ignition TOYOTA LAND CRUISER 2016 J200 Quick Reference Guide

10
FEATURES/OPERATIONS
Automatic Transmission
* The “ENGINE START STOP” switch must be in “IGNITION ON” mo\
de and the brake pedal depressed to shift from Park.
Shift the shift lever to “S” position from “D” position.
+: Upshift (push and release)

-: Downshift (pull and release)
Downshifting increases power going uphill, or provides engine braking do\
wnhill.
For best fuel economy during normal driving conditions, always drive wit\
h the shift
lever in the “D” position.
“S” (Sequential) mode
Park*
Reverse
Neutral
Drive
P
R
N
D
S“S” mode
Auto lock/unlock
Automatic door locks can be programmed to operate in two different modes\
, or
turned OFF.
-Doors lock when shifting from Park.
-Doors lock when the vehicle speed is approximately 12 mph or higher.
-Doors unlock when shifting into Park.
-Doors unlock when the driver’s door is opened within 45 seconds afte\
r turning the
“ENGINE START STOP” switch OFF.
Refer to the Owner’s Manual for more details.
Power modeSecond start mode
For powerful acceleration and driving in
mountainous regions.For starting on slippery surfaces, such
as snowy roads. Press “2nd” to return to
normal mode.

OVERVIEWFEATURES/OPERATIONS TOYOTA SAFETY SENSESAFETY AND EMERGENCY FEATURES
17
Moon roof
Sliding operationTilting operation
OpenTilt
CloseClose
Recommended open position to
minimize wind noise.
Push once to open partway;
again to open completely.
Rear view mirror-Outside
Linked mirror function when reversing
The outside rearview mirrors
automatically angle downwards when vehicle is in reverse. Will only oper\
ate when
switch is in “L” or “R” position. Use switch to adjust mirror
angle while in ACCESSORY
or IGNITION ON mode.

22
Crawl Control
Multi-terrain Monitor
Speed selection switch
LoHi(1)
(2)
Med
Lo-MedMed-Hi
Speed modes
FEATURES/OPERATIONS
Press “” switch while the engine switch is in IGNITION ON mode to check
vehicle surroundings.
Note: The amount of time that the screen is displayed changes according\
to
the vehicle speed at the time the VIEW switch was pressed. Speeds exceed\
ing
approximately 7 mph (12 km/h) will cancel monitor viewing.
For more details, please refer to the Owner’s Manual.
Crawl Control allows travel on extremely rough off-road surfaces at a fi\
xed low
speed without pressing the accelerator or brake pedal. Operating status \
displays
on the MID.
Lo to Lo-Med - Rock, mogul (downhill) and gravel (downhill)
Lo-Med to Med - Mogul (uphill)
Med-Hi - Snow, mud, gravel (uphill), sand, dirt, mogul (uphill) and grass

26
FEATURES/OPERATIONS
COOLBOX
PWR
Cooler box
Push “PWR” button to turn cooler box ON; indicator will illuminate\
.
Indicator
Power outlets-12V DC
The “ENGINE START STOP” switch must be in “ACCESSORY” or “\
IGNITION ON”
mode to be used.
FrontRear
Parking brake
(2) Push
SetRelease
(1) Pull slightly
(3) Lower
Pull
Cup holders
FrontRear

OVERVIEWFEATURES/OPERATIONS TOYOTA SAFETY SENSESAFETY AND EMERGENCY FEATURES
27
Power outlet-120V AC
The “ENGINE START STOP” switch must be in “IGNITION ON” mode\
to be used.
Qi wireless charger
A portable device can be charged by just placing Qi standard wireless ch\
arge
compatible portable devices according to the Wireless Power Consortium, \
such as
smart phones and mobile batteries, etc., on the charge area.
This function cannot be used with portable devices that are larger than \
the
charging area. Also, depending on the portable device, it may not operat\
e as
normal. Please read the Owner’s Manual for portable devices to be use\
d. The power switch must be in ACCESSORY or ON mode.
(1)
Push to open door.Push power supply charging button.
Note: While device is charging, the light is orange.
The light turns green when it is finished.
Place charging side of device on
the charge area.
(2)
(3)

29
OVERVIEWFEATURES/OPERATIONS TOYOTA SAFETY SENSESAFETY AND EMERGENCY FEATURES

Pre-Collision System (PCS)
The Pre-Collision System uses a radar sensor and camera sensor to help d\
etect
vehicles and pedestrians in front of your vehicle. If the system determi\
nes that
the possibility of a frontal collision with a vehicle or pedestrian is h\
igh, the system
warns the driver to take evasive action while the potential brake pressu\
re is
increased to help the driver avoid collision or reduce the impact to the\
vehicle and
it’s occupants.
Note: PCS is enabled each time the engine switch is turned to Ignition On. Th\
e
system can be disabled/enabled and the warning timing of the system can \
be
changed.
Pre-collision warning
When the system determines that the possibility of a frontal collision i\
s high,
a buzzer will sound and a warning message will be displayed on the Multi\
-
Information Display (MID) to urge the driver to take evasive action.
Pre-collision brake assist
When the system determines that the possibility of a frontal collision i\
s high, the
system applies greater braking force in relation to how strongly the bra\
ke pedal is
depressed.
Pre-collision braking
When the system determines that the possibility of a frontal collision i\
s high, the
system warns the driver. If the system determines that the possibility o\
f a collision
is extremely high, the brakes are automatically applied to help avoid th\
e collision
or reduce the collision speed.

30

Changing the pre-collision warning timing

Disabling the Pre-Collision System (PCS)
Each time the Pre-Collision System switch is pressed, the response to th\
e warning
distance changes as follows:
Far
Middle
Near
To disable the system
Press the PCS switch for 3 seconds or more.
The PCS warning light will turn on and a message will be displayed on th\
e Multi-
Information Display (MID).
To enable the system
Press the PCS switch again.
The system is enabled each time the engine switch is turned to IGNITION \
ON mode.
TOYOTA SAFETY SENSE

Activating the Automatic High Beam (AHB) system
(1) With the engine switch in IGNITION ON mode and headlight switch tu\
rned to “AUTO” position, push lever away from you.
(2) Depress the Automatic High Beam “AUTO” switch. The AHB indicator will come on when the headlights are turned on
automatically to indicate that the system is active.
Note: Pull the lever back toward you to turn the AHB system off.
The AHB indicator will turn off and the high beam indicator turns on.
37OVERVIEW FEATURES/OPERATIONS TOYOTA SAFETY SENSESAFETY AND EMERGENCY FEATURES
Conditions where Automatic High Beams will turn ON/OFF automatically
When all of these conditions are met, high beams will be automatically t\
urned on
(after approximately 1 second): =

9HKLFOHVSHHGLVDERYHDSSUR[LPDWHO\PSKNPK
=7KHDUHDDKHDGRIWKHYHKLFOHLVGDUN
=7KHUHDUHQRRQFRPLQJRUSUHFHGLQJYHKLFOHVZLWKKHDGOLJKWVR UWDLOOLJKWV
turned on.
If any of these conditions occur, high beams will be automatically turne\
d off: =9HKLFOHVSHHGGURSVEHORZDSSUR[LPDWHO\PSKNPK
=7KHDUHDDKHDGRIWKHYHKLFOHLVQRWGDUN
=2QFRPLQJRUSUHFHGLQJYHKLFOHVKDYHKHDGOLJKWVRUWDLOOLJKWV
turned on.
=7KHUHDUHPDQ\VWUHHWOLJKWVRQWKHURDGDKHDG

38
SAFETY AND EMERGENCY FEATURES
NOTE: If a passenger’s seat belt is fully extended, then retracted ev\
en slightly,
the Automatic locking retractor (ALR) will prevent it from being re-ex\
tended
beyond that point, unless fully retracted again. This feature is used to\
help hold
child restraint systems securely.
To find more information about seat belts, and how to install a child re\
straint
system, refer to the Owner’s Manual.
Keep as low on
hips as possible
Take up slack
Too high
Seat belts
Push up, or squeeze
lock release to lower
Seat belts-Shoulder belt anchor
The Tire Pressure Monitoring (warning) System (TPMS) provides advanc\
e warning in
the event of a loss in tire inflation pressure.
While the engine is in IGNITION ON mode, push and hold “
SET” button until the
indicator blinks three times. Wait a few minutes to allow initialization\
to
complete. The system displays the location and tire pressure for each ti\
re on the
MID.
NOTE: The warning light may come on due to temperature changes or changes
in tire pressure from natural air leakage. If the system has not been in\
itialized
recently, setting the tire pressures to factory specifications should tu\
rn off the
light.
Tire Pressure Monitoring (warning)
System