recommended oil TOYOTA LAND CRUISER 2008 J200 Owners Manual

367
4−2. Maintenance
4
Maintenance and care
General maintenance
Engine compartment
Items Check points
BatteryMaintenance−free (
P. 387)
Brake fluidAt the correct level? (
P. 384)
Engine coolantAt the correct level? (
P. 382)
Engine oilAt the correct level? (
P. 377)
Exhaust systemNo fumes or strange sounds?
Power steering fluidAt the correct level? (
P. 386)
Radiator/condenser/hosesNot blocked with foreign matter?
( P. 383)
Washer fluidAt the correct level? (
P. 338)
Listed below are the general maintenance items that should be per
formed at the intervals specified
in the “Owner ’s Warranty Informa
tion Booklet”, “Owner ’s Manual Supplement”. It is recommended
that any problem you notice should be brought to the attention of
your Toyota dealer or qualified service shop for advice.

379
4−3. Do−it−yourself maintenance
4
Maintenance and care
nRecommended viscosity
SAE 5W−20 or 0W−2 0 engine oil
may be used. However, SAE
0W−20 is the best choice for
good fuel economy and good
starting in cold weather.
nHow to read oil container labels
The ILSAC (International Lubricant Standardization and Approval
Committee) Certification Mark is added to some oil containers to
help you select the
oil you should use.
Outside temperature

497
6−1. Specifications
6
Vehicle specifications
Lubrication system
Oil viscosity:
l
The 0W portion of the oil viscosity rating indicates the characteristic
of the oil which allows cold startab ility. Oils with a lower value before
the W allow for easier starting of the engine in cold weather.
lThe 20 in 0W−20 indicates the oil viscosity when the oil is as its oper−
ating temperature. An oil with a higher viscosity may be better suited
if the vehicle is operated at high
speeds, or under extreme load con−
dition.
Oil capacity drain and
refill
(Reference)
with filter
without filter7.4 qt. (7.0 L, 6.2 lmp.qt.)
7.0 qt. (6.6 L, 5.8 lmp.qt.)
Oil grade
ILSAC multigrade engine oil
Recommended oil
viscosity
Use Toyota approved “Toyota Genuine Motor Oil”
or equivalent to satisfy the above grade and vis−
cosity.
Outside temperature

500 6−1. Specifications
Automatic transmission
Transfer
Brakes
*1: Minimum pedal clearance when depressed with a force of 110 lbf (490 N, 50
kgf) while the engine is running.
*2: Parking brake pedal travel when pulled with a force of 45 lbf (200 N, 20 kgf).
Fluid
capacityWithout oil cooler11.5 qt. (10.9 L, 9.6 Imp.qt.)
With oil cooler
11.7 qt. (11.1 L, 9.8 Imp.qt.)
Fluid type Toyota Genuine ATF WS
NOTICE
Using transmission fluid other than “Toyota Genuine ATF WS” may cause
deterioration in shift quality, locking up of your transmission accompanied by
vibration, and ultimately damage the transmission of your vehicle.
Oil capacity
1.53 qt. (1.45 L, 1.28 lmp.qt.)
Oil type
Gear oil API GL−5
Recommended oil viscosity
SAE75W−90
Pedal clearance
*13.62 in. (92 mm) Min.
Pedal free play 0.04 0.24 in. (1.0
6.0 mm)
Brake pad wear limit
0.04 in. (1.0 mm)
Parking brake lining wear limit
0.04 in. (1.0 mm)
Parking brake adjustment
*25 7 clicks
Fluid type
SAE J1703 or FMVSS No. 116 DOT 3

512 6−1. Specifications
Warning: The temperature grades for this tire are established for a
tire that is properly inflated and not overloaded.
Excessive speed, underinflation, or
excessive loading, either sepa−
rately or in combination, can cause heat buildup and possible tire fail−
ure.
Glossary of tire terminology
Tire related term Meaning
Cold tire inflation
pressureTire pressure when the vehicle has been
parked for three hours or more, or has not
been driven more than 1 mile or 1.5 km under
that condition
Maximum inflation
pressureThe maximum cold inflated pressure to which a
tire may be inflated, shown on the sidewall of
the tire
Recommended
inflation pressureCold tire inflation pressure recommended by a
manufacturer.
Accessory weightThe combined weight (in excess of those stan−
dard items which may be replaced) of trans−
mission, power steering, power brakes, power
windows, power seats, radio and heater, to the
extent that these items are available as factory−
installed equipment (whether installed or not)
Curb weightThe weight of a motor vehicle with standard
equipment, including the maximum capacity of
fuel, oil and coolant, and if so equipped, air
conditioning and additional weight optional
engine
Maximum loaded
vehicle weight
The sum of:
(a) Curb weight
(b) Accessory weight
(c) Vehicle capacity weight
(d) Production options weight

540
GAS STATION INFORMATION
Auxiliary catch lever
P. 374
Fuel filler door
P. 8 9
Hood lock release lever
P. 374
Fuel filler door opener
P. 8 9
Tire inflation pressure
P. 502
Fuel tank capacity24.6 gal. (93 L, 20.5 lmp.gal.)
Fuel type
Unleaded gasoline only P. 90, 496
Cold tire inflation
pressure
P. 502
Engine oil capacity
drain and refill
(Reference)qt. (L, Imp.qt.)
With filter 7.4 (7.0, 6.2)
Without filter 7.0 (6.6, 5.8)
Engine oil type
“Toyota Genuine Motor Oil” or equivalent
Oil grade: ILSAC multigrade engine oil P. 497
Recommended oil viscosity: SAE 0W−20, 5W−20