receiver.
lConnect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
lConsult the dealer or an experienced radio/TV technician for help.
FCC WARNING:
Changes or modifications not expressly approved by the party responsible
for compliance could void the user ’s authority to operate the equipment.
FCC ID:HYQ14AAB
FCC ID:HYQ13BZS

43
1
1−2. Opening, closing and locking the doors
Before driving
Side doors
The vehicle can be locked and unlocked using the smart key system,
wireless remote control
or door lock switch.
n
P. 2 6
n
P. 4 0
n
Door lock switch
Locks all doors
Unlocks all doors
nInside lock button
Locks the door
Unlocks the door
The front doors can be opened
by pulling the inside handles
even if the lock buttons are in
the lock position.

44 1−2. Opening, closing and locking the doors
Locking the driver ’s doors from the outside without a key
Move the inside lock button to the lock position.
Close the door.
The door cannot be locked if the “ENGINE START STOP” switch is in
ACCESSORY or IGNITION ON mode, or the electronic key is left
inside the vehicle.
The key may not be detected correctly and the door may be locked.
Rear door childprotector lock
The door cannot be opened from
inside the vehicle when the locks
are set.
These locks can be set to prevent
children from opening the rear
doors. Press down rear door
switches to lock the rear doors.
STEP1
STEP 2
ITY12C032

45
1−2. Opening, closing and locking the doors
1
Before driving
Automatic door locking and unlocking systems
The following functions can be set or canceled:
nSetting and canceling the functions
To switch between setting and canceling, follow the procedure
below:
Close all the doors and switch the “ENGINE START STOP”
switch IGNITION ON mode. (Perform step 2 within 20 sec−
onds.)
Shift the shift lever to “P” or “N”,
press and hold the driver ’s door
lock switch (
or) for 5 sec−
onds then release.
The shift lever and switch posi−
tions corresponding to the
desired function to be set or can−
celed are shown as follows.
Function Operation
Shift position linked
door locking functionShifting the shift lever out of “P” locks all
doors.
Shift position linked
door unlocking functionShifting the shift lever to “P” unlocks all
doors.
Speed linked door lock−
ing functionAll doors are locked when the vehicle speed is
approximately 12 mph (20 km/h) or higher.
Driver ’s door linked door
unlocking function
All doors are unlocked when the driver ’s door
is opened within 10 seconds after turning the
“ENGINE START STOP” switch OFF.
STEP1
STEP 2