ECU TOYOTA LAND CRUISER 2009 J200 Quick Reference Guide
[x] Cancel search | Manufacturer: TOYOTA, Model Year: 2009, Model line: LAND CRUISER, Model: TOYOTA LAND CRUISER 2009 J200Pages: 32, PDF Size: 2.1 MB
Page 5 of 32
3
OVERVIEW
FEATURES/OPERATIONS
SAFETY AND EMERGENCY FEATURES
CD INRAND RPTSCAN ALBDISC FLD ART TR FILE ST MEG TRAFPLDGNPAUTO-P ART4 DISC OF OWNER
TYPE∑DISCAM-GAT
SCAN
FMDISC∑AUXTRAF
00 H
M
LOADTUNE·FILE
CH-DISCFMTA P EPWR·VOL
SEEK-TRACKDISC·AUXSAT
AM4 DISC OF OWNER
SCAN
LOGIC CONTROL DECK
SECURITYCLIMATE
DEST MAVOICEP
MENU
DISP
INFO
A UDIO
Four-wheel drive control switch
VSC/TRAC OFF switch
Center differential lock/unlock switch
Cruise control
Tire Pressure Warning System reset
Power rearview mirror control
Instrument panel light control
Tilt and telescopic steering control
Roll Sensing of Curtain shield Airbag OFF switch
Toyota park assist switch
1
115V AC Power outlet main switch
Headlight cleaner1
1
If equipped2Vehicles with navigation system: for details, refer to the “ Navigation
System Owner’s Manual .”
Without navigation system
With navigation system
M2.qxd 7/28/08 3:14 PM Page 3
Page 15 of 32
13
OVERVIEW
FEATURES/OPERATIONS
SAFETY AND EMERGENCY FEATURES(1) Stow the seat belt buckles and lower the head restraints.
(2) Hook the seat belt to the seat belt hangers.
(3) Fold down the seatback and swing the whole seat up and forward.
(4) Hook the holding strap to the assist grip and secure the seat.
(5) Install the seat hook covers on the seat hooks.
(1)
(5)
(3)
(2)
Seats-Tumbling second row seats
(4)Pull Seat hook cover
Pull
M2.qxd 7/28/08 3:14 PM Page 13
Page 25 of 32
23
OVERVIEW
FEATURES/OPERATIONS
SAFETY AND EMERGENCY FEATURES
Power outlets-12V DC
The “ENGINE START STOP” switch must be in ACCESSORY or IGNITION ON
mode to be used.
Power outlets-115V AC
AC
115VAC11 5V100W
ON/OFF switch
The “ENGINE START STOP” switch must be in IGNITION ON mode to be used.
Garage door openers manufactured under license from HomeLink®* can
be programmed to operate garage doors, estate gates, security lighting, \
etc.
Refer to “Garage door opener,” Section 3-6 in the Owner’s Manualfor
more details.
* HomeLink®is a registered trademark of Johnson Controls, Inc.
Garage door opener (HomeLink®)*
M2.qxd 7/28/08 3:14 PM Page 23
Page 30 of 32
28
SAFETY AND
EMERGENCY FEATURES
If belt is fully extended, then retracted even slightly, it cannot be
re-extended beyond that point, unless fully retracted again. This featur\
e
is used to help hold child restraint systems securely.
To find more information about seat belts, and how to install a child
restraint system, refer to the Owner's Manual.
Keep as low on
hips as possible
Take up slack
Too high
Seat belts
Push up, or squeeze
lock release to lower
System reset initialization
1. Push and hold “ SET” button
until the indicator blinks
three times.
2. Wait a few minutes to allow initialization to complete.
Seat belts-Shoulder belt anchor
After adjusting tire pressures, or after tires have been rotated or
replaced, turn the ignition switch to “ON” and press and hold the \
“ SET” button until indicator blinks three times. Let the vehicle sit f\
or a
few minutes to allow initialization to complete.
Refer to the load label on the door jamb or the Owner’s Manualfor tire
inflation specifications.
If the tire pressure indicator flashes for more than 60 seconds and then\
remains on, take the vehicle to your local Toyota dealer.
Note : The warning light may come on due to temperature changes or
changes in tire pressure from natural air leakage. If the system has not\
been initialized recently, setting the tire pressures to factory
specifications should turn off the light.
Tire Pressure Monitoring (warning)
System
M2.qxd 7/28/08 3:14 PM Page 28