low beam TOYOTA LAND CRUISER 2016 J200 Quick Reference Guide

OVERVIEWFEATURES/OPERATIONS TOYOTA SAFETY SENSESAFETY AND EMERGENCY FEATURES
5
Anti-lock Brake System warning
2
Turn signal indicator
Slip indicator2
Low speed four-wheel drive indicator
Center differential lock indicator
Crawl Control indicator2
Low Tire Pressure Warning2
Automatic Transmission
second start indicator
Headlight low/
high beam indicator
Blind Spot Monitor indicator2
Rear Cross Traffic
Alert indicator
Blind Spot Monitor outside
rear view mirror indicator2
Shift position and range
indicators
Open door warning
Parking brake indicator
Pre-Collision System indicator1,2
Auto High Beam indicator
Land Departure Alert indicator1
Airbag SRS warning2
Master warning1,2
Power mode indicator
Roll Sensing of Curtain shield
Airbag OFF indicator2
Fog light indicator
1 If equipped.2
If indicator does not turn off within a few seconds of starting engine, \
there may be a
malfunction. Have vehicle inspected by your Toyota dealer.
Cruise control indicator/Cruise control SET indicator
Vehicle Stability Control OFF indicator2
Multi-terrain select indicator
ECO driving indicator2
Turn assist function indicator
Dynamic radar cruise control indicator1
Fuel tank position indicator
TRAC OFF indicator
Automatic headlight leveling
system warning

OVERVIEWFEATURES/OPERATIONS TOYOTA SAFETY SENSESAFETY AND EMERGENCY FEATURES
15
Lights & turn signals
Turn signals
Headlights
Front fog lights
-Daytime Running Light system (DRL) Automatically turns on the headlights at a
reduced intensity.
-Automatic light cut off system Automatically turns lights off after a delay of 30
seconds.
Right turn
Lane change
Lane change Left turn
Auto
OFF
Parking lights
Headlights
TurnOFF
ON
Front fog lights come on only when the headlights are on low beam.
Low beam
High beam flasher
High beam

28
Quick overview-Toyota Safety Sense P
Toyota Safety Sense (TSS) P is a set of active safety technologies des\
igned to
help prevent or mitigate collisions across a wide range of traffic situa\
tions. TSS P
is designed to help support the driver’s awareness, decision making a\
nd vehicle
operation contributing to a safe and comfortable driving experience.
TOYOTA SAFETY SENSE
Pre-Collision System (PCS)
Provides collision avoidance or damage mitigation
support in speed ranges where rear end collisions are
likely to occur.
Lane Departure Alert (LDA)
Provides notification regarding the risk of unintended
lane departure.
Auto High Beams (AHB)
Vehicle detects lights of leading or opposing vehicles
and automatically changes between high and low beam
headlight settings.
Pedestrian Detection Function
Advanced sensor system helps to recognize pedestrians
and provide collision avoidance support and/or damage
mitigation.
Dynamic Radar Cruise Control (DRCC)
Follows the car in front maintaining distance
between vehicles up to a set speed.
Refer to the Owner’s Manual for more details to understand these functions
and complete safety precautions before attempting to use any of TOYOTA
SAFETY SENSE P functions.
Sensors
Two types of sensors, located behind the front grille and windshield, de\
tect
information necessary to operate the drive assist systems. The single-le\
ns camera
in front of the inside rear view mirror recognizes certain shapes and vi\
sible white
or yellow lane markings.

Radar sensor
Camera sensor

36
The AHB uses an in-vehicle camera sensor to assess the brightness of str\
eetlights,
the lights of oncoming and preceding vehicles, etc., and automatically t\
urns high
beam on or off as necessary.
Auto High Beams (AHB)
(1)
(2)
Switching to constant speed control mode
(3) Acceleration when there are no longer any preceding vehicles driving
slower than the set speed The system accelerates until the set speed is reached. The system then
returns to constant speed cruising.
Note: When your vehicle is too close to a vehicle ahead, and
sufficient automatic deceleration via the cruise control is not
possible, the display will flash and the buzzer will sound to alert the \
driver. An example of this would be if another driver cuts in front of
you while you are following a vehicle. Depress the brake pedal to
ensure an appropriate vehicle-to-vehicle distance.
Note: When the engine is turned off, it will automatically default to DRCC.
TOYOTA SAFETY SENSE
If you are already using DRCC “”, push ON-OFF button to turn the system off
first, then push and hold ON-OFF button for at least 1.5 seconds to swit\
ch.