towing TOYOTA PRIUS 2001 Service Repair Manual

B04757
B04752
HV Fuse
IGCT Relay Engine Room J/B
Engine Room R/B No. 2
B04760
IN±18
± INTRODUCTIONFOR ALL OF VEHICLES
18 Author: Date:
2001 PRIUS (RM778U)

Remove the service plug with the insulated
gloves on.
If the service plug cannot be removed due to damage to the rear
portion of the vehicle, remove the HV fuse or IGCT relay
instead.
(c) Moving the damaged vehicle
HINT:
If any of the following applies, tow the vehicle away using a tow
truck lorry.

One or more of the high±voltage components and cables
is damaged.

The driving, traction, or fuel system is damaged.

The READY light is not lit when you turn ignition key to the
ON position.
NOTICE:

Before towing the vehicle away using a break down
lorry, disconnect the cable from the negative (±) ter-
minal of the auxiliary battery and remove the service
plug.
Only if none of the above applies and you see no prob-
lems that might affect the driving operation, you are
allowed to drive the vehicle away from the place of ac-
cident.

Preform the procedure below if the READY light goes
off or you detect an abnormal noise, abnormal smell,
or strong vibration while traveling:
(1) Park the vehicle in a safe place.
(2) Move the shift lever to the P position and engage
the parking brake.
(3) Disconnect the cable from the negative (±) terminal
of the auxiliary battery.
(4) Remove the service plug with insulated gloves on.

B04758
IN±20
± INTRODUCTIONFOR ALL OF VEHICLES
20 Author: Date:
2001 PRIUS (RM778U)
(6) If a damage to any of the high±voltage components
and cables is suspected, cut the high±voltage cir-
cuit using the procedure below:

Move the shift lever to the P position and en-
gage the parking brake.

Remove the ignition key. Then disconnect the
cable from the negative (±) terminal of the
auxiliary battery.

Wear insulated gloves, and then remove the
service plug.

If you cannot remove the service plug due to
damage to the rear portion of the vehicle, re-
move the HV fuse or IGCT relay instead.
(g) Precautions to be taken when disposing of the vehicle
When scrapping the vehicle, remove the HV battery from
the vehicle and return it through the route specified by the
manufacturer. The same applies to any damaged HV bat-
tery.
(h) Precautions to be observed when towing
Tow the damaged vehicle with its front wheels or its front
and rear wheels lifted off the ground.
NOTICE:
Towing the damaged vehicle with its front wheels on the
ground may cause the motor to generate electricity. This
electricity could, depending on the nature of the damage,
leak and cause a fire.
(i) Towing with 4 wheels on the ground
NOTICE:

If you have to tow the damaged vehicle using a rope,
do it at a speed below 30 km/h. Such towing operation
is allowed only to cover very short distance, such as
the distance to a tow truck lorry, for example.

Set the ignition switch to the ACC position and shift
lever to the N position.

If you detect any abnormality in the damaged vehicle
during the towing operation, stop the towing opera-
tion immediately.
(j) Towing eyelet
(1) Install the hook.
(2) Hook a rope onto the illustrated point for towing.