change time TOYOTA PRIUS V 2012 Accessories, Audio & Navigation (in English)

TOYOTA — RS3200 PLUS Security System Page 12
PROGRAMMING
The RS3200 PLUS is factory-set to not PASSIVELY ARM. To change the system’s
operation for PASSIVE ARMING operation, as well as adjust the ENTRY DELAY time,
follow the procedure below. For more information on this feature, please refer to page
7. (Not applicable to Highlander and Sienna. Please consult your Toyota Dealer for
programming information.)
PASSIVE ARMING ON/OFF SELECTION, ENTRY DELAY TIME SELECTION
1.

Before you begin:
Open the driver

’s door. Close the remaining
doors and the trunk or hatch. Unlock all doors
with the inside lock switch. Remove the key
from the
ignition
switch.
d. Lock , then unlock
the driver’s door
inside lock button
3 times.
f. The system locks the door
in 2 seconds; if this does not
happen, start over
.
Start the Programming Procedure. (Complete these steps within 40 seconds.)
b. Lock then unlock the
driver’s door inside lock
button 1 time.c. The system locks the door
in 2 seconds; if this does
not happen, start over.
Programming is now
complete.
3. Select the Operating Mode and Complete the Programming Procedure.
a. Close, then Open the driver ’s
door:
2 times = PASSIVE ARMING OFF
3 times = PASSIVE ARMING ON,
0 Sec. ENTR

Y DELAY
4 times = PASSIVE ARMING ON,
15 Sec. ENTR

Y DELAY
5 times = PASSIVE ARMING ON,
30 Sec. ENTR

Y DELAY
a. Close the
driver’s door. b.
Lock and unlock all doors
3 times by key or remote
control.c. Open and close
the driver ’s
door.
e.

Open the
driver

’s door.
g. Unlock the driver ’s
door knob.
2. Insert and remove the key from the igni-
tion key cylinder 3 times; this must be
completed within 5 seconds.