warning lights TOYOTA PRIUS C 2015 NHP10 / 1.G User Guide

872. Instrument cluster
2
Instrument cluster
PRIUS c_U (OM52E68U)
Warning lights inform the driver of malfunctions in any of the vehicle's
systems.
Warning lights
*
(U.S.A.)
Brake system warning
light (P. 441)*
(Canada)
ABS warning light
(P. 442)
*
(Canada)
Brake system warning
light ( P. 441)*Electric power steering
system warning light
(P. 442)
*
(Yellow)
Brake system warning
light ( P. 441)*
Slip indicator ( P. 442)
*Charging system warn-
ing light (P. 442)Low fuel level warning
light (P. 443)
*
(U.S.A.)
Malfunction indicator
lamp ( P. 442)Seat belt reminder light
(P. 443)
*
(Canada)
Malfunction indicator
lamp ( P. 442)*Master warning light
(P. 443)
*SRS warning light
(P. 442)*Tire pressure warning
light ( P. 444)
*
(U.S.A.)
ABS warning light
(P. 442)

1553-4. Adjusting the steering wheel and mirrors
3
Operation of each component
PRIUS c_U (OM52E68U)
The height of the rear view mirror can be adjusted to suit your driving
posture.
Adjust the height of the rear view
mirror by moving it up and down.
Reflected light from the headlights of vehicles behind can be reduced
by operating the lever.Normal position
Anti-glare position
Inside rear view mirror
The rear view mirror’s position can be adjusted to enable suffi-
cient confirmation of the rear view.
Adjusting the height of rear view mirror
Anti-glare function
1
2
WARNING
Do not adjust the position of the mirror while driving.
Doing so may lead to mishandling of the vehicle and cause an accident,
resulting in death or serious injury.

2094-3. Operating the lights and wipers
4
Driving
PRIUS c_U (OM52E68U)
Washer/wiper dual operation
The wipers will automatically oper-
ate a couple of times after the
washer squirts.
■The windshield wipers and washer can be operated when
Vehicles without a smart key system
The engine switch is in the “ON” position.
Vehicles with a smart key system
The “POWER” switch is in ON mode.
■ If no windshield washer fluid sprays
Check that the washer nozzles are not blocked if there is washer fluid in the
windshield washer fluid reservoir.
7
WARNING
■Caution regarding the use of washer fluid
When it is cold, do not use the washer fluid until the windshield becomes
warm. The fluid may freeze on the windshield and cause low visibility. This
may lead to an accident, resulting in death or serious injury.

3677-1. Maintenance and care
7
Maintenance and care
PRIUS c_U (OM52E68U)■
Aluminum wheels (if equipped)
●Remove any dirt immediately by us ing a neutral detergent. Do not use hard
brushes or abrasive cleaners. Do not use strong or harsh chemical clean-
ers.
Use the same mild detergent and wax as used on the paint.
● Do not use detergent on the wheels when they are hot, for example after
driving for long distance in the hot weather.
● Wash detergent from the wheels immediately after use.
■ Bumpers
Do not scrub with abrasive cleaners.
WARNING
■When washing the vehicle
Do not apply water to the inside of the engine compartment. Doing so may
cause the electrical components etc. to catch fire.
■ Precautions regarding the exhaust pipe
Exhaust gasses cause the exhaust pipe to become quite hot.
When washing the vehicle, be careful not to touch the pipe until it has
cooled sufficiently, as touching a hot exhaust pipe can cause burns.
NOTICE
■To prevent paint deterioration and corrosion on the body and compo-
nents (aluminum wheels etc.)
● Wash the vehicle immediately in the following cases:
• After driving near the sea coast
• After driving on salted roads
• If coal tar or tree sap is present on the paint surface
• If dead insects, insect droppings or bird droppings are present on the
paint surface
• After driving in an area contaminated with soot, oily smoke, mine dust, iron powder or chemical substances
• If the vehicle becomes heavily soiled with dust or mud
• If liquids such as benzene and gasoline are spilled on the paint surface
● If the paint is chipped or scratched, have it repaired immediately.
● To prevent the wheels from corroding, remove any dirt and store in a place
with low humidity when storing the wheels.
■ Cleaning the exterior lights
●Wash carefully. Do not use organic substances or scrub with a hard brush.
This may damage the surfaces of the lights.
● Do not apply wax to the surfaces of the lights.
Wax may cause damage to the lenses.

4197-3. Do-it-yourself maintenance
7
Maintenance and care
PRIUS c_U (OM52E68U)
■After a fuse is replaced
●If the lights do not turn on even after the fuse has been replaced, a bulb may
need replacement. ( P. 420)
● If the replaced fuse blows again, have the vehicle inspected by your Toyota
dealer.
■ If there is an overload in a circuit
The fuses are designed to blow, protecting the wiring harness from damage.
WARNING
■To prevent system breakdowns and vehicle fire
Observe the following precautions.
Failure to do so may cause damage to the vehicle, and possibly a fire or
injury.
●Never use a fuse of a higher amperage rating than that indicated, or use
any other object in place of a fuse.
● Always use a genuine Toyota fuse or equivalent.
Never replace a fuse with a wire, even as a temporary fix.
● Do not modify the fuses or fuse boxes.
■ Fuse box near the power control unit
Never check or replace the fuses as there are high voltage parts and wiring
near the fuse box.
Doing so may cause electric shock, resulting in death or serious injury.
NOTICE
■Before replacing fuses
Have the cause of electrical overload determined and repaired by your
Toyota dealer as soon as possible.

4287-3. Do-it-yourself maintenance
PRIUS c_U (OM52E68U)
WARNING
■Replacing light bulbs
●Turn off the lights. Do not attempt to replace the bulb immediately after
turning off the lights.
The bulbs become very hot and may cause burns.
● Do not touch the glass portion of the light bulb with bare hands. When it is
unavoidable to hold the glass portion, use and hold with a clean dry cloth
to avoid getting moisture and oils on the bulb.
Also, if the bulb is scratched or dropped, it may blow out or crack.
● Fully install light bulbs and any parts used to secure them. Failure to do so
may result in heat damage, fire, or water entering the headlight unit. This
may damage the headlights or cause condensation to build up on the lens.
■ To prevent damage or fire
Make sure bulbs are fully seated and locked.

4418-2. Steps to take in an emergency
8
When trouble arises
PRIUS c_U (OM52E68U)
If a war ning light tur ns on or a war ning
buzzer sounds
Calmly perform the following actions if any of the warning lights
comes on or flashes. If a light comes on or flashes, but then
goes off, this does not necessarily indicate a malfunction in the
system. However, if this continues to occur, have the vehicle
inspected by your Toyota dealer.
Warning light and warning buzzer list
Warning lightWarning light/Details/Actions
(U.S.A.)
(Canada)
Brake system warning light in red (warning buzzer)*1
• Low brake fluid
• Malfunction in the brake system This light also comes on when the parking brake is not
released. If the light turns off after the parking brake is
fully released the system is operating normally.
 Immediately stop the vehicle in a safe place and con-
tact your Toyota dealer. Continuing to drive the vehi-
cle may be dangerous.
Brake system warning light in yellow
Indicates a malfunction in:
• The regenerative brake system; or
• The electronically controlled brake system
 Have the vehicle inspected by your Toyota dealer
immediately.

4508-2. Steps to take in an emergency
PRIUS c_U (OM52E68U)
Warning message and warning buzzer list
Warning messageDetails/Actions
Indicates a malfunction in the hybrid systemA buzzer sounds in accordance with the warn-
ing message that is displayed.
 Immediately stop the vehicle in a safe place
and contact your Toyota dealer.
Indicates that the high engine coolant tempera-
ture is too high
Immediately stop the vehicle in a safe
place. ( P. 483)
Indicates abnormal engine oil pressure
The warning message is shown if the engine oil
pressure is too low.
A buzzer also sounds.
 Immediately stop the vehicle in a safe place
and contact your Toyota dealer.
(If equipped)
• Indicates a malfunction in the smart key system
• Indicates a malfunction in the steering lock sys-
tem
A buzzer also sounds.
 Have the vehicle inspected by your Toyota
dealer.
Indicates a malfunction in the LED headlight sys-
tem If there is a malfunction, the LED headlights do
not turn on. However, depending on the mal-
function, they may turn on.
A buzzer also sounds.
 Have the vehicle inspected by your Toyota
dealer.
(Flashes)
(Flashes)

4548-2. Steps to take in an emergency
PRIUS c_U (OM52E68U)Indicates that the engine switch is turned to the
“ACC” or “LOCK” position (vehicles without a
smart key system) or the “POWER” switch is
turned to ACCESSORY mode or turned off (vehi-
cles with a smart key system) and the driver’s
door is opened while the lights are turned on
A buzzer also sounds.
 Turn the lights off.
Indicates that the EV drive mode is not avail-
able
*2
The reason the EV drive mode is not available
(the vehicle is idling, battery charge is low,
speed is higher than the EV drive mode operat-
ing speed range, accelerator pedal is
depressed too much) may be displayed.
A buzzer also sounds.
 Use the EV drive mode when it becomes
available.
Indicates that the EV drive mode has been auto-
matically canceled
*2
The reason the EV drive mode is not available
(the battery charge is low, speed is higher than
the EV drive mode speed range, accelerator
pedal is depressed too much) may be dis-
played.
A buzzer also sounds.
 Drive the vehicle for a while.
Indicates that the TRAC (Traction Control) sys-
tem has been deactivated
 Turn the TRAC on. ( P. 233)
Indicates that the accelerator and brake pedals
are being depressed simultaneously, and the
Brake Override System is operating. ( P. 167)
 Release the accelerator or brake pedal.
Warning messageDetails/Actions
(Flashes)
(Flashes 3
times)
(Flashes)

550Alphabetical index
PRIUS c_U (OM52E68U)
Tail lightsReplacing light bulbs............. 427
Switch ................................... 201
Theft deterrent system Immobilizer system ................. 82
Theft prevention labels ........... 84
Theft prevention labels ............. 84
Tire inflation pressure............. 406
Tire information Glossary................................ 509
Size ....................................... 505
Tire identification number ..... 504
Uniform tire quality grading ............................... 507
Tires Chains................................... 242
Checking ............................... 398
If you have a flat tire ............. 462
Inflation pressure .................. 497
Inflation pressure sensor ...... 399
Information ............................ 502
Replacing .............................. 462
Rotating tires......................... 398
Size ....................................... 497
Snow tires ............................. 243
Spare tire .............................. 462
Tire pressure warning system ........................ 398, 444
Tools ......................................... 462
Total load capacity .................. 179
Towing Dinghy towing ....................... 181
Emergency towing ................ 433
Trailer towing ........................ 180 TRAC ........................................ 232
Traction control ....................... 232
Transmission
Hybrid transmission .............. 196
If the shift lever cannot be shifted from P ................ 475
Trip information ......................... 94
Trip meter ................................... 91
Turn signal lights Replacing light bulbs ............ 420
Switch ................................... 199
Wattage ................................ 498
USB memory.................... 250, 277
Vanity mirrors .......................... 357
Vehicle data recordings .............. 9
Vehicle identification number................................... 491
Vehicle Proximity Notification System ................................... 72
Vehicle stability control .......... 232
VSC ........................................... 232
VSC OFF switch....................... 233
T
U
V