ECO mode TOYOTA LAND CRUISER 2008 J200 Owners Manual

33
1−2. Opening, closing and locking the doors
1
Before driving
nNote for the smart key system
lEven when the electronic key is within the effective range (detection
areas), the system may not operate properly in the following cases.
The electronic key is too close to the window or outside door handle,
near the ground, or in a high place when the doors are locked or
unlocked.
The electronic key is near the ground or in a high place, or too close to
the rear bumper center when the back door is locked or unlocked.
The electronic key is on the instrument panel, floor or in the glove box
when the engine is started or “ENGINE START STOP” switch modes
are changed.
lAs long as the electronic key is within the effective range, the doors may
be locked or unlocked by anyone.
lEven if the electronic key is not inside the vehicle, it may be possible to
start the engine if the electronic key is near the window.
lThe doors may unlock if a large amount of water splashes on the door
handle, such as in the rain or in a car wash. (The doors will automatically
be locked after approximately 60 seconds if the doors are not opened
and closed.)
lGripping the door handle when wearing a glove may not unlock the door.
lIf the wireless remote control is used to lock the doors when the elec−
tronic key is near the vehicle, there is a possibility that the door may not
be unlocked by the smart key system. (Use the wireless remote control to
unlock the doors.)
lA sudden approach to the effective range or door handle operation may
prevent the doors from being unlocked.
In this case, return the door han−
dle to the original position and check that the doors unlock before pulling
the door handle.
nWhen the vehicle is not driven for extended periods
To prevent theft of the vehicle, do not leave the electronic key within 6 ft. (2
m) of the vehicle.
nSecurity feature
If a door is not opened within approximately 60 seconds after the vehicle is
unlocked, the security feature automatically locks the vehicle again.

34 1−2. Opening, closing and locking the doors
nAlarms and warning indicators
A combination of exterior and interior alarms as well as warnings displayed
on the multi−information display are used to prevent theft of the vehicle and
unforeseeable accidents resulting from erroneous operation. Perform the
appropriate correction procedure de
scribed in the following table.
AlarmSituation Correction procedure
Exterior alarm
sounds once for
2 secondsAn attempt was made to
lock the doors using the
entry function while the
electronic key was still
inside the passenger com−
partmentRetrieve the elec−
tronic key from the
passenger compart−
ment and lock the
doors again
Exterior alarm
sounds once for
60 secondsAn attempt was made to
exit the vehicle and lock
the doors without first turn−
ing the “ENGINE START
STOP” switch OFFTurn the “ENGINE
START STOP” switch
OFF and lock the
doors again
Exterior alarm
sounds once for
10 secondsAn attempt was made to
lock the vehicle while a
door is openClose all of the doors
and lock the doors
again
Interior alarm
pings continu−
ously
*1
The “ENGINE START
STOP” switch was turned
to ACCESSORY mode
while the driver ’s door was
open (or the driver ’s door
was opened while the
“ENGINE START STOP”
switch was in ACCES−
SORY mode)Turn the “ENGINE
START STOP” switch
OFF and close the
driver ’s door
The “ENGINE START
STOP” switch was turned
OFF while the driver ’s door
was open
Close the driver ’s
door

45
1−2. Opening, closing and locking the doors
1
Before driving
Automatic door locking and unlocking systems
The following functions can be set or canceled:
nSetting and canceling the functions
To switch between setting and canceling, follow the procedure
below:
Close all the doors and switch the “ENGINE START STOP”
switch IGNITION ON mode. (Perform step 2 within 20 sec−
onds.)
Shift the shift lever to “P” or “N”,
press and hold the driver ’s door
lock switch (
or) for 5 sec−
onds then release.
The shift lever and switch posi−
tions corresponding to the
desired function to be set or can−
celed are shown as follows.
Function Operation
Shift position linked
door locking functionShifting the shift lever out of “P” locks all
doors.
Shift position linked
door unlocking functionShifting the shift lever to “P” unlocks all
doors.
Speed linked door lock−
ing functionAll doors are locked when the vehicle speed is
approximately 12 mph (20 km/h) or higher.
Driver ’s door linked door
unlocking function
All doors are unlocked when the driver ’s door
is opened within 10 seconds after turning the
“ENGINE START STOP” switch OFF.
STEP1
STEP 2

62
1−3. Adjustable components (seats, mirrors, steering wheel)
Driving position memor y system
Your preferred driving position (th e position of the driver ’s seat,
steering wheel and outside rear view mirrors) can be entered into the
computer ’s memory and recalled with
the touch of a button. It is also
possible to set this function to activate automatically when the
doors are unlocked.
Three different driving positions can be entered into memory.
nEntering a position to memory
Check that the shift lever is set in “P”.
Switch to IGNITION ON mode.
Adjust the driver ’s seat, steering wheel, and outside rear
view mirrors to the desired positions.
While pressing the “SET” but−
ton, press button “1”, “2” or “3”
until the signal beeps.
If the selected button has
already been preset, the previ−
ously recorded position will be
overwritten.
nRecalling the memorized position
Check that the shift lever is set in “P”.
Switch to IGNITION ON mode.
Press button “1”, “2” or “3” to
recall the desired position.
STEP1
STEP 2
1SET23
1SET23
ITY13C036
STEP3STEP 3
STEP 1
1SET23
1SET23
ITY13C038
STEP2

81
1−3. Adjustable components (seats, mirrors, steering wheel)
1
Before driving
nWhen the mirrors are fogged up
Turn on the outside rear view mirror defoggers to defog the mirrors.
(P. 256)
nAuto antiglare function
When the anti−glare inside rear view mirror is set to auto mode, the outside
rear view mirrors will activate in conjunction with the anti−glare inside rear
view mirror to reduce reflected light. (
P. 79)
nLinked mirror function when reversing
The outside rear view mi rrors will automatically angle downwards when the
vehicle is reversing in order to give a better view of the ground. However,
this function will not operate when the mirror select switch is in the neutral
position (between “L” and “R”).
nOnetouch adjustment of the mirror angle
A desired mirror face angle can be entered to memory and adjusted with the
touch of a button. (
P. 62)
CAUTION
nWhile driving
Observe the following precautions.
Failing to do so may result in losing control of the vehicle and cause an acci−
dent, resulting in death or serious injury.
lDo not adjust the mirrors.
lDo not drive with the mirrors folded back.
lBefore driving, be sure to extend mirrors and make an adjustment prop−
erly.
n
When the mirror defoggers are operating
Do not touch the mirror surface as the mirror surface becomes hot.

84 1−4. Opening and closing the windows and moon roof
nThe power windows can be operated when
The “ENGINE START STOP” switch is in IGNITION ON mode.
nLinked door lock window operation
lThe power windows can be opened and closed using the mechanical
key. ( P. 43)
lThe power windows can be opened using the wireless remote control.
(P. 40)
lThe power windows can be closed using the smart key system.
nOperating the power windows after turning the “ENGINE START STOP”
switch OFF
The power windows can be operated for approximately 45 seconds even
after the “ENGINE START STOP” switch is turned ACCESSORY mode or
turned OFF. They cannot, however, be operated once the driver ’s or front
passenger ’s door is opened.
nJam protection function
If an object becomes caught between the window and the window frame,
window travel is stopped and the window is opened slightly.
nCustomization that can be configured at Toyota dealer
Settings (e.g. linked door lock operation) can be changed. (Customizable
features P. 519)

87
1−4. Opening and closing the windows and moon roof
1
Before driving
nThe moon roof can be operated when
The “ENGINE START STOP” switch is in IGNITION ON mode.
nLinked door lock moon roof operation
lThe moon roof can be opened and closed using the mechanical key.
(P. 43)
lThe moon roof can be opened using the wireless remote control.
(P. 40)
lThe moon roof can be closed using the smart key system.
n
Operating the moon roof after tu rning the “ENGINE START STOP”
switch OFF
The moon roof can be operated for approximately 45 seconds even after the
“ENGINE START STOP” switch is turned to ACCESSORY mode or turned
OFF. It cannot, however, be operated once the driver ’s or front passenger ’s
door is opened.
nJam protection function
If an object is detected between the moon roof and the frame while closing
or tilting down, travel is stopped and the moon roof opens slightly.
nIf the moon roof cannot be closed automatically
Keep the switch depressed.
nTo reduce moon roof wind noise
Drive with the moon roof opened automatically (just before fully opened
position).
nSunshade
The sunshade can be opened and closed manually. However, the sunshade
will open automatically when the moon roof is opened.

98 1−6. Theft deterrent system
nItems to check before locking the vehicle
To prevent unexpected triggering of the alarm and vehicle theft, make sure
of the following.
lNobody is in the vehicle.
lThe windows and moon roof are closed before the alarm is set.
lNo valuables or other personal items are left in the vehicle.
nTriggering of the alarm
The alarm may be triggered in the following situations.
(Stopping the alarm deactivates the alarm system.)
lA person inside the vehicle opens a door or hood.
lThe battery is recharged or replaced when the vehicle is locked.
n
Panic mode
nDeactivating or stopping the alarm
Do one of the following to deactivate or stop the alarm.
lUnlock the doors using the smar t key system or the wireless
remote control.
lStart the engine. (The alarm will be deactivated or stopped after
a few seconds.)
When is pressed for longer than
about one second, the headlights/tail
lights/emergency flashers will flash, the
front and rear interior lights will come on,
and an alarm will sound for about 60 sec−
onds to deter any person from trying to
break into or damage your vehicle.
To stop the alarm, press any button on
the wireless remote control.

152 2−1. Driving procedures
CAUTION
nWhen starting the engine
Always start the engine while sitting in the driver ’s seat. Do not depress the
accelerator while starting the engine under any circumstances.
Doing so may cause an accident resulting in death or serious injury.
nCaution when driving
Do not touch the “ENGINE START STOP” switch while driving.
Pressing and holding the “ENGINE START STOP” switch will stop the
engine, which may lead to an unexpected accident.
NOTICE
nTo prevent battery discharge
Do not leave the “ENGINE START STOP” switch in ACCESSORY or IGNI−
TION ON mode for long periods without the engine running.
nWhen starting the engine
lDo not race a cold engine.
l
If the engine becomes difficult to start or stalls frequently, have the engine
checked immediately.

154 2−1. Driving procedures
nShift position uses
*1: To improve fuel consumption and reduce noises, set the shift lever in
the “D” position for normal driving.
*2: By selecting shift ranges using “S” mode, you can control engine brak−
ing forces.
nSelecting a driving mode
The following patterns can be selected to suit current driving and
operating conditions.
Power mode
For powerful acceleration and
driving in mountainous
regions.
Normal mode
Second start mode
For starting on slippery road
surfaces, such as on snow.
Press “2nd” to return to normal
mode.
Shift positionFunction
PParking the vehicle or starting the engine
RReversing
NNeutral
DNormal driving*1
S“S” mode driving *2
ETC PWR2nd
PWR2ndPWR2ndPWR2nd
ECT
PWR2nd
STRT
ITY21C007