bulb TOYOTA LAND CRUISER 2010 J200 Owners Manual

TABLE OF CONTENTSIndex
4
L/C200_U
3-5. Using the interior lightsInterior lights list ................. 369
• Interior lights .................... 370
• Personal lights ................. 371
3-6. Using the storage features List of storage features....... 372
• Glove box ......................... 373
• Console box ..................... 374
• Overhead console ............ 375
• Cup holders...................... 376
• Bottle holders ................... 377
• Card holders .................... 379
• Auxiliary box..................... 379
3-7. Other interior features Cool box ............................. 380
Sun visors .......................... 382
Vanity mirror ....................... 383
Clock .................................. 384
Outside temperature display .............................. 385
Ashtrays ............................. 386
Cigarette lighter .................. 388
Power outlets ..................... 389
Seat heaters ....................... 391
Armrest............................... 393
Floor mats .......................... 394
Luggage compartment features ............................ 395
Garage door opener ........... 397
Safety Connect................... 404 4-1. Maintenance and care
Cleaning and protecting the vehicle exterior ........... 412
Cleaning and protecting the vehicle interior ............ 415
4-2. Maintenance Maintenance requirements .................... 418
General maintenance ......... 420
Emission inspection and maintenance (I/M)
programs .......................... 423
4-3. Do-it-yourself maintenance Do-it-yourself service precautions ....................... 424
Hood ................................... 427
Engine compartment .......... 428
Tires.................................... 443
Tire inflation pressure ......... 452
Wheels................................ 456
Air conditioning filter ........... 458
Electronic key battery ......... 461
Checking and replacing fuses ................................. 464
Light bulbs .......................... 477
4Maintenance and care

161
2-1. Driving procedures
2
When driving
L/C200_U
Tur n signal lever
■Turn signals can be operated when
The “ENGINE START STOP” switch is in IGNITION ON mode.
■ If the indicators flash faster than usual
Check that a light bulb in the front or rear turn signal lights has not burned
out.
Right turn
Left turn
Move and hold the lever
partway to signal a lane
change
The right hand signal will flash
until you release the lever.
Move and hold the lever
partway to signal a lane
change
The left hand signal will flash
until you release the lever.
ITO21C035

Maintenance and care4
411
L/C200_U
4-1. Maintenance and careCleaning and protecting the vehicle exterior ......... 412
Cleaning and protecting the vehicle interior .......... 415
4-2. Maintenance Maintenance requirements .................. 418
General maintenance....... 420
Emission inspection and maintenance (I/M)
programs ........................ 423
4-3. Do-it-yourself maintenance Do-it-yourself service precautions .................... 424
Hood ................................ 427
Engine compartment ........ 428
Tires ................................. 443
Tire inflation pressure ...... 452
Wheels ............................. 456
Air conditioning filter......... 458
Electronic key battery....... 461
Checking and replacing fuses .............................. 464
Light bulbs........................ 477

476 4-3. Do-it-yourself maintenance
L/C200_U
■After a fuse is replaced
● If the lights do not turn on even after the fuse has been replaced, a bulb
may need replacement. (P. 477)
● If the replaced fuse blows again, have the vehicle inspected by your
Toyota dealer.
■ If there is an overload in the circuits
The fuses are designed to blow the entire wiring harness is damaged.
CAUTION
■To prevent system breakdowns and vehicle fire
Observe the following precautions.
Failing to do so may cause damage, and possibly a fire or injury.
● Never use a fuse of a higher amperage rating than indicated, or use any
other object in place of a fuse.
● Always use a genuine Toyota fuse or equivalent.
Never replace a fuse with a wire, even as a temporary fix.
This can cause extensive damage or even fire.
● Do not modify fuses or the fuse box.
NOTICE
■Before replacing fuses
Have the cause of electrical overload determined and repaired by your
Toyota dealer.

477
4-3. Do-it-yourself maintenance
4
Maintenance and care
L/C200_U
Light bulbs
You may replace the following bulbs yourself. The difficulty level of
replacement varies depending on the bulb. If necessary bulb
replacement seems difficult to perfor m, contact your Toyota dealer.
For more information about replacing other light bulbs, contact your
Toyota dealer.
■ Prepare a replacement light bulb.
Check the wattage of the light bulb being replaced. ( P. 551)
■ Remove the engine compartment cover.
P. 429
■ Front bulb locations
ITY43C074
Front side marker light
Parking light
Front fog light
Headlight
high beam Headlight low beam
Front turn signal light

478 4-3. Do-it-yourself maintenance
L/C200_U
Replacing light bulbs■ Headlight low beam
Turn the bulb base counterclock-
wise.
■Rear bulb locations
ITY43C075
License plate lights
Rear turn signal
light
Back-up light
ITY43C038
STEP1

479
4-3. Do-it-yourself maintenance
4
Maintenance and care
L/C200_U
Unplug the connector while
depressing the lock release.
■ Headlight high beam
Turn the bulb base counterclock-
wise.
Unplug the connector while
depressing the lock release.
ITY43C039
STEP2
ITY43C040
STEP1
ITY43C041
STEP2

480 4-3. Do-it-yourself maintenance
L/C200_U■
Front fog light
Remove the fender liner bolts,
loose the fender liner nut and
remove the fender liner.
Fender liner nut
Fender liner bolts
Turn the bulb base counterclock-
wise.
Unplug the connector while pull-
ing the lock release.
STEP1
ITY43C042
STEP2
ITY43C043
STEP3

481
4-3. Do-it-yourself maintenance
4
Maintenance and care
L/C200_U
■
Parking light
Turn the bulb base counterclock-
wise.
Remove the light bulb.
ITY43C048
STEP1
ITY43C049
STEP2

482 4-3. Do-it-yourself maintenance
L/C200_U■
Front turn signal light
For the left side only: Remove
the securing bolt and move the
washer fluid filler opening.
Turn the bulb base counterclock-
wise.
Remove the light bulb.
ITY43C012
STEP1
ITY43C044
STEP2
ITY43C045
STEP3